Abstract
Zinc oxide is a necessary component in most accelerator-sulfur vulcanization systems. While it is not an accelerator, its presence leads to increased modulus, i.e., tighter cures. The manner in which it can effect this better cure is not completely clear. Some insight into the role of zinc oxide has been gained through the analysis of the vulcanizate for reaction products of zinc, such as zinc stearate, the zinc salts of the accelerators, and zinc sulfide. However, these products may not account for all of the zinc oxide which has reacted. An analytical method for the direct determination of unreacted zinc oxide in vulcanizates was therefore needed. The determination of zinc oxide in rubber vulcanizates has received scant attention. Wet-chemical techniques for analysis of the sample after ashing provide only the total amount of zinc from which the amount of unreacted zinc oxide cannot be determined. Endter has reported the use of the Debye-Scherrer x-ray technique for the identification of zinc oxide in rubber samples. While similar to the method developed in this laboratory, Endter employed photographic film for recording the diffraction pattern, and special sample preparation was required to accommodate the photographic technique. This method was satisfactory for qualitative identification of zinc oxide, but was difficult to use for quantitative analysis. Subsequent to this investigation Hagino et al. described the use of x-ray diffractometry for the determination of the mixing ratio of ingredients compounded in rubber. This method was also suggested for the quantitative analysis of zinc oxide, but no studies were reported. During a study in this laboratory to determine the role of zinc oxide in the vulcanization of rubber, a new analytical method, based on x-ray diffractometry, was developed. The method was rapid, nondestructive, and simple. The data were reliable and accurate.
Direct determination of atom and radical concentrations in thermal reactions of hydrocarbons and other gases. Progress report, June 1, 1976--December 31, 1976. [Design and construction of shock tube for measuring reaction products]