scholarly journals PRELIMINARY TITLE I DESIGN REPORT, SNAP-50/SPUR NUCLEAR TEST FACILITY: COMMENTS AND RECOMMENDATIONS. Letter Report.

1964 ◽  
Author(s):  
W Doll
Keyword(s):  
Title I ◽  
Nuclear Test ◽  
Test Facility

scholarly journals Satellite radar observation of large surface collapses induced by the 2017 North Korea nuclear test

2020 ◽  
Vol 10 (1) ◽  
Author(s):  
Won-Kyung Baek ◽  
Hyung-Sup Jung ◽  
Tae Sung Kim
Keyword(s):  
North Korea ◽  
Surface Deformation ◽  
Complex Surface ◽  
Nuclear Test ◽  
Test Facility ◽  
Deformation Pattern ◽  
Vertical Deformation ◽  
Horizontal Deformation ◽  
Maximum Deformation ◽  
The North

Abstract The artificial earthquake of mb 6.1 related to the North Korea’s sixth nuclear test occured at Mt. Mantap, North Korea on September 3, 2017. It was reported that a large and complex surface deformation was caused by the event. The surface deformation was composed of expansion of explosions, collapse, compaction and landslides. Since the precise vertical deformation measurement is very important to estimate the stability of the nuclear test facility, we retrieved a precise 3D surface deformation field and then decomposed the vertical deformation pattern from the 3D deformation. The measured maximum deformation was about − 491, − 343 and 166 cm with the measurement uncertainty of about 3.3, 4.1 and 2.7 cm in the east, north and up directions, respectively. The maximum horizontal deformation was approximately 515 cm. The horizontal deformation clearly showed a radial pattern because it was mainly caused by the explosions and landslides, while the vertical deformation displayed a rugged pattern because it was affected by the explosions, compaction and collapse. The collapse may seem to occur along the underground tunnels and at the test site’s epicenter as well. Moreover, the severe collapse was observed westside from the epicenter of the sixth nuclear test, and it has a depth of about 68.6 cm on the area of 0.3765 km2. On the basis of our results including the shapes, locations and volume changes of the large collapse, evidently a new vital piece of information was obtained so that it could be used to interprete the sixth nuclear test more accurately.

scholarly journals New challenge to nuclear test facility

Nature ◽  
1997 ◽  
Vol 386 (6624) ◽  
pp. 427-427
Author(s):  
Colin Macilwain
Keyword(s):  
Nuclear Test ◽  
Test Facility

Radiation Damage Studies with the HVEM

1972 ◽  
Vol 30 ◽  
pp. 680-681
Author(s):  
J. J. Laidler ◽  
B. Mastel
Keyword(s):  
Radiation Damage ◽  
Stainless Steels ◽  
Volume Expansion ◽  
Austenitic Stainless Steels ◽  
Test Facility ◽  
Fast Breeder Reactors ◽  
Breeder Reactors ◽  
Under Construction ◽  
Development Laboratory ◽  
Insight Into

One of the major materials problems encountered in the development of fast breeder reactors for commercial power generation is the phenomenon of swelling in core structural components and fuel cladding. This volume expansion, which is due to the retention of lattice vacancies by agglomeration into large polyhedral clusters (voids), may amount to ten percent or greater at goal fluences in some austenitic stainless steels. From a design standpoint, this is an undesirable situation, and it is necessary to obtain experimental confirmation that such excessive volume expansion will not occur in materials selected for core applications in the Fast Flux Test Facility, the prototypic LMFBR now under construction at the Hanford Engineering Development Laboratory (HEDL). The HEDL JEM-1000 1 MeV electron microscope is being used to provide an insight into trends of radiation damage accumulation in stainless steels, since it is possible to produce atom displacements at an accelerated rate with 1 MeV electrons, while the specimen is under continuous observation.

Sign in / Sign up

Export Citation Format

Share Document