scholarly journals Protocols for Uranium Carbon Analysis - Testing Protocol Summary

2021 ◽  
Author(s):  
Philip Tubesing
Keyword(s):  
Testing Protocol ◽  
Carbon Analysis

Pengaruh Pendopingan Karbon Terhadap Struktur Kristal dan Morfologi TIO2

2019 ◽  
Vol 2 (2) ◽  
Author(s):  
Frastica Deswardani ◽  
Helga Dwi Fahyuan ◽  
Rimawanto Gultom ◽  
Eif Sparzinanda
Keyword(s):  
Thin Film ◽  
Crystal Structure ◽  
Grain Size ◽  
Tio2 Thin Film ◽  
Crystal Size ◽  
Diffraction Peak ◽  
Carbon Doping ◽  
Tio2 Anatase ◽  
Spray Method ◽  
Carbon Analysis

Telah dilakukan penelitian mengenai pengaruh konsentrasi doping karbon pada lapisan tipis TiO2 yang ditumbuhkan dengan metode spray terhadap struktur kristal dan morfologi TiO2. Hasil karakterisasi SEM menunjukkan bahwa penambahan doping karbon dapat meningkatkan ukuran butir. Lapisan TiO2 doping karbon 8% diperoleh ukuran butir terbesar adalah 1.35 μm, sedangkan ukuran tekecilnya adalah 0.45 μm. Sementara itu, untuk lapisan tipis TiO2 didoping karbon 15% memiliki ukuran butir terbesar yaitu 1.76 μm dan terkecil 0.9 μm. Hasil XRD menunjukkan seluruh puncak difraksi lapisan tipis TiO2 dengan doping karbon 8% dan 15% merupakan TiO2 anatase. Ukuran kristal lapisan TiO2 didoping karbon 8% diperoleh sebesar 638,08 Å dan untuk pendopingan 15% karbon ukuran kristal lapisan tipis TiO2 adalah 638,09 Å, hal ini menunjukkan ukuran kristal kedua sampel tidak mengalami perubahan yang signifikan.   TiO2 thin film with carbon doping has been successfully grown by spray method. The research on the effect of carbon doping on crystal structure and morfology of TiO2 has been prepared by varying carbon concentration (8% and 15% carbon). Analysis of SEM showed that the addition of carbon may increase the grain size. Thin film of TiO2 doped carbon 8% has the largest grain size 1.35 μm, while the smallest grain size is 0.45 μm. Meanwhile, for thin film TiO2 doped carbon 15% has the largest grain size 1.76 μm and smallest 0.9 μm. The XRD results showed the entire diffraction peak of thin film TiO2 doped carbon 8% and 15% were TiO2 anatase. The crystal size of thin film TiO2 doped carbon 8% was obtained at 638.08 Å and for thin film TiO2 doped carbon 15% the crystalline size of TiO2 thin film was 638.09 Å, this shows that the crystal size of both samples did not change significantly.    

Reliability of the electronic early treatment diabetic retinopathy study testing protocol in children 7 to <13 years old

2003 ◽  
Vol 136 (4) ◽  
pp. 655-661 ◽  
Author(s):  
Susan A Cotter ◽  
Raymond H Chu ◽  
Danielle L Chandler ◽  
Roy W Beck ◽  
Jonathan M Holmes ◽  
...  
Keyword(s):  
Diabetic Retinopathy ◽  
Early Treatment ◽  
Testing Protocol

Specifications and testing of self-consolidating mortar designated for annular space grouting

2011 ◽  
Vol 38 (4) ◽  
pp. 422-432 ◽  
Author(s):  
Soo-Duck Hwang ◽  
Kamal H. Khayat ◽  
Richard Morin
Keyword(s):  
High Stability ◽  
Fine Sand ◽  
Underground Water ◽  
Experimental Program ◽  
Testing Protocol ◽  
Slump Flow ◽  
Nominal Size ◽  
Repair Mortars ◽  
Passing Ability ◽  
Good Filling

An experimental program was undertaken to evaluate the performance of self-consolidating mortar designed for filling small annular spaces for the rehabilitation of underground water line or sewage pipelines. The study also intended to establish a testing protocol to validate the workability of repair grout. All the investigated mixtures had good filling and passing ability with adequate retention of workability over 3 h. The repair mortars exhibited high stability with bleeding lower than 0.3% compared to 3% bleeding in the case of the reference neat cement grout. The reference grout had a lower plastic viscosity and higher slump flow values than the sanded repair grouts. A V-funnel with 30 mm × 30 mm overture and a flow cone with 12.7 mm overture are recommended for mortar made with concrete sand with a 5 mm nominal size and micro mortar with fine sand with a nominal size up to 3 mm, respectively.

Early Detection of Ototoxicity Using 1/6th-Octave Steps

2003 ◽  
Vol 14 (08) ◽  
pp. 444-450 ◽  
Author(s):  
Stephen A. Fausti ◽  
Wendy J. Helt ◽  
David S. Phillips ◽  
Jane S. Gordon ◽  
Gene W. Bratt ◽  
...  
Keyword(s):  
Early Detection ◽  
Early Identification ◽  
High Frequency ◽  
Detection Rate ◽  
Frequency Range ◽  
Test Protocol ◽  
Hearing Results ◽  
Testing Protocol ◽  
Initial Work ◽  
Auditory Research

The National Center for Rehabilitative Auditory Research has developed a protocol to provide early identification of ototoxicity for patients receiving ototoxic medications. The initial work involved patients with relatively good high-frequency hearing and resulted in the use of an individualized, sensitive frequency range separated by 1/16th-octave intervals. This protocol tested puretone frequencies at 1/6th-octave steps above 9 kHz, but only conventional audiometric frequencies were tested below 9 kHz. More recently, the testing protocol was expanded to include 1/6th-octave testing below 9 kHz. The primary question of interest was to determine whether adding 1/16th-octave test frequencies below 9 kHz would increase the ototoxicity detection rate for patients with poorer hearing. Results indicated 76 of the 210 (36.2%) ears that demonstrated initial ototoxic hearing change would have been missed or detected later if only conventional frequency testing was conducted. Therefore, for individuals with poorer hearing, expanding the use of the 1/16th-octave test protocol provides earlier identification of ototoxicity.

Reliability of a basketball specific testing protocol for footwear fit and comfort perception

2011 ◽  
Vol 3 (3) ◽  
pp. 151-158 ◽  
Author(s):  
Wing Kai Lam ◽  
Thorsten Sterzing ◽  
Jason Tak-Man Cheung
Keyword(s):  
Testing Protocol ◽  
Comfort Perception ◽  
Footwear Fit

The Two-Point Discrimination Test – Time For a Re-Appraisal?

2004 ◽  
Vol 29 (5) ◽  
pp. 418-422 ◽  
Author(s):  
G. LUNDBORG ◽  
B. ROSÉN
Keyword(s):  
Nerve Repair ◽  
Test Time ◽  
Discrimination Test ◽  
Testing Technique ◽  
Testing Protocol

The two-point discrimination (2PD) test is the most frequently used test for the assessment of the sensory outcome after nerve repair. Here we focus on factors which explain the enormous and implausible variability in reported 2PD levels after nerve repair. We conclude that the 2PD testing technique is not at all standardized and that its use as the sole test for tactile gnosis recovery should be seriously questioned. Reports of 2PD results should always be accompanied by a detailed description of how the test was performed, especially with reference to the pressure applied and the testing protocol.

Sign in / Sign up

Export Citation Format

Share Document