Modification of tubular ceramic membranes with carbon nanotubes using catalytic chemical vapor deposition

2015 ◽  
Vol 72 (8) ◽  
pp. 1404-1410 ◽  
Author(s):  
Duc Trung Tran ◽  
Guillemette Thieffry ◽  
Matthieu Jacob ◽  
Catherine Batiot-Dupeyrat ◽  
Benoit Teychene

In this study, carbon nanotubes (CNTs) were successfully grown on tubular ceramic membranes using the catalytic chemical vapor deposition (CCVD) method. CNTs were synthesized at 650°C for 3–6 h under a 120 mL min−1 flow of C2H6 on ceramic membranes impregnated with iron salt. The synthesis procedure was beforehand optimized in terms of catalyst amount, impregnation duration and reaction temperature, using small pieces of tubular ceramic membranes. The yield, size and structure of the CNTs produced were characterized using thermogravimetric analysis and microscopic imaging techniques. Afterwards, preliminary filtration tests with alginate and phenol were performed on two modified tubular membranes. The results indicate that the addition of CNTs on the membrane material increased the permeability of ceramic membrane and its ability to reject alginate and adsorb phenol, yet decreased its fouling resistance.

2011 ◽  
Vol 364 ◽  
pp. 232-237 ◽  
Author(s):  
S.Y. Lim ◽  
M.M. Norani

Catalyst plays a crucial role in determining the characteristics of carbon nanotubes (CNTs) produced by using thermal catalytic chemical vapor deposition (CVD). It is essential to investigate how the catalyst preparation affects the characteristics of CNTs because certain application demands specific size for optimum performance. This study reports the effect of the types of catalyst and the duration of the catalyst pre-treatment (wet etching time, dry etching time and ball milling) on the diameter of CNTs. The synthesized CNTs samples were characterized by scanning and transmission electron microscopy and Raman spectroscopy. Wet etching (2M hydrofluoric acid) time was varied from 1 to 2.5 hrs and the diameter range was found to be in the range of 23 to 52 nm. The diameter range for CNTs produced for 3 hrs and 5 hrs of dry etching treatment (with ammonia gas) are 38 to 51 nm and 23 to 48 nm, respectively. The diameter size of CNTs produced using Ni (14 to 25 nm) was found to be smaller than Fe (38 to 51 nm). There is a significant decrease in the diameter of CNTs by prolonging the wet etching period. Shorter and curly shaped CNTs can also be obtained by using Ni as the catalyst. Keywords: chemical vapor deposition, carbon nanotubes, catalyst pretreatment


2017 ◽  
Vol 5 (16) ◽  
pp. 4068-4074 ◽  
Author(s):  
Xinliang Li ◽  
Xiaowei Yin ◽  
Meikang Han ◽  
Changqing Song ◽  
Hailong Xu ◽  
...  

Ti3C2TxMXenes modified within situgrown carbon nanotubes (CNTs) are fabricatedviaa simple catalytic chemical vapor deposition (CVD) process.


Sign in / Sign up

Export Citation Format

Share Document