Evaluation of deammonification process performance at different aeration strategies

2011 ◽  
Vol 63 (6) ◽  
pp. 1168-1176 ◽  
Author(s):  
M. Zubrowska-Sudol ◽  
J. Yang ◽  
J. Trela ◽  
E. Plaza

In a deammonification process applied in the moving bed biofilm reactor (MBBR) oxygen is a crucial parameter for the process performance and efficiency. The objective of this study was to investigate different aeration strategies, characterised by the ratio between non-aerated and aerated phase times (R) and dissolved oxygen concentrations (DO). The series of batch tests were conducted with variable DO concentrations (2, 3, 4 mg L−1) and R values (0-continuous aeration; 1/3, 1, 3-intermittent aeration) but with the same initial ammonium concentration, volume of the moving bed and temperature. It was found that the impact of DO on deammonification was dependent on the R value. At R=0 and R=1/3, an increase of DO caused a significant increase in nitrogen removal rate, whereas for R=1 and R=3 similar rates of the process were observed irrespectively of the DO. The highest nitrogen removal rate of 3.33 g N m−2 d−1 (efficiency equal to 69.5%) was obtained at R=1/3 and DO=4 mg L−1. Significantly lower nitrogen removal rates (1.17–1.58 g N m−2 d−1) were observed at R=1 and R=3 for each examined DO. It was a consequence reduced aerated phase duration times and lesser amounts of residual nitrite in non-aerated phases as compared to R=1/3.

2012 ◽  
Vol 23 (5) ◽  
pp. 739-749 ◽  
Author(s):  
Ivar Zekker ◽  
Kristel Kroon ◽  
Ergo Rikmann ◽  
Toomas Tenno ◽  
Martin Tomingas ◽  
...  

2017 ◽  
Vol 76 (12) ◽  
pp. 3468-3477 ◽  
Author(s):  
Weixing Mi ◽  
Jianqiang Zhao ◽  
Xiaoqian Ding ◽  
Guanghuan Ge ◽  
Rixiang Zhao

Abstract To investigate the characteristics of anaerobic ammonia oxidation for treating low-ammonium wastewater, a continuous-flow completely autotrophic nitrogen removal over nitrite (CANON) biofilm reactor was studied. At a temperature of 32 ± 1 °C and a pH between 7.5 and 8.2, two operational experiments were performed: the first one fixed the hydraulic retention time (HRT) at 10 h and gradually reduced the influent ammonium concentrations from 210 to 50 mg L−1; the second one fixed the influent ammonium concentration at 30 mg L−1 and gradually decreased the HRT from 10 to 3 h. The results revealed that the total nitrogen removal efficiency exceeded 80%, with a corresponding total nitrogen removal rate of 0.26 ± 0.01 kg N m−3 d−1 at the final low ammonium concentration of 30 mg L−1. Small amounts of nitrous oxide (N2O) up to 0.015 ± 0.004 kg m−3 d−1 at the ammonium concentration of 210 mg L−1 were produced in the CANON process and decreased with the decrease in the influent ammonium loads. High-throughput pyrosequencing analysis indicated that the dominant functional bacteria ‘Candidatus Kuenenia’ under high influent ammonium levels were gradually succeeded by Armatimonadetes_gp5 under low influent ammonium levels.


2007 ◽  
Vol 55 (8-9) ◽  
pp. 19-26 ◽  
Author(s):  
B. Szatkowska ◽  
G. Cema ◽  
E. Plaza ◽  
J. Trela ◽  
B. Hultman

The ability of bacterial cultures to create biofilm brings a possibility to enhance biological wastewater treatment efficiency. Moreover, the ability of Anammox and Nitrosomonas species to grow within the same biofilm layer enabled a one-stage system for nitrogen removal to be designed. Such a system, with Kaldnes rings as carriers for biofilm growth, was tested in a technical pilot plant scale (2.1 m3) at the Himmerfjärden Waste Water Treatment Plant (WWTP) in the Stockholm region. The system was directly supplied with supernatant originating from dewatering of digested sludge containing high ammonium concentrations. Nearly 1-year of operational data showed that during the partial nitritation/Anammox process, alkalinity was utilised parallel to ammonium removal. The process resulted in a small pH drop, and its relationship with conductivity was found. The nitrogen removal rate for the whole period oscillated around 1.5 g N m−2d−1 with a maximum value equal to 1.9 g N m−2d−1. Parallel to the pilot plant experiment, a series of batch tests were run to investigate the influence on removal rates of different dissolved oxygen conditions and addition of nitrite. The highest nitrogen removal rate (5.2 g N m−2d−1) in batch tests was obtained when the Anammox process was stimulated by the addition of nitrite. In the simultaneous partial nitritation and Anammox process, the partial nitritation was the rate-limiting step.


2012 ◽  
Vol 33 (20) ◽  
pp. 2263-2271 ◽  
Author(s):  
Ivar Zekker ◽  
Ergo Rikmann ◽  
Toomas Tenno ◽  
Priit Vabamäe ◽  
Kristel Kroon ◽  
...  

2017 ◽  
Vol 245 ◽  
pp. 1282-1285 ◽  
Author(s):  
Xinbo Zhang ◽  
Zi Song ◽  
Wenshan Guo ◽  
Yanmin Lu ◽  
Li Qi ◽  
...  

2015 ◽  
Vol 50 (3) ◽  
pp. 219-227 ◽  
Author(s):  
Maohong Zhou ◽  
Hairen Ye ◽  
Xiaowei Zhao

The effects of culture conditions on a newly isolated Pseudomonas stutzeri KTB's ability to simultaneously perform heterotrophic nitrification and aerobic denitrification were investigated to determine its potential of application in nitrogen removal from wastewater. The results from experiments in the presence of 10 mmol/L of ammonium were as follows: succinate was the preferred carbon source, and the optimum C/N ratio, temperature, and initial pH were 10, 30 °C, and 7–8, respectively. Nitrogen removal took place not only in the logarithmic phase but also in the stationary phase. Under the optimum conditions, the nitrogen removal rate increased as the ammonium concentration elevated, until it was as high as 60 mmol/L. Meanwhile, the maximum specific growth rate decreased. The highest nitrogen removal rate of 0.977 mmol/L/h was observed at 60 mmol/L of ammonium and the maximum removal ratio of 85.6% at 40 mmol/L when the bacterial treatment for 48 h was completed. The strain was vulnerable to even higher ammonium loads. When incubated in anaerobically digested hennery wastewater containing 43.85 mmol/L of ammonium and 2.32 mmol/L of nitrate, the removal ratio and rate reached 82.4% and 0.397 mmol/L/h, respectively. The strain might be a great candidate for ammonium removal from wastewater.


2009 ◽  
Vol 2009 (15) ◽  
pp. 2266-2279
Author(s):  
Arbina Shrestha ◽  
Rumana Riffat ◽  
Charles Bott ◽  
Imre Takacs ◽  
Beverley Stinson ◽  
...  

2016 ◽  
Vol 74 (12) ◽  
pp. 2909-2916 ◽  
Author(s):  
Lukasz Kopec ◽  
Jakub Drewnowski ◽  
Adam Kopec

The paper presents research of a prototype moving bed biofilm reactor (MBBR). The device was used for the post-denitrification process and was installed at the end of a technological system consisting of a septic tank and two trickling filters. The concentrations of suspended biomass and biomass attached on the EvU Perl moving bed surface were determined. The impact of the external organic carbon concentration on the denitrification rate and efficiency of total nitrogen removal was also examined. The study showed that the greater part of the biomass was in the suspended form and only 6% of the total biomass was attached to the surface of the moving bed. Abrasion forces between carriers of the moving bed caused the fast stripping of attached microorganisms and formation of flocs. Thanks to immobilization of a small amount of biomass, the MBBR was less prone to leaching of the biomass and the occurrence of scum and swelling sludge. It was revealed that the maximum rate of denitrification was an average of 0.73 gN-NO3/gDM·d (DM: dry matter), and was achieved when the reactor was maintained in external organic carbon concentration exceeding 300 mgO2/dm3 chemical oxygen demand. The reactor proved to be an effective device enabling the increase of total nitrogen removal from 53.5% to 86.0%.


2013 ◽  
Vol 67 (12) ◽  
pp. 2677-2684 ◽  
Author(s):  
M. Christensson ◽  
S. Ekström ◽  
A. Andersson Chan ◽  
E. Le Vaillant ◽  
R. Lemaire

ANITA™ Mox is a new one-stage deammonification Moving-Bed Biofilm Reactor (MBBR) developed for partial nitrification to nitrite and autotrophic N-removal from N-rich effluents. This deammonification process offers many advantages such as dramatically reduced oxygen requirements, no chemical oxygen demand requirement, lower sludge production, no pre-treatment or requirement of chemicals and thereby being an energy and cost efficient nitrogen removal process. An innovative seeding strategy, the ‘BioFarm concept’, has been developed in order to decrease the start-up time of new ANITA Mox installations. New ANITA Mox installations are started with typically 3–15% of the added carriers being from the ‘BioFarm’, with already established anammox biofilm, the rest being new carriers. The first ANITA Mox plant, started up in 2010 at Sjölunda wastewater treatment plant (WWTP) in Malmö, Sweden, proved this seeding concept, reaching an ammonium removal rate of 1.2 kgN/m3 d and approximately 90% ammonia removal within 4 months from start-up. This first ANITA Mox plant is also the BioFarm used for forthcoming installations. Typical features of this first installation were low energy consumption, 1.5 kW/NH4-N-removed, low N2O emissions, <1% of the reduced nitrogen and a very stable and robust process towards variations in loads and process conditions. The second ANITA Mox plant, started up at Sundets WWTP in Växjö, Sweden, reached full capacity with more than 90% ammonia removal within 2 months from start-up. By applying a nitrogen loading strategy to the reactor that matches the capacity of the seeding carriers, more than 80% nitrogen removal could be obtained throughout the start-up period.


2013 ◽  
Vol 69 (6) ◽  
pp. 1227-1233 ◽  
Author(s):  
Vojtech Kouba ◽  
Michael Catrysse ◽  
Hana Stryjova ◽  
Ivana Jonatova ◽  
Eveline I. P. Volcke ◽  
...  

The application of nitrification–denitrification over nitrite (nitritation–denitritation) with municipal (i.e. diluted and cold (or low-temperature)) wastewater can substantially improve the energy balance of municipal wastewater treatment plants. For the accumulation of nitrite, it is crucial to inhibit nitrite-oxidizing bacteria (NOB) with simultaneous proliferation of ammonium-oxidizing bacteria (AOB). The present study describes the effect of the influent total ammonium nitrogen (TAN) concentration on AOB and NOB activity in two moving bed biofilm reactors operated as sequencing batch reactors (SBR) at 15 °C (SBR I) and 21 °C (SBR II). The reactors were fed with diluted reject water containing 600, 300, 150 and 75 mg TAN L−1. The only factor limiting NOB activity in these reactors was the high concentrations of free ammonia and/or free nitrous acid (FNA) during the SBR cycles. Nitrite accumulation was observed with influents containing 600, 300 and 150 mg TAN L−1 in SBR I and 600 and 300 in SBR II. Once nitrate production established in the reactors, the increase of influent TAN concentration up to the original 600 mg TAN L−1 did not limit NOB activity. This was due to the massive development of NOB clusters throughout the biofilm that were able to cope with faster formation of FNA. The results of the fluorescence in situ hybridization analysis preliminarily showed the stratification of bacteria in the biofilm.


Sign in / Sign up

Export Citation Format

Share Document