Application of mulch for treating metals in urban runoff: batch and column test

2007 ◽  
Vol 55 (1-2) ◽  
pp. 95-103 ◽  
Author(s):  
A. Jang ◽  
S.-W. Lee ◽  
Y. Seo ◽  
K.-W. Kim ◽  
I.S. Kim ◽  
...  
Keyword(s):  
Heavy Metals ◽  
Urban Runoff ◽  
Treatment Method ◽  
Breakthrough Curves ◽  
Column Tests ◽  
Filter System ◽  
Batch Tests ◽  
Major Interest ◽  
Removal Of Heavy Metals ◽  
The Many

Among the many methods available for the removal of heavy metals in urban nonpoint source pollution (NSP), adsorption has been shown to be an economically feasible alternative. To adsorb the amount of heavy metals in runoff, filtration of runoff through a specially constructed filter system is one possible treatment method. The mulch layer in a specially constructed filter system functions through adsorptive-filtration, where some pollutants are immobilised through sorption and some pollutants associated with suspended solids are immobilised through filtration. Therefore, the major interest of this study was to investigate the possibility of utilising mulch for the adsorption of heavy metals such as cadmium, copper, lead and zinc for a solution typical of those found in urban runoff using the flask-type adsorption batch tests and laboratory column tests. From the equilibrium sorption batch tests, it was observed that the adsorption of heavy metals on mulch with the same initial concentrations of metals in the solution decreased in the order Pb(II)> Cu(II)> Zn(II)> Cd(II) regardless of changes in pH. In column tests, the breakthrough curves for various heavy metals' adsorption by mulch showed that the binding strength of the following metal ions onto mulch was as follows: Pb(II)> Cu(II)> Zn(II)> Cd(II).

The removal of heavy metals in urban runoff by sorption on mulch

2005 ◽  
Vol 133 (1) ◽  
pp. 117-127 ◽  
Author(s):  
Am Jang ◽  
Youngwoo Seo ◽  
Paul L. Bishop
Keyword(s):  
Heavy Metals ◽  
Urban Runoff ◽  
Removal Of Heavy Metals

scholarly journals Preparation and Characterization of Activated Carbon from Bagasse and Jute Fibre for Heavy Metal Adsorption

2019 ◽  
pp. 17-34
Author(s):  
Md. Shazzad Hossain ◽  
Farzana Khan Rony ◽  
Sazia Sultana ◽  
Md.Humayun Kabir ◽  
Sumaya F. Kabir ◽  
...  
Keyword(s):  
Heavy Metals ◽  
Heavy Metal ◽  
Activated Carbon ◽  
Raw Materials ◽  
Low Cost ◽  
Treatment Method ◽  
Jute Fibre ◽  
Removal Of Heavy Metals ◽  
Atomic Adsorption Spectroscopy

Over the past few years, activated carbon (AC) has attained significant attention as an efficient adsorbent for heavy metal (lead, cadmium, chromium etc.) removal. In Bangladesh, bagasse and jute fibre are the two most potential raw materials for producing activated carbon due to their high availability and low cost. The activated carbon was produced by thermal treatment method. The produced AC were characterized using FTIR, XRD, SEM etc. Batch experiments under agitation was also carried out for adsorption of heavy metals and then characterized using AAS (Atomic Adsorption Spectroscopy). Adsorption with commercially available activated carbon was also done to use as standard. Among all ACs produced in this study, the highest percentage removal of heavy metals which were Cr3+ and Cd2+ was at 57.06% and 43.01% respectively for J-400 ( AC produced from jute fibre at 4000C). This obtained value was 16.6% and 12.9% higher in comparison to Commercially available Activated carbon for Cr3+ and Cd2+ respectively.

Biosorption: An Eco-Friendly Technique for the Removal of Heavy Metals

2011 ◽  
Vol 2 (3) ◽  
pp. 1-8 ◽  
Author(s):  
Sasmita Sabat ◽  
◽  
R V Kavitha R V Kavitha ◽  
Shantha S L Shantha S L ◽  
Gopika Nair ◽  
...  
Keyword(s):  
Heavy Metals ◽  
Removal Of Heavy Metals

Study of the Cu(II) removal from aqueous solutions by adsorption on titania

2013 ◽  
Vol 12 (3) ◽  
pp. 239-247
Keyword(s):  
Heavy Metals ◽  
Ionic Strength ◽  
Toxic Metals ◽  
Low Cost ◽  
Lateral Interaction ◽  
Tio2 Surface ◽  
High Toxicity ◽  
Removal Of Heavy Metals ◽  
Solution Parameters ◽  
Kinetics Of

The removal of heavy metals from wastewaters is a matter of paramount importance due to the fact that their high toxicity causes major environmental pollution problems. One of the most efficient, applicable and low cost methods for the removal of toxic metals from aqueous solutions is that of their adsorption on an inorganic adsorbent. In order to achieve high efficiency, it is important to understand the influence of the solution parameters on the extent of the adsorption, as well as the kinetics of the adsorption. In the present work, the adsorption of Cu(II) species onto TiO2 surface was studied. It was found that the adsorption is a rapid process and it is not affected by the value of ionic strength. In addition, it was found that by increasing the pH, the adsorbed amount of Cu2+ ions and the value of the adsorption constant increase, whereas the value of the lateral interaction energy decreases.

Synergistic Effect of Rhamnolipid and Saponin Biosurfactants on Removal of Heavy Metals from Oil Contaminated Soils

2020 ◽  
Vol 57 (2) ◽  
pp. 109-114
Author(s):  
Amirhossein Dolatzadeh khiyavi ◽  
Reza Hajimohammadi ◽  
Hossein Amani ◽  
Hadi Soltani
Keyword(s):  
Heavy Metals ◽  
Synergistic Effect ◽  
Contaminated Soils ◽  
Removal Of Heavy Metals

Applications of Bentonite to Soil Decontamination

2018 ◽  
Vol 69 (7) ◽  
pp. 1695-1698
Author(s):  
Marin Rusanescu ◽  
Carmen Otilia Rusanescu ◽  
Gheorghe Voicu ◽  
Mihaela Begea
Keyword(s):  
Heavy Metals ◽  
Heavy Metal ◽  
Laboratory Experiments ◽  
Experimental Studies ◽  
Heavy Metal Concentration ◽  
Polluted Soil ◽  
Raw Material ◽  
Soil Decontamination ◽  
Metal Retention ◽  
Removal Of Heavy Metals

A calcium bentonite from Orasu Nou deposit (Satu Mare Romania) was used as raw material. We have conducted laboratory experiments to determine the influence of bentonite on the degree of heavy metal retention. It has been observed that the rate of retention increases as the heavy metal concentration decreases. Experimental studies have been carried out on metal retention ( Zn) in bentonite. In this paper, we realized laboratory experiments for determining the influence of metal (Zn) on the growth and development of two types of plants (Pelargonium domesticum and Kalanchoe) and the effect of bentonite on the absorption of pollutants. These flowers were planted in unpolluted soil, in heavy metal polluted soil and in heavy metal polluted soil to which bentonite was added to observe the positive effect of bentonite. It has been noticed that the flowers planted in unpolluted soil and polluted with heavy metals to which bentonite has been added, the flowers have flourished, the leaves are still green and the plants whose soils have been polluted with heavy metals began to dry after 6 days, three weeks have yellowish leaves and flowers have dried. Experiments have demonstrated the essential role of bentonite for the removal of heavy metals polluted soil.

Sign in / Sign up

Export Citation Format

Share Document