scholarly journals Theoretical evaluation of concentration time and storage coefficient with their application to major dam basins in Korea

2018 ◽  
Vol 19 (2) ◽  
pp. 644-652
Author(s):  
Chulsang Yoo ◽  
Jiho Lee ◽  
Eunsaem Cho
Keyword(s):  
Channel Length ◽  
Main Channel ◽  
Flow Conditions ◽  
Empirical Formulas ◽  
Theoretical Evaluation ◽  
Storage Coefficient ◽  
Concentration Time ◽  
Channel Slope ◽  
And Storage ◽  
Laminar Flow Conditions

Abstract This study theoretically evaluated the basin concentration time and storage coefficient with their empirical formulas available worldwide. The evaluation results were also validated in the application to major dam basins in Korea. The findings are summarized as follows. As a result of analytical analysis, the concentration time was found to be proportional to the main channel length under laminar flow conditions and to the square of it under turbulent flow conditions, but inversely proportional to the channel slope. It was also found that the storage coefficient and the concentration time are linearly but loosely related. Most empirical formulas for the concentration time concurred with the basic equation form, but just a few for the storage coefficient. Applications to major dam basins in Korea also showed that the concentration time agrees well with the result of theoretical analysis. However, the behavior of the storage coefficient varied much, basin by basin, indicating that additional factors may be needed to explain it.

Velocity measurements close to the bed in a wave tank

1970 ◽  
Vol 42 (1) ◽  
pp. 111-123 ◽  
Author(s):  
J. F. A. Sleath
Keyword(s):  
Velocity Distribution ◽  
Vortex Formation ◽  
Reynolds Numbers ◽  
Flow Conditions ◽  
Velocity Measurements ◽  
Dominant Effect ◽  
Wave Tank ◽  
High Reynolds Numbers ◽  
High Reynolds ◽  
Laminar Flow Conditions

Measurements of the velocity distribution close to the bed have been made under laminar flow conditions in a wave tank. The classical solution for the velocity distribution was found to be valid when the bed was smooth, but considerable deviations between theory and experiment were observed with beds of sand. It is suggested that these deviations were caused by vortex formation around the grains of sand. The similarity between the velocity profiles obtained in these tests and those reported by other writers under supposedly turbulent conditions suggests that even at high Reynolds numbers vortex formation may continue to be the dominant effect in oscillatory boundary layers of this sort.

A Mechanistic Study of Griseofulvin Dissolution into Surfactant Solutions under Laminar Flow Conditions

1997 ◽  
Vol 86 (10) ◽  
pp. 1132-1137 ◽  
Author(s):  
Venkatramana M. Rao ◽  
Mengfen Lin ◽  
Cynthia K. Larive ◽  
Marylee Z. Southard
Keyword(s):  
Laminar Flow ◽  
Mechanistic Study ◽  
Flow Conditions ◽  
Surfactant Solutions ◽  
Laminar Flow Conditions

Investigation of Airflow and Temperature Distribution in the Freezer Cabinet of a Domestic No-Frost Refrigerator

2009 ◽  
Author(s):  
Melike Nikbay ◽  
M. Berkay Acikgoz ◽  
Husnu Kerpicci
Keyword(s):  
Energy Consumption ◽  
Temperature Distribution ◽  
Uniform Temperature ◽  
Flow Conditions ◽  
Piv Measurements ◽  
Factors Affecting ◽  
Flow And Heat Transfer ◽  
Cfd Analyses ◽  
Off Time ◽  
Laminar Flow Conditions

Uniformity of temperature distribution in a loaded freezer cabinet is one of the most important factors affecting energy consumption of a refrigerator. Present study focuses on the airflow behavior and the temperature distribution inside the freezer compartment of a domestic no-frost refrigerator. Energy consumption increases in a freezer cabinet if the temperature difference between the warmest load package and average of all packages is high. The objective is to reduce the energy consumption by providing a uniform temperature distribution and also to keep the food fresh for a longer time. In this study, the air flow and heat transfer during on-time and off-time periods inside the freezer compartment is modeled by considering turbulent and laminar flow conditions in 3D transient CFD analyses. The initial and boundary conditions are provided from temperature controlled room and PIV measurements. The CFD analyses obtained are verified by experimental measurements.

Sign in / Sign up

Export Citation Format

Share Document