scholarly journals Determination of the Effect of Grain Size Distribution on the Internal Friction Angle in Dry Sands by Direct Shear Test

2020 ◽  
pp. 1702-1713
Author(s):  
Eyyüb KARAKAN ◽  
Zelal EBREN
Keyword(s):  
Grain Size ◽  
Internal Friction ◽  
Size Distribution ◽  
Grain Size Distribution ◽  
Direct Shear Test ◽  
Shear Test ◽  
Friction Angle ◽  
Internal Friction Angle ◽  
Direct Shear

scholarly journals Influence of Structural Plane Microscopic Parameters on Direct Shear Strength

2018 ◽  
Vol 2018 ◽  
pp. 1-7 ◽  
Author(s):  
Yanhui Cheng ◽  
Weijun Yang ◽  
Dongliang He
Keyword(s):  
Particle Size ◽  
Shear Strength ◽  
Internal Friction ◽  
Direct Shear Test ◽  
Shear Test ◽  
Friction Angle ◽  
Internal Friction Angle ◽  
Direct Shear ◽  
Stiffness Ratio ◽  
Structural Plane

Structural plane is a key factor in controlling the stability of rock mass engineering. To study the influence of structural plane microscopic parameters on direct shear strength, this paper established the direct shear mechanical model of the structural plane by using the discrete element code PFC2D. From the mesoscopic perspective, the research on the direct shear test for structural plane has been conducted. The bonding strength and friction coefficient of the structural plane are investigated, and the effect of mesoscopic parameters on the shear mechanical behavior of the structural plane has been analyzed. The results show that the internal friction angle φ of the structural plane decreases with the increase of particle contact stiffness ratio. However, the change range of cohesion is small. The internal friction angle decreases first and then increases with the increase of parallel bond stiffness ratio. The influence of particle contact modulus EC on cohesion c is relatively small. The internal friction angle obtained by the direct shear test is larger than that obtained by the triaxial compression test. Parallel bond elastic modulus has a stronger impact on friction angle φ than that on cohesion c. Under the same normal stress conditions, the shear strength of the specimens increases with particle size. The shear strength of the specimen gradually decreases with the increase of the particle size ratio.

scholarly journals Study on Water Characteristic Curve and Shear Characteristics of Typical Unsaturated Silty Clay in Shaoxing

Geofluids ◽  
2021 ◽  
Vol 2021 ◽  
pp. 1-15
Author(s):  
Ruiqian Wu ◽  
Youzhi Tang ◽  
Shaohe Li ◽  
Wei Wang ◽  
Ping Jiang ◽  
...  
Keyword(s):  
Shear Strength ◽  
Internal Friction ◽  
Unsaturated Soil ◽  
Direct Shear Test ◽  
Shear Test ◽  
Characteristic Curve ◽  
Friction Angle ◽  
Matric Suction ◽  
Silty Clay ◽  
Direct Shear

In order to probe into one simplified method to predict the shear strength of Shaoxing unsaturated silty clay, the test method combining unsaturated soil consolidation instrument and conventional direct shear instrument is used to study the shear strength, and the method is compared and verified with the results of equal suction direct shear test. The research results show that the soil water characteristic curve fitted by the measured data points and VG model has obvious stage characteristics in the range of 0~38 kPa, 38~910 kPa, and 910~10000 kPa. The shear strength of unsaturated soil measured by consolidation meter combined with conventional direct shear test is in good agreement with that measured by equal suction direct shear test in the range of 0~500 kPa. The results show that the shear strength, total cohesion, and effective internal friction angle of soil increase slightly with the increase of matric suction in the range of 0~38 kPa. When the matric suction increases from 38 kPa to 500 kPa, the shear strength and total cohesion force of the soil have similar stage characteristics with the SWCC, which first increases and then tends to be stable, while the effective internal friction angle changes slightly. Finally, taking the air-entry value as the demarcation point, an improved model of unsaturated shear strength is proposed by analyzing the error value. Compared with the measured value, the absolute value of relative error is basically kept in the range of 5%~10%, which is close to the measured value.

scholarly journals Determination of the Effect of Soil Particle Size Distribution on the Shear Behavior of Sand

2021 ◽  
Vol 5 (2) ◽  
pp. 125
Author(s):  
Mohammad Afrazi ◽  
Mahmoud Yazdani
Keyword(s):  
Particle Size ◽  
Shear Strength ◽  
Direct Shear Test ◽  
Shear Test ◽  
Friction Angle ◽  
Particle Sizes ◽  
Direct Shear ◽  
Shear Tests ◽  
Direct Shear Tests

Many geotechnical problems require the determination of soil engineering properties such as shear strength. Therefore, the determination of the reliable values for this parameter is essential. For this purpose, the direct shear test, as one of the oldest tests to examine the shear strength of soils, is the most common way in laboratories to determine the shear parameters of soil. There are far too many variables that influence the results of a direct shear test. In this paper, a series of 10 × 10 cm direct shear tests were carried out on four different poorly graded sands with different particle size distributions to determine their shear behaviors. Four different poorly graded sands with a different median diameter or medium value of particle size distribution (D50) (0.2, 0.53, 1.3, and 2.3 mm) has been selected, and about 40 direct shear tests were conducted. It was concluded that a soil’s friction angle is affected by coarse-grained material. Accordingly, sandy soils with bigger particle sizes record a higher friction angle than soils containing small particles. The investigations also showed that sand with bigger particle sizes has a higher dilation angle. In addition, a non-linear regression analysis was performed to establish the exact relationship between the friction angle of the soil and the characteristics of the soil particles. This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution, and reproduction in any medium provided the original work is properly cited.

scholarly journals Determination of Soil Strength Using 2D Geoelectric Methods and Direct Shear Test (Case Study in Istana Tidar Regency Housing – Jember)

2017 ◽  
Vol 5 (2) ◽  
Author(s):  
Nurul Priyantari ◽  
Supriyadi . ◽  
Devi Putri Sulistiani ◽  
Winda Aprita Mayasari
Keyword(s):  
Direct Shear Test ◽  
Shear Test ◽  
Resistivity Measurement ◽  
Soil Strength ◽  
Test Case ◽  
Cohesive Soils ◽  
Direct Shear ◽  
Geoelectrical Resistivity

2D geoelectrical resitivity measurement and direct shear test has been conducted to determine soil type and soil strength on land settlement Istana Tidar Regency housing, Jember. Resistivity measurement is conducted at two line that have latitude 08.10’102” – 08.10’108” S, 113.43’404” – 113.43’408” E (line 1) dan 08.10’102” – 08.10’108” S, 113.43’410” – 113.43’414” E (line 2). Soil specimen were taken at 3 point, 2 point at line 1 and 1 point at line 2. Based on result of 2D geoelectrical resistivity measurement and direct shear test, this location was dominated by clay, silt and sandy silt are included in the type of cohesive soils. Soil strength of this type is capable to support light bulding contruction one or two floors.

scholarly journals Shear strength characteristics of Jerash expansive soil

2021 ◽  
Vol 3 (2) ◽  
pp. 74-80
Author(s):  
Talal Masoud
Keyword(s):  
Shear Strength ◽  
Internal Friction ◽  
Water Content ◽  
Direct Shear Test ◽  
Shear Test ◽  
Expansive Soil ◽  
Content Increase ◽  
Direct Shear ◽  
Initial Water ◽  
Angle Of Internal Friction

The results of the direct shear test on Jerash expansive soil show the effect of the initial water content on the cohesion (c) and on the angel of internal friction ( ) [shear strength parameters].it show that, as the initial water increase, the cohesion (c) of Jerash expansive soil also increase up to the shrinkage limit, after that increase of water even small amount, decrease the cohesion of the soil. On the other hand, the results of direct shear test show also  that as the water content increase, the angle of internal friction ( )remain unchanged up to shrinkage limit , any increase of water cause a large decrease on the angle of internal friction of Jerash expansive soil.

Study on the Granular Shear Strength Parameters of Dumping Site

2012 ◽  
Vol 256-259 ◽  
pp. 358-361
Author(s):  
Xiang Yun Kong ◽  
Guang Jin Wang ◽  
Xiao Chao Zhou
Keyword(s):  
Particle Size ◽  
Grain Size ◽  
Shear Strength ◽  
Internal Friction ◽  
Friction Angle ◽  
Internal Friction Angle ◽  
Shear Strength Parameters ◽  
Strength Parameters ◽  
Dumping Site ◽  
Size Grading

Apparent particle size grading is the important characteristic of super-high bench dumping site, and the critical factors with the impact of its stability and disaster prevention are the fragmentation distribution and shear strength parameters of granular. With the copper mine dumping site which had the feature of apparent particle size grading, the thesis carried out the study of on-site particle size investigation and indoor laboratory. The particle-size distribution law with the changing of dumping-site height was analyzed and quantitative relationship between the fragmentation distribution and shear strength parameters of granular was discussed. The research results indicated that coarse-grain contents and maximum grain size were increased significantly according to the decreasing of dumping-site height, which showed that the dumping-site had the feature of apparent particle size grading. The coarse particle content in the grain size composition and internal friction angle φ of shear strength parameters increased with the obvious increment of the distribution value B. The relationship between distribution value B and the internal friction angle φ could be expressed by exponential function curve.

scholarly journals The influence of organic polymer on properties of mineral concentrates

2013 ◽  
Vol 20 (2) ◽  
pp. 90-93
Author(s):  
Marzenna Popek
Keyword(s):  
High Risk ◽  
Internal Friction ◽  
Moisture Content ◽  
Friction Angle ◽  
Internal Friction Angle ◽  
Organic Polymer ◽  
Biodegradable Materials

AbstractTransport of mineral concentrates is associated with high risk of liquefaction of the cargoes. This type of goods containing water may liquefy and shift dangerously across the cargo compartments. Therefore, it is rational to limit the moisture content of the cargoes which may liquefy. To prevent sliding and shifting of ore concentrates in storage biodegradable materials composed of starch are added to the mineral concentrates. The influence of adding starch materials to the mineral concentrates on its parameters determining ability for safe shipment was assessed on the basis of determination of the following parameters: permeability, cohesion and internal friction angle of concentrates.

Sign in / Sign up

Export Citation Format

Share Document