scholarly journals A Combined Pwm and Aem Based Ac Voltage Controller for Resistive Loads

2022 ◽  
Author(s):  
GENO PETER ◽  
samat bin Iderus ◽  
Praghash k
Keyword(s):  
Voltage Controller ◽  
Resistive Loads

IMPORTANCE OF MOTIVATION IN TOLERABILITY OF INCREASED BREATHING RESISTANCE

2019 ◽  
pp. 72-79
Author(s):  
Yu.Yu. Byalovskiy ◽  
I.S. Rakitina
Keyword(s):  
Functional State ◽  
Maximum Level ◽  
Technological Environment ◽  
Breathing Control ◽  
Aerodynamic Loads ◽  
Breathing Resistance ◽  
Resistive Breathing ◽  
Resistive Loads ◽  
Intraoral Pressure

Cortical mechanisms play an important role in breathing control under increased breathing resistance (resistive loads). Cortical mechanisms determine the level of voluntary motivation, which significantly affects the tolerance of resistive breathing loads. The purpose of the paper is to determine the effect of voluntary motivation on the tolerance of additional breathing resistance. Materials and Methods. The authors formed procedural motivation by means of moral encouragement or financial rewards of the subjects. Simulation of increased breathing resistance was performed using in-creasing values of thresholdless inspiratory aerodynamic loads: 40, 60, 70, and 80 % from the maximum intraoral pressure. Results. The maximum level of tolerance of additional breathing resistance was observed in volunteers with a material and subsidiary procedural motivation of activity. Under respiratory loads, these subjects demonstrated the greatest deviations of the functional state indicators. Undefined motivation based on the mobilization of goal-oriented resources with moral stimulation showed less efficiency. Lack of specially formed procedural motivation led to minimal tolerance of resistive loads. Conclusion. Procedural motivation, aimed at overcoming additional breathing resistance, significantly increases the tolerance of individual protective means of respiratory organs, which maintains health of workers in a polluted technological environment. Keywords: motivation, tolerance, increased breathing resistance. Большую роль в регуляции дыхания при увеличенном сопротивлении дыханию (резистивных нагрузках) играют кортикальные механизмы. Корковые механизмы определяют уровень произвольной мотивации, которая существенно влияет на переносимость резистивных дыхательных нагрузок. Цель исследования – определение влияния произвольной мотивации на переносимость дополнительного респираторного сопротивления. Материалы и методы. Процессуальную мотивацию формировали методом морального или материального поощрения испытуемых. Моделирование увеличенного сопротивления дыханию проводили с помощью предъявления возрастающих значений беспороговых инспираторных аэродинамических нагрузок: 40, 60, 70 и 80 % от максимального внутриротового давления. Результаты. Максимальный уровень переносимости дополнительного респираторного сопротивления наблюдался у добровольцев, у которых была сформирована материально-субсидивная процессуальная мотивация деятельности; у этой категории испытуемых во время действия дыхательных нагрузок отмечались наибольшие отклонения показателей функционального состояния. Произвольная мотивация на основе мобилизации волевых ресурсов при моральном стимулировании характеризовалась меньшей эффективностью, а отсутствие специально сформированной процессуальной мотивации сопровождалось минимальной переносимостью резистивных нагрузок. Выводы. Процессуальная мотивация, сформированная для преодоления дополнительного респираторного сопротивления, существенно повышает переносимость средств индивидуальной защиты органов дыхания, что имеет большое значение для сохранения здоровья работающих в условиях загрязненной производственной среды. Ключевые слова: мотивация, переносимость, увеличенное сопротивление дыханию.

scholarly journals Tilt Active Vibration Isolation Using Vertical Pendulum and Piezoelectric Transducer with Parallel Controller

2021 ◽  
Vol 11 (10) ◽  
pp. 4526
Author(s):  
Lihua Wu ◽  
Yu Huang ◽  
Dequan Li
Keyword(s):  
Piezoelectric Transducer ◽  
Vibration Isolation ◽  
Vertical Vibration ◽  
Open Loop ◽  
Negative Effects ◽  
Voltage Controller ◽  
Hysteresis Nonlinearity ◽  
Passive Vibration Isolation ◽  
Active Vibration ◽  
Active Vibration Isolation

Tilt vibrations inevitably have negative effects on some precise engineering even after applying horizontal and vertical vibration isolations. It is difficult to adopt a traditional passive vibration isolation (PVI) scheme to realize tilt vibration isolation. In this paper, we present and develop a tilt active vibration isolation (AVI) device using a vertical pendulum (VP) tiltmeter and a piezoelectric transducer (PZT). The potential resolution of the VP is dependent on the mechanical thermal noise in the frequency bandwidth of about 0.0265 nrad, which need not be considered because it is far below the ground tilt of the laboratory. The tilt sensitivity of the device in an open-loop mode, investigated experimentally using a voltage controller, is found to be (1.63±0.11)×105 V/rad. To compensate for the hysteresis nonlinearity of the PZT, we experimentally established the multi-loop mathematical model of hysteresis, and designed a parallel controller consisting of both a hysteresis inverse model predictor and a digital proportional–integral–differential (PID) adjuster. Finally, the response of the device working in close-loop mode to the tilt vibration was tested experimentally, and the tilt AVI device showed a good vibration isolation performance, which can remarkably reduce the tilt vibration, for example, from 6.0131 μrad to below 0.0103 μrad.

An Efficient Pseudo-Derivative-Feedback-Based Voltage Controller for DVR Under Distorted Grid Conditions

2021 ◽  
Vol 2 (1) ◽  
pp. 71-81
Author(s):  
Deshpande Gururaj Abhilash Krishna ◽  
Karthikeyan Anbalagan ◽  
K. K. Prabhakaran ◽  
Sushant Kumar
Keyword(s):  
Voltage Controller ◽  
Distorted Grid

Detection Latency of Added Loads to Breathing

1982 ◽  
Vol 63 (1) ◽  
pp. 11-15 ◽  
Author(s):  
J. G. W. Burdon ◽  
K. J. Killian ◽  
E. J. M. Campbell
Keyword(s):  
Peak Inspiratory Pressure ◽  
Normal Subjects ◽  
Reciprocal Relationship ◽  
Respiratory Cycle ◽  
Curvilinear Relationship ◽  
Similar Relationship ◽  
Detection Latency ◽  
Mechanical Information ◽  
Resistive Loads ◽  
Comparable Magnitude

1. Detection latency of a range of added elastic (0·95–4·50 kPa/l) and resistive (0·73–3·29 kPa l−1 s) loads to breathing were measured in five normal subjects. Detection latency was defined as the time from the onset of the breath to detection of the load. 2. Detection latency followed a curvilinear relationship when plotted as a function of the magnitude of the added loads. A similar relationship was found with both elastic and resistive loads although detection latencies to added elastances were longer than for added resistances. 3. When the added load was expressed in terms of comparable magnitude (peak inspiratory pressure) detection latencies for added elastances were found to be consistently longer than for added resistive loads. 4. These studies show that the detection latency to added inspiratory loads follows a reciprocal relationship, that detection latencies for elastic and resistive loads are clearly different and suggest that these loads are detected during the respiratory cycle at a time when the mechanical information regarding muscular pressure is greatest.

Effects of expiratory loading on respiration in humans

1980 ◽  
Vol 49 (4) ◽  
pp. 601-608 ◽  
Author(s):  
B. Gothe ◽  
N. S. Cherniack
Keyword(s):  
Muscle Activity ◽  
Healthy Subjects ◽  
Respiratory Muscle ◽  
Resistive Load ◽  
Similar Magnitude ◽  
Occlusion Pressure ◽  
Ventilatory Responses ◽  
Residual Capacity ◽  
Resistive Loads ◽  
The Difference

We examined the effects of expiratory resistive loads of 10 and 18 cmH2O.l-1.s in healthy subjects on ventilation and occlusion pressure responses to CO2, respiratory muscle electromyogram, pattern of breathing, and thoracoabdominal movements. In addition, we compared ventilation and occlusion pressure responses to CO2 breathing elicited by breathing through an inspiratory resistive load of 10 cmH2O.l-1.s to those produced by an expiratory load of similar magnitude. Both inspiratory and expiratory loads decreased ventilatory responses to CO2 and increased the tidal volume achieved at any given level of ventilation. Depression of ventilatory responses to Co2 was greater with the larger than with the smaller expiratory load, but the decrease was in proportion to the difference in the severity of the loads. Occlusion pressure responses were increased significantly by the inspiratory resistive load but not by the smaller expiratory load. However, occlusion pressure responses to CO2 were significantly larger with the greater expiratory load than control. Increase in occlusion pressure observed could not be explained by changes in functional residual capacity or chemical drive. The larger expiratory load also produced significant increases in electrical activity measured during both inspiration and expiration. These results suggest that sufficiently severe impediments to breathing, even when they are exclusively expiratory, can enhance inspiratory muscle activity in conscious humans.

Sign in / Sign up

Export Citation Format

Share Document