Do Stock Return Factors Outperform Other Risk Factors? Evidence from a Large Cross-Section of Anomalies

2014 ◽  
Author(s):  
Paulo F. Maio
Keyword(s):  
Risk Factors ◽  
Cross Section ◽  
Stock Return ◽  
Large Cross Section ◽  
Return Factors

Air exchange dynamics in the system of large cross-section blind roadways

2020 ◽  
Vol 2 ◽  
pp. 46-57
Author(s):  
S.V. Maltsev ◽  
◽  
B.P. Kazakov ◽  
A.G. Isaevich ◽  
M.A. Semin ◽  
...  
Keyword(s):  
Cross Section ◽  
Large Cross Section ◽  
Air Exchange

scholarly journals Are We Able to Print Components as Strong as Injection Molded?—Comparing the Properties of 3D Printed and Injection Molded Components Made from ABS Thermoplastic

2021 ◽  
Vol 11 (15) ◽  
pp. 6946
Author(s):  
Bartłomiej Podsiadły ◽  
Andrzej Skalski ◽  
Wiktor Rozpiórski ◽  
Marcin Słoma
Keyword(s):  
Tensile Strength ◽  
Injection Molding ◽  
Mechanical Strength ◽  
Cross Section ◽  
Fused Deposition Modeling ◽  
High Strength ◽  
Large Cross Section ◽  
Fused Deposition ◽  
Injection Molded ◽  
The Cross

In this paper, we are focusing on comparing results obtained for polymer elements manufactured with injection molding and additive manufacturing techniques. The analysis was performed for fused deposition modeling (FDM) and single screw injection molding with regards to the standards used in thermoplastics processing technology. We argue that the cross-section structure of the sample obtained via FDM is the key factor in the fabrication of high-strength components and that the dimensions of the samples have a strong influence on the mechanical properties. Large cross-section samples, 4 × 10 mm2, with three perimeter layers and 50% infill, have lower mechanical strength than injection molded reference samples—less than 60% of the strength. However, if we reduce the cross-section dimensions down to 2 × 4 mm2, the samples will be more durable, reaching up to 110% of the tensile strength observed for the injection molded samples. In the case of large cross-section samples, strength increases with the number of contour layers, leading to an increase of up to 97% of the tensile strength value for 11 perimeter layer samples. The mechanical strength of the printed components can also be improved by using lower values of the thickness of the deposited layers.

Sign in / Sign up

Export Citation Format

Share Document