First in situ X-ray identification of coesite and retrograde quartz on a glass thin section of an ultrahigh-pressure metamorphic rock and their crystal structure details

2007 ◽  
Vol 92 (1) ◽  
pp. 57-63 ◽  
Author(s):  
D. Ikuta ◽  
N. Kawame ◽  
S. Banno ◽  
T. Hirajima ◽  
K. Ito ◽  
...  
Keyword(s):  
Crystal Structure ◽  
Thin Section ◽  
Metamorphic Rock ◽  
Ultrahigh Pressure ◽  
X Ray ◽  
Ultrahigh Pressure Metamorphic Rock

Single Crystal Growth of High-Pressure Phases of Ice and Salt Hydrate Far Below the Original Melting Point by Mixing Alcohol: Crystal Structure Determination of Magnesium Chloride Heptahydrate

2020 ◽  
Author(s):  
Keishiro Yamashita ◽  
Kazuki Komatsu ◽  
Hiroyuki Kagi
Keyword(s):  
Crystal Structure ◽  
High Pressure ◽  
Crystal Growth ◽  
Single Crystal ◽  
Room Temperature ◽  
Growth Technique ◽  
Salt Hydrate ◽  
X Ray

An crystal-growth technique for single crystal x-ray structure analysis of high-pressure forms of hydrogen-bonded crystals is proposed. We used alcohol mixture (methanol: ethanol = 4:1 in volumetric ratio), which is a widely used pressure transmitting medium, inhibiting the nucleation and growth of unwanted crystals. In this paper, two kinds of single crystals which have not been obtained using a conventional experimental technique were obtained using this technique: ice VI at 1.99 GPa and MgCl<sub>2</sub>·7H<sub>2</sub>O at 2.50 GPa at room temperature. Here we first report the crystal structure of MgCl2·7H2O. This technique simultaneously meets the requirement of hydrostaticity for high-pressure experiments and has feasibility for further in-situ measurements.

PHASE TRANSITION IN LAYERED PEROVSKITE LIKE MANGANATE Ca3Mn2O7 UNDER HIGH PRESSURE

2001 ◽  
Vol 15 (18) ◽  
pp. 2491-2497 ◽  
Author(s):  
J. L. ZHU ◽  
L. C. CHEN ◽  
R. C. YU ◽  
F. Y. LI ◽  
J. LIU ◽  
...  
Keyword(s):  
Crystal Structure ◽  
High Pressure ◽  
Diamond Anvil Cell ◽  
The Other ◽  
Layered Perovskite ◽  
X Ray Diffraction ◽  
Two Phase ◽  
X Ray ◽  
Diamond Anvil

In situ high pressure energy dispersive X-ray diffraction measurements on layered perovskite-like manganate Ca 3 Mn 2 O 7 under pressures up to 35 GPa have been performed by using diamond anvil cell with synchrotron radiation. The results show that the structure of layered perovskite-like manganate Ca 3 Mn 2 O 7 is unstable under pressure due to the easy compression of NaCl-type blocks. The structure of Ca 3 Mn 2 O 7 underwent two phase transitions under pressures in the range of 0~35 GPa. One was at about 1.3 GPa with the crystal structure changing from tetragonal to orthorhombic. The other was at about 9.5 GPa with the crystal structure changing from orthorhombic back to another tetragonal.

scholarly journals X-Ray Single Crystal Structural Analysis of Magnetically Oriented Microcrystals

2014 ◽  
Vol 70 (a1) ◽  
pp. C1138-C1138
Author(s):  
Chiaki Tsuboi ◽  
Kazuki Aburaya ◽  
Shingo Higuchi ◽  
Fumiko Kimura ◽  
Masataka Maeyama ◽  
...  
Keyword(s):  
Molecular Structure ◽  
Crystal Structure ◽  
Single Crystal ◽  
Three Dimensional ◽  
Diffraction Measurement ◽  
X Ray Diffraction ◽  
Data Set ◽  
Uv Curable ◽  
X Ray

We have developed magnetically oriented microcrystal array (MOMA) technique that enables single crystal X-ray diffraction analyses from microcrystalline powder. In this method, microcrystals suspended in a UV-curable monomer matrix are there-dimensionally aligned by special rotating magnetic field, followed by consolidation of the matrix by photopolymerization. From thus achieved MOMAs, we have been succeeded in crystal structure analysis for some substances [1, 2]. Though MOMA method is an effective technique, it has some problems as follows: in a MOMA, the alignment is deteriorated during the consolidation process. In addition, the sample microcrystals cannot be recovered from a MOMA. To overcome these problems, we performed an in-situ X-ray diffraction measurement using a three-dimensional magnetically oriented microcrystal suspension (3D MOMS) of L-alanine. An experimental setting of the in-situ X-ray measurement of MOMS is schematically shown in the figure. L-alanine microcrystal suspension was poured into a glass capillary and placed on the rotating unit equipped with a pair of neodymium magnets. Rotating X-ray chopper with 10°-slits was placed between the collimator and the suspension. By using this chopper, it was possible to expose the X-ray only when the rotating MOMS makes a specific direction with respect to the impinging X-ray. This has the same effect as the omega oscillation in conventional single crystal measurement. A total of 22 XRD images of 10° increments from 0° to 220° were obtained. The data set was processed by using conventional software to obtain three-dimensional molecular structure of L-alanine. The structure is in good agreement with that reported for the single crystal. R1 and wR2 were 6.53 and 17.4 %, respectively. RMSD value between the determined molecular structure and the reported one was 0.0045 Å. From this result, we conclude that this method can be effective and practical to be used widely for crystal structure analyses.

Structure determination of fatty acid ester biofuels via in situ cryocrystallisation and single crystal X-ray diffraction

CrystEngComm ◽  
2019 ◽  
Vol 21 (1) ◽  
pp. 41-52 ◽  
Author(s):  
Siriyara Jagannatha Prathapa ◽  
Cara Slabbert ◽  
Manuel A. Fernandes ◽  
Andreas Lemmerer
Keyword(s):  
Crystal Structure ◽  
Fatty Acid ◽  
Fatty Acid Ester ◽  
Structure Determination ◽  
Homologous Series ◽  
Methyl Esters ◽  
X Ray Diffraction ◽  
X Ray

In situ cryocrystallisation enabled the crystal structure determination of a homologous series of low-melting n-alkyl methyl esters Cn−1H2n+1CO2CH3.

The new barium compound Ba4Al7+x: formation and crystal structure

2016 ◽  
Vol 71 (5) ◽  
pp. 611-619 ◽  
Author(s):  
Yurii Prots ◽  
Felix Lange ◽  
Christina Drathen ◽  
Marcus Schmidt ◽  
Yuri Grin
Keyword(s):  
Crystal Structure ◽  
Structural Model ◽  
Model Space ◽  
Binary Compound ◽  
Formation Temperature ◽  
X Ray Diffraction ◽  
Scanning Calorimetry ◽  
Laves Phases ◽  
X Ray

AbstractCombining laboratory X-ray powder diffraction with in-situ high-temperature synchrotron experiments and differential scanning calorimetry, it has been shown that Ba21Al40, Ba3Al5, Ba7Al10 and Ba4Al5 decompose peritectically at 914, 826, 756, and 732°C, respectively. In addition, a new binary compound with the composition Ba4Al7+x (x = 0.17) and the formation temperature of 841°C was found. The initial structural model (space group P63/mmc, a = 6.0807(1), c = 39.2828(8) Å) with four Ba and five Al crystallographic positions was developed. It is based on the intergrowth concept involving the neighboring Ba21Al40 and Ba3Al5 phases and the derived atomic arrangement is subsequently refined using X-ray diffraction data. The crystal structures of all phases in the Ba–Al system, except BaAl4, exhibit Kagomé nets of aluminum atoms resembling those observed for the B atoms in the Laves phases AB2. In the crystal structure of Ba4Al7+x, single Kagomé layers alternate with double slabs (MgZn2 motif) along [001] and are separated by Ba cations. Intergrowth features of Ba4Al7+x are discussed together with the neighboring Ba–Al compounds and Sr5Al9.

Crystal structure, mosaicity, and strain analysis of Hawaiian olivines using in situ X-ray diffraction

2011 ◽  
Vol 96 (4) ◽  
pp. 486-497 ◽  
Author(s):  
N. Vinet ◽  
R. L. Flemming ◽  
M. D. Higgins
Keyword(s):  
Crystal Structure ◽  
Strain Analysis ◽  
X Ray Diffraction ◽  
X Ray

Synthesis of Au-SiO2 Composite Nanospheres and Their Catalytic Activity

2016 ◽  
Vol 16 (4) ◽  
pp. 3821-3826 ◽  
Author(s):  
Wang Dexuan ◽  
Li Guian ◽  
Han Qingyan ◽  
Wang Ziqiang ◽  
Pan Liping ◽  
...  
Keyword(s):  
Crystal Structure ◽  
Photoelectron Spectroscopy ◽  
Au Nanoparticles ◽  
Catalytic Properties ◽  
Organic Dyes ◽  
Chemical Elements ◽  
X Ray ◽  
Transmission Electron ◽  
Environmentally Friendly Approach

We report a simple and environmentally friendly approach to the synthesis of Au-SiO2 composite nanospheres. Our method presents a route for the decoration of preformed amine functionalized SiO2 nanospheres by in situ formation of Au nanoparticles at three different concentrations of Au precursor (HAuCl4). Herein, the silane coupling agent (KH-550) is used as an intermediary to connect the Au nanoparticles to the surfaces of the SiO2 nanospheres, which helps avoid the aggregation of Au nanoparticles. The crystal structure, chemical elements, morphology and catalytic properties of the Au-SiO2 composite nanospheres were analyzed by transmission electron microscopy (TEM), X-Ray powder diffraction (XRD), UV-vis-spectrophotometer (UV-vis) and X-ray photoelectron spectroscopy (XPS). The analytical results demonstrate that the Au nanoparticles (4–9 nm) were homogeneously distributed on the surface of the SiO2 nanospheres, which had a good FCC crystal structure. Moreover, the Au-SiO2 composite nanospheres exhibited good catalytic properties, measured by their ability to reduce organic dyes. The Au-SiO2 composite nanospheres are promising candidates for applications in catalysis and wastewater treatment.

Sign in / Sign up

Export Citation Format

Share Document