Organic Matter and Aggregate Size Interactions in Infiltration, Seal Formation, and Soil Loss

2004 ◽  
Vol 68 (3) ◽  
pp. 935-942 ◽  
Author(s):  
M. Lado ◽  
A. Paz ◽  
M. Ben-Hur
2017 ◽  
Vol 241 ◽  
pp. 79-87 ◽  
Author(s):  
Dennis Grunwald ◽  
Michael Kaiser ◽  
Simone Junker ◽  
Sven Marhan ◽  
Hans-Peter Piepho ◽  
...  

2020 ◽  
Vol 295 ◽  
pp. 106882 ◽  
Author(s):  
Jennifer Cooper ◽  
Isabel Greenberg ◽  
Bernard Ludwig ◽  
Laura Hippich ◽  
Daniel Fischer ◽  
...  

Author(s):  
Vito Ferro ◽  
Vincenzo Bagarello

Field plots are often used to obtain experimental data (soil loss values corresponding to different climate, soil, topographic, crop, and management conditions) for predicting and evaluating soil erosion and sediment yield. Plots are used to study physical phenomena affecting soil detachment and transport, and their sizes are determined according to the experimental objectives and the type of data to be obtained. Studies on interrill erosion due to rainfall impact and overland flow need small plot width (2–3 m) and length (< 10 m), while studies on rill erosion require plot lengths greater than 6–13 m. Sites must be selected to represent the range of uniform slopes prevailing in the farming area under consideration. Plots equipped to study interrill and rill erosion, like those used for developing the Universal Soil Loss Equation (USLE), measure erosion from the top of a slope where runoff begins; they must be wide enough to minimize the edge or border effects and long enough to develop downslope rills. Experimental stations generally include bounded runoff plots of known rea, slope steepness, slope length, and soil type, from which both runoff and soil loss can be monitored. Once the boundaries defining the plot area are fixed, a collecting equipment must be used to catch the plot runoff. A conveyance system (H-flume or pipe) carries total runoff to a unit sampling the sediment and a storage system, such as a sequence of tanks, in which sediments are accumulated. Simple methods have been developed for estimating the mean sediment concentration of all runoff stored in a tank by using the vertical concentration profile measured on a side of the tank. When a large number of plots are equipped, the sampling of suspension and consequent oven-drying in the laboratory are highly time-consuming. For this purpose, a sampler that can extract a column of suspension, extending from the free surface to the bottom of the tank, can be used. For large plots, or where runoff volumes are high, a divisor that splits the flow into equal parts and passes one part in a storage tank as a sample can be used. Examples of these devices include the Geib multislot divisor and the Coshocton wheel. Specific equipment and procedures must be employed to detect the soil removed by rill and gully erosion. Because most of the soil organic matter is found close to the soil surface, erosion significantly decreases soil organic matter content. Several studies have demonstrated that the soil removed by erosion is 1.3–5 times richer in organic matter than the remaining soil. Soil organic matter facilitates the formation of soil aggregates, increases soil porosity, and improves soil structure, facilitating water infiltration. The removal of organic matter content can influence soil infiltration, soil structure, and soil erodibility.


2004 ◽  
Vol 13 (2) ◽  
pp. 195 ◽  
Author(s):  
R. García-Corona ◽  
E. Benito ◽  
E. de Blas ◽  
M. E. Varela

Two forest soils rich in organic matter but differing in texture (sandy loam and silty loam) were heated under controlled laboratory conditions in order to examine the consequences of the heating effect that accompanies the passage of a fire on the physical properties of soil. Three samples of both soils were heated for 30 min in a muffle furnace at temperatures of 25, 170, 220, 380 and 460°C. At each temperature, the following parameters were determined: dry aggregate size distribution, water aggregate stability, total porosity, pore size distribution, water repellency and hydraulic conductivity. Heating the soils at 170 and 220°C caused no significant changes in aggregate size distribution or total porosity but increased water aggregate stability and the volume of pores 0.2–30 μm. Also, increased water repellency and strongly decreased the hydraulic conductivity. All parameters underwent much more dramatic changes at 380 and 460°C that can be ascribed to the combustion of organic matter. At such temperatures, water repellency was destroyed and the low hydraulic conductivity can be attributed to the aggregate breakdown observed under dry and wet conditions.


1997 ◽  
Vol 12 (2) ◽  
pp. 55-58 ◽  
Author(s):  
Kim L. Fleming ◽  
William L. Powers ◽  
Alice J. Jones ◽  
Glenn A. Helmers

AbstractThe soil erodibility factor (K) of the Revised Universal Soil Loss Equation is currently considered a constant for all soils in the same type, regardless of production practice. To examine the effect of alternative production systems on the K-factor we compared pairs of alternatively and conventionally farmed fields on a Judson silt loam (Fine-silty, mixed, mesic Cumulic Hapludolls), a Yutan silty clay loam (Fine-silty, mixed, mesic Mollic Hapludalf), and a Wann fine sandy loam (Coarse-loamy, mixed, mesic Fluvaquentic Haplustolls). Soil cores were taken from the surface 10 cm and analyzed for organic matter, permeability, structure, and texture. These data were used to estimate K-factors from a nomograph. All soils in the study had a fine granular structure. Organic matter content and permeability were significantly higher for the alternatively managed field at every location, except for no difference in permeability on the Judson soil. However, the K-factor was significantly lower for the alternative system on the Judson soil. Of all the parameters, texture has the greatest influence in determining K-factors within the nomograph, with soils higher in silt being more erodible than soils higher in sand or clay. Thus, the influences of alternative production systems affected the Judson soil to a greater degree than other textures because of its higher inherent susceptibility to erosion. This study shows that alternative production systems affect the K-factor of some soil types and can reduce soil erodibility, and therefore should be considered when developing conservation plans.


Author(s):  
Sezgin Hacisalihoglu

In this study, the effects of Anatolian Black pine [(Pinus nigra Arn. subsp. pallasiana (Lamb.) Holmboe] plantation on hydro-physical soil properties and soil loss were investigated. This study was carried out on the afforestation field of Anatolian Black Pine in the Gölbaşı district of Ankara province, which is included in the arid and semi-arid regions. Totally 48 soil sample in two soil depth level (0-20cm, 20-50cm) were collected from forest (36 soil sample) and barren (control) area (12 soil sample). Hydro-physically important soil properties were analysed [Sand (%), Silt (%), Clay (%), Organic Matter (%), pH, Field Capacity (%), Wilting Point (%), Saturation (%), Available Water Holding Capacity (cm/cm) Saturated Hydraulic Conductivity (cm/hr), Bulk Density (gr/cm3)]. And soil loss in a unit area by using ABAG (Allgemeine Boden Abtrags Gleichung) model was estimated. Soil properties and soil loss amount relations among the land use group were determined. Topsoil (0-20cm) and subsoil (20-50cm) properties except subsoil organic matter were significantly affected by land use group. Finally, Significant changes were found for annual soil loss amounts in a unit area. Avarage annual soil loss in planted area was found approximately 5.5 times less than barren area at 0-50 cm soil depth. Vegetation factor (C) which is one of the most important components of the soil loss equation, has been significantly affected by afforestation in a short period of 40 years and thus it was a variable to reduce to soil loss.


2007 ◽  
Vol 47 (6) ◽  
pp. 700 ◽  
Author(s):  
M. C. Manna ◽  
A. Swarup ◽  
R. H. Wanjari ◽  
H. N. Ravankar

Yield decline or stagnation under long-term cultivation and its relationship with soil organic matter fractions are rarely considered. To understand this phenomenon, soil organic matter fractions and soil aggregate size distribution were studied in a long-term experiment at Akola, in a Vertisol in a semiarid tropical environment. For 14 years, the following fertiliser treatments were compared with undisturbed fallow plots: unfertilised (control), 100% recommended rates of N, NP, NPK (N : P : K ratios of 100 : 21.8 : 18.2 and 120 : 26.2 : 50 kg/ha for sorghum and wheat, respectively) and 100% NPK plus farmyard manure (FYM) and continuous cropping with a sorghum (Sorghum bicolor L. Moench) and wheat (Triticum aestivum L.) system during 1988–2001. The significant negative yield trend was observed in unbalanced use of inorganic N application for both crops. However, yields were maintained when NPK and NPK + FYM were applied. Results showed that soil organic C and total N in the unfertilised plot decreased by 21.7 and 18.2%, compared to the initial value, at a depth of 0–15 cm. Depletion of large macroaggregates (>2 mm) accounted for 22–81% of the total mass of aggregates in N, NP and unfertilised control plots compared to fallow plots. Irrespective of treatments, small macroaggregates (0.25–2 mm) dominated aggregate size distribution (56–71%), followed by microaggregates (0.053–0.25 mm, 18–37%). Active fractions, such as microbial biomass C, microbial biomass N, hot water soluble C and N, and acid hydrolysable carbohydrates were greater in NPK and NPK + FYM treatments than in the control. Carbon and N mineralisation were greater in small macroaggregates than microaggregates. Particulate organic matter C (POMC) and N (POMN) were significantly correlated (P < 0.01) with water-stable aggregate C and N (0.25–2 mm size classes), respectively. It was further observed that POMC and POMN were significantly greater in NPK and NPK + FYM plots than N and NP treated plots. Microbial biomass C was positively correlated with acid-hydrolysable carbohydrates (r = 0.79, P < 0.05). Continuous cropping and fertiliser use also influenced humic acid C and fulvic acid C fractions of the soil organic matter. Acid-hydrolysable N proportion in humic acid was greater than fulvic acid and it was greatest in NPK + FYM treatments. Continuous application of 100% NPK + FYM could restore soil organic carbon (SOC) to a new equilibrium level much earlier (t = 1/k, 2.4 years) than N (t = 1/k, 25.7 years), NP (t = 1/k, 8.1 years) and NPK (t = 1/k, 5.02 years). In conclusion, integrated use of NPK with FYM would be vital to obtain sustainable yields without deteriorating soil quality.


Sign in / Sign up

Export Citation Format

Share Document