scholarly journals PREDICTIONS OF WAVE INDUCED SHIP MOTIONS AND LOADS BY LARGE-SCALE MODEL MEASUREMENT AT SEA AND NUMERICAL ANALYSIS

Brodogradnja ◽  
2016 ◽  
Vol 67 (2) ◽  
pp. 81-100 ◽  
Author(s):  
Jialong Jiao ◽  
Shuzheng Sun ◽  
Huilong Ren
Keyword(s):  
Numerical Analysis ◽  
Large Scale ◽  
Scale Model ◽  
Ship Motions ◽  
Large Scale Model ◽  
Wave Induced ◽  
Model Measurement

scholarly journals Experimental Investigation of Wave-Induced Ship Hydroelastic Vibrations by Large-Scale Model Measurement in Coastal Waves

2016 ◽  
Vol 2016 ◽  
pp. 1-14 ◽  
Author(s):  
Jialong Jiao ◽  
Huilong Ren ◽  
Shuzheng Sun ◽  
Christiaan Adika Adenya
Keyword(s):  
Large Scale ◽  
Testing Procedure ◽  
Scale Model ◽  
Sea Waves ◽  
Load Pressure ◽  
Large Scale Model ◽  
Wide Range ◽  
Hydroelastic Vibrations ◽  
Wave Induced ◽  
Model Measurement

Ship hydroelastic vibration is an issue involving mutual interactions among inertial, hydrodynamic, and elastic forces. The conventional laboratory tests for wave-induced hydroelastic vibrations of ships are performed in tank conditions. An alternative approach to the conventional laboratory basin measurement, proposed in this paper, is to perform tests by large-scale model measurement in real sea waves. In order to perform this kind of novel experimental measurement, a large-scale free running model and the experiment scheme are proposed and introduced. The proposed testing methodology is quite general and applicable to a wide range of ship hydrodynamic experimental research. The testing procedure is presented by illustrating a 5-hour voyage trial of the large-scale model carried out at Huludao harbor of China in August 2015. Hammer tests were performed to identify the natural frequencies of the ship model at the beginning of the tests. Then a series of tests under different sailing conditions were carried out to investigate the vibrational characteristics of the model. As a postvoyage analysis, load, pressure, acceleration, and motion responses of the model are studied with respect to different time durations based on the measured data.

RANCANG BANGUN PERANGKAT EKSPERIMENTASI PROSES PIROLISIS BIOMASA GELOMBANG MIKRO

2013 ◽  
Vol 14 (2) ◽  
Author(s):  
Noor Fachrizal
Keyword(s):  
Large Scale ◽  
Continuous Model ◽  
Biomass Energy ◽  
Scale Model ◽  
Small Scale ◽  
Laboratory Apparatus ◽  
Liquid Form ◽  
Large Scale Model ◽  
Bio Oil ◽  
Pyrolysis Of Biomass

Biomass such as agriculture waste and urban waste are enormous potency as energy resources instead of enviromental problem. organic waste can be converted into energy in the form of liquid fuel, solid, and syngas by using of pyrolysis technique. Pyrolysis process can yield higher liquid form when the process can be drifted into fast and flash response. It can be solved by using microwave heating method. This research is started from developing an experimentation laboratory apparatus of microwave-assisted pyrolysis of biomass energy conversion system, and conducting preliminary experiments for gaining the proof that this method can be established for driving the process properly and safely. Modifying commercial oven into laboratory apparatus has been done, it works safely, and initial experiments have been carried out, process yields bio-oil and charcoal shortly, several parameters are achieved. Some further experiments are still needed for more detail parameters. Theresults may be used to design small-scale continuous model of productionsystem, which then can be developed into large-scale model that applicable for comercial use.

Effect of an Oscillating Flow Direction on Leading Edge Heat Transfer

1984 ◽  
Vol 106 (1) ◽  
pp. 222-228 ◽  
Author(s):  
M. L. Marziale ◽  
R. E. Mayle
Keyword(s):  
Heat Transfer ◽  
Strouhal Number ◽  
Large Scale ◽  
Flow Direction ◽  
Leading Edge ◽  
Periodic Variation ◽  
Scale Model ◽  
Transfer Rates ◽  
Large Scale Model ◽  
Turbulence Length

An experimental investigation was conducted to examine the effect of a periodic variation in the angle of attack on heat transfer at the leading edge of a gas turbine blade. A circular cylinder was used as a large-scale model of the leading edge region. The cylinder was placed in a wind tunnel and was oscillated rotationally about its axis. The incident flow Reynolds number and the Strouhal number of oscillation were chosen to model an actual turbine condition. Incident turbulence levels up to 4.9 percent were produced by grids placed upstream of the cylinder. The transfer rate was measured using a mass transfer technique and heat transfer rates inferred from the results. A direct comparison of the unsteady and steady results indicate that the effect is dependent on the Strouhal number, turbulence level, and the turbulence length scale, but that the largest observed effect was only a 10 percent augmentation at the nominal stagnation position.

Large scale model tests on Royal Schelde SES

1989 ◽  
Author(s):  
R. DE GAAIJ ◽  
E. VAN RIETBERGEN ◽  
M. SLEGERS
Keyword(s):  
Large Scale ◽  
Model Tests ◽  
Scale Model ◽  
Large Scale Model

Experimental Study on the Behavior of a Swimming Pool Onboard a Large Passenger Ship

2009 ◽  
Vol 46 (01) ◽  
pp. 27-33
Author(s):  
Pekka Ruponen ◽  
Jerzy Matusiak ◽  
Janne Luukkonen ◽  
Mikko Ilus
Keyword(s):  
Large Scale ◽  
Hydraulic Cylinder ◽  
Operating Conditions ◽  
Swimming Pool ◽  
Scale Model ◽  
Longitudinal Motion ◽  
Sea State ◽  
Passenger Ship ◽  
Large Scale Model ◽  
Computer Controlled

The water in a swimming pool on the top deck of a large passenger ship can be excited to a resonant motion, even in a moderate sea state. The motion of the water in the pool is mainly caused by longitudinal acceleration, resulting from the ship's pitch and surge motions. At resonance, there can be high waves in the pool and splashing of water. In this study the behavior of the Solarium Pool of the Freedom of the Seas was examined in various sea states and operating conditions. The motions of the pool were calculated on the basis of a linear seakeeping method, and the behavior of the water in the pool was studied with experimental model tests. A large-scale model of the pool was constructed and fitted to a purpose-built test bench that could be axially moved by a computer-controlled hydraulic cylinder. Water elevation in the pool was measured, and all tests were video recorded. Different modifications of the pool were tested to improve the behavior of the pool. A strong correlation between the longitudinal motion and the behavior of the water in the pool was found.

Sign in / Sign up

Export Citation Format

Share Document