AXKT Drop Rate Test

1989 ◽  
Author(s):  
Dan Moffat
Keyword(s):  
Rate Test ◽  
Drop Rate

Vuilleumier Cooler Wear Rate Test Program

1976 ◽  
Author(s):  
T. Ohara ◽  
K. G. Moore ◽  
M. N. Gardos
Keyword(s):  
Wear Rate ◽  
Test Program ◽  
Rate Test

scholarly journals The High-Rate Sealed MRPC to Promote Pollutant Exchange in Gas Gaps: Status on the Development and Observations

2021 ◽  
Vol 11 (11) ◽  
pp. 4722
Author(s):  
Botan Wang ◽  
Xiaolong Chen ◽  
Yi Wang ◽  
Dong Han ◽  
Baohong Guo ◽  
...  
Keyword(s):  
Gas Flow ◽  
High Rate ◽  
Stable Operation ◽  
Beam Test ◽  
High Luminosity ◽  
Rate Test ◽  
3D Printed ◽  
Resistive Plate Chambers ◽  
The Impact ◽  
Current Behavior

This work reports the latest observations on the behavior of two Multigap Resistive Plate Chambers (MRPC) under wide high-luminosity exposures, which motivate the development and in-beam test of the sealed MRPC prototype assembled with low-resistive glass. The operation currently being monitored, together with previous simulation results, shows the impact of gas pollution caused by avalanches in gas gaps, and the necessity to shrink the gas-streaming volume. With the lateral edge of the detector sealed by a 3D-printed frame, a reduced gas-streaming volume of ~170 mL has been achieved for a direct gas flow to the active area. A high-rate test of the sealed MRPC prototype shows that, ensuring a 97% efficiency and 70 ps time resolution, the sealed design results in a stable operation current behavior at a counting rate of 3–5 kHz/cm2. The sealed MRPC will become a potential solution for future high luminosity applications.

scholarly journals Rock Stress Measurements for Unlined Pressure Tunnels: A True Triaxial Laboratory Experiment to Investigate the Ability of a Simplified Hydraulic Jacking Test to Assess Fracture Normal Stress

2021 ◽  
Author(s):  
Henki Ødegaard ◽  
Bjørn Nilsen
Keyword(s):  
Normal Stress ◽  
Test Method ◽  
Sudden Increase ◽  
Normal Stresses ◽  
True Triaxial ◽  
Step Rate ◽  
Stress Measurements ◽  
Fracture Closure ◽  
Rate Test ◽  
Hydraulic Jacking

AbstractTo avoid hydraulic failure of unlined pressure tunnels, knowledge of minimum principal stress is needed. Such knowledge is only obtainable from in situ measurements, which are often time-consuming and relatively costly, effectively limiting the number of measurements typically performed. In an effort to enable more stress measurements, the authors propose a simplified and cost-effective stress measuring method; the Rapid Step-Rate Test (RSRT), which is based on existing hydraulic testing methods. To investigate the ability of this test to measure fracture normal stresses in field-like conditions, a true triaxial laboratory test rig has been developed. Hydraulic jacking experiments performed on four granite specimens, each containing a fracture, have been performed. Interpretation of pressure-, flow- and acoustic emission (AE) data has been used to interpret fracture behaviour and to assess fracture normal stresses. Our experimental data suggest that the proposed test method, to a satisfactory degree of reliability, can measure the magnitude of fracture normal stress. In addition, a clear correlation has been found between fracture closure and sudden increase in AE rate, suggesting that AE monitoring during testing can serve as a useful addition to the test. The rapid step-rate test is also considered relevant for field-scale measurements, with only minor adaptions. Our findings suggest that the RSRT can represent a way to get closer to the ideal of performing more testing along the entire length of pressure tunnel, and not only at key locations, which requires interpolation of stress data with varying degree of validity.

scholarly journals Lamellar Polypyrene Based on Attapulgite–Sulfur Composite for Lithium–Sulfur Battery

Membranes ◽  
2021 ◽  
Vol 11 (7) ◽  
pp. 483
Author(s):  
Jing Wang ◽  
Riwei Xu ◽  
Chengzhong Wang ◽  
Jinping Xiong
Keyword(s):  
Cathode Material ◽  
Current Density ◽  
High Current Density ◽  
Specific Capacity ◽  
Lithium Sulfur Batteries ◽  
Rate Test ◽  
Sulfur Battery ◽  
Lower Capacity ◽  
Lithium Sulfur

We report on the preparation and characterization of a novel lamellar polypyrrole using an attapulgite–sulfur composite as a hard template. Pretreated attapulgite was utilized as the carrier of elemental sulfur and the attapulgite–sulfur–polypyrrole (AT @400 °C–S–PPy) composite with 50 wt.% sulfur was obtained. The structure and morphology of the composite were characterized with infrared spectroscopy (IR), thermogravimetric analysis (TGA), and scanning electron microscopy (SEM). An AT @400 °C–S–PPy composite was further utilized as the cathode material for lithium–sulfur batteries. The first discharge specific capacity of this kind of battery reached 1175 mAh/g at a 0.1 C current rate and remained at 518 mAh/g after 100 cycles with capacity retention close to 44%. In the rate test, compared with the polypyrrole–sulfur (PPy–S) cathode material, the AT @400 °C–S–PPy cathode material showed lower capacity at a high current density, but it showed higher capacity when the current came back to a low current density, which was attributed to the “recycling” of pores and channels of attapulgite. Therefore, the lamellar composite with special pore structure has great value in improving the performance of lithium–sulfur batteries.

scholarly journals Analysis of substitution rates showed that TLR5 is evolving at different rates among mammalian groups

2019 ◽  
Vol 19 (1) ◽  
Author(s):  
Ana Pinheiro ◽  
Ana Águeda-Pinto ◽  
José Melo-Ferreira ◽  
Fabiana Neves ◽  
Joana Abrantes ◽  
...  
Keyword(s):  
Substitution Rate ◽  
Relative Rate ◽  
Purifying Selection ◽  
Genetic Distances ◽  
Major Protein ◽  
Substitution Rates ◽  
Evolutionary Pattern ◽  
Branch Model ◽  
Rate Test ◽  
Species Specific

Abstract Background Toll-like receptors (TLRs) are the most widely studied innate immunity receptors responsible for recognition of invading pathogens. Among the TLR family, TLR5 is the only that senses and recognizes flagellin, the major protein of bacterial flagella. TLR5 has been reported to be under overall purifying selection in mammals, with a small proportion of codons under positive selection. However, the variation of substitution rates among major mammalian groups has been neglected. Here, we studied the evolution of TLR5 in mammals, comparing the substitution rates among groups. Results In this study we analysed the TLR5 substitution rates in Euungulata, Carnivora, Chiroptera, Primata, Rodentia and Lagomorpha, groups. For that, Tajima’s relative rate test, Bayesian inference of evolutionary rates and genetic distances were estimated with CODEML’s branch model and RELAX. The combined results showed that in the Lagomorpha, Rodentia, Carnivora and Chiroptera lineages TLR5 is evolving at a higher substitution rate. The RELAX analysis further suggested a significant relaxation of selective pressures for the Lagomorpha (K = 0.22, p < 0.01), Rodentia (K = 0.58, p < 0.01) and Chiroptera (K = 0.65, p < 0.01) lineages and for the Carnivora ancestral branches (K = 0.13, p < 0.01). Conclusions Our results show that the TLR5 substitution rate is not uniform among mammals. In fact, among the different mammal groups studied, the Lagomorpha, Rodentia, Carnivora and Chiroptera are evolving faster. This evolutionary pattern could be explained by 1) the acquisition of new functions of TLR5 in the groups with higher substitution rate, i.e. TLR5 neofunctionalization, 2) by the beginning of a TLR5 pseudogenization in these groups due to some redundancy between the TLRs genes, or 3) an arms race between TLR5 and species-specific parasites.

scholarly journals Determination of rheological behaviour of wine lees

2015 ◽  
Vol 29 (3) ◽  
pp. 307-311 ◽  
Author(s):  
Jaromír Lachman ◽  
Kazimierz Rutkowski ◽  
Petr Trávníček ◽  
Tomáš Vítěz ◽  
Patrik Burg ◽  
...  
Keyword(s):  
Dynamic Viscosity ◽  
Rheological Behaviour ◽  
Volatile Acid ◽  
Second Phase ◽  
Temperature Hysteresis ◽  
Chemical Background ◽  
Rate Test ◽  
Red Grape ◽  
Increasing Temperature

Abstract This study deals with the rheological properties of wine lees. Samples of wine lees of the Saint Laurent variety were used in this experiment. The investigated wine lees arose in the process of production red grape wine in 2013 (Czech Republic). At first, the chemical background was determined. The chemical background includes the following chemical parameters: total acidity, pH, alcohol content, reduced sugars, free SO2, total SO2, and volatile acid. In the second phase of the study, physical properties were determined. Specifically, a sample of wine lees was subjected to rheological tests. These tests consisted in determination of dependence of dynamic viscosity on the temperature, hysteresis loop tests, dependence of dynamic viscosity on the time and step-down in the shear rate test. The experiment demonstrated that the dynamic viscosity increased with increased temperature – this phenomenon is caused by thermolabile proteins – and the wine lees has rheopectic behaviour; the degree of rheopexy was found to rise with the increasing temperature.

Sign in / Sign up

Export Citation Format

Share Document