Transition to Turbulence in Constant-Acceleration Pipe Flow

1988 ◽  
Author(s):  
P. J. Lefebvre
Keyword(s):  
Pipe Flow ◽  
Transition To Turbulence ◽  
Constant Acceleration

Critical Reynolds Number in Constant-Acceleration Pipe Flow From an Initial Steady Laminar State

2010 ◽  
Vol 132 (9) ◽  
Author(s):  
Charles W. Knisely ◽  
Kazuyoshi Nishihara ◽  
Manabu Iguchi
Keyword(s):  
Reynolds Number ◽  
Flow Visualization ◽  
Pipe Flow ◽  
Laser Doppler Velocimetry ◽  
Critical Reynolds Number ◽  
Transition To Turbulence ◽  
Doppler Velocimetry ◽  
Constant Acceleration ◽  
Laminar State ◽  
Steady Laminar

The transition to turbulence in a constant-acceleration pipe flow from an initial laminar state was investigated in a custom-made apparatus permitting visual access to the water flow in the pipe. The apparatus allowed both laser Doppler velocimetry measurements and flow visualization using a tracer. The experiment was carried out by accelerating the flow from a steady laminar state to a steady turbulent state. The relation between the critical Reynolds number for transition to turbulence and the acceleration was found to be similar to that in a constant-acceleration pipe flow started from rest. In addition, with increased acceleration, the turbulent transition was found to be delayed to higher Reynolds numbers using flow visualization with simultaneous laser Doppler velocimetry measurements.

Effect of Initial Constant Acceleration on the Transition to Turbulence in Transient Circular Pipe Flow

2010 ◽  
Vol 132 (11) ◽  
Author(s):  
Manabu Iguchi ◽  
Kazuyoshi Nishihara ◽  
Yusuke Nakahata ◽  
Charles W. Knisely
Keyword(s):  
Reynolds Number ◽  
Pipe Flow ◽  
Time Lag ◽  
Transition To Turbulence ◽  
Circular Pipe ◽  
Constant Acceleration ◽  
Mean Velocity ◽  
Cross Sectional ◽  
Circular Pipe Flow ◽  
The Cross

Experimental investigation is carried out on the transition to turbulence in a transient circular pipe flow. The flow is accelerated from rest at a constant acceleration until its cross-sectional mean velocity reaches a constant value. Accordingly, the history of the flow thus generated consists of the initial stage of constant acceleration and the following stage of constant cross-sectional mean velocity. The final Reynolds number based on the constant cross-sectional mean velocity and the pipe diameter is chosen to be much greater than the transition Reynolds number of a steady pipe flow of about 3000. The transition to turbulence is judged from the output signal of the axial velocity component and its root-mean-square value measured with a hot-wire anemometer. A turbulent slug appears after the cross-sectional mean velocity of the flow reaches the predetermined constant value under every experimental condition. Turbulence production therefore is suppressed, while the flow is accelerated. The time lag for the appearance of the turbulent slug after the cross-sectional mean velocity of the flow reaches the constant value decreases with an increase in the constant acceleration value. An empirical equation is proposed for estimating the time lag. The propagation velocity of the leading edge of the turbulent slug is independent of the constant acceleration value under the present experimental conditions.

scholarly journals Experimental and theoretical progress in pipe flow transition

2008 ◽  
Vol 366 (1876) ◽  
pp. 2671-2684 ◽  
Author(s):  
A.P Willis ◽  
J Peixinho ◽  
R.R Kerswell ◽  
T Mullin
Keyword(s):  
Pipe Flow ◽  
Quantitative Agreement ◽  
Travelling Wave ◽  
Turbulent Pipe Flow ◽  
Transition To Turbulence ◽  
Reynolds Number Flow ◽  
Threshold Amplitude ◽  
Number Flow ◽  
The Stability ◽  
Laminar State

There have been many investigations of the stability of Hagen–Poiseuille flow in the 125 years since Osborne Reynolds' famous experiments on the transition to turbulence in a pipe, and yet the pipe problem remains the focus of attention of much research. Here, we discuss recent results from experimental and numerical investigations obtained in this new century. Progress has been made on three fundamental issues: the threshold amplitude of disturbances required to trigger a transition to turbulence from the laminar state; the threshold Reynolds number flow below which a disturbance decays from turbulence to the laminar state, with quantitative agreement between experimental and numerical results; and understanding the relevance of recently discovered families of unstable travelling wave solutions to transitional and turbulent pipe flow.

Stability of Hagen-Poiseuille flow with superimposed rigid rotation

1976 ◽  
Vol 73 (1) ◽  
pp. 153-164 ◽  
Author(s):  
P.-A. Mackrodt
Keyword(s):  
Poiseuille Flow ◽  
Pipe Flow ◽  
Stokes Equations ◽  
Three Dimensional ◽  
Reynolds Numbers ◽  
Neutral Curve ◽  
Rigid Rotation ◽  
Transition To Turbulence ◽  
Navier Stokes ◽  
Navier Stokes Equations

The linear stability of Hagen-Poiseuille flow (Poiseuille pipe flow) with superimposed rigid rotation against small three-dimensional disturbances is examined at finite and infinite axial Reynolds numbers. The neutral curve, which is obtained by numerical solution of the system of perturbation equations (derived from the Navier-Stokes equations), has been confirmed for finite axial Reynolds numbers by a few simple experiments. The results suggest that, at high axial Reynolds numbers, the amount of rotation required for destabilization could be small enough to have escaped notice in experiments on the transition to turbulence in (nominally) non-rotating pipe flow.

scholarly journals Pipe flow with large particles and their impact on the transition to turbulence

2020 ◽  
Vol 5 (11) ◽  
Author(s):  
Martin Leskovec ◽  
Fredrik Lundell ◽  
Fredrik Innings
Keyword(s):  
Pipe Flow ◽  
Transition To Turbulence ◽  
Large Particles

The effect of rigid rotation on the finite-amplitude stability of pipe flow at high Reynolds number

1984 ◽  
Vol 148 ◽  
pp. 193-205 ◽  
Author(s):  
T. R. Akylas ◽  
J.-P. Demurger
Keyword(s):  
Reynolds Number ◽  
Pipe Flow ◽  
High Reynolds Number ◽  
Finite Amplitude ◽  
Linear Instability ◽  
Rigid Rotation ◽  
Transition To Turbulence ◽  
Neutral Stability ◽  
Axisymmetric Mode ◽  
High Reynolds

A theoretical study is made of the stability of pipe flow with superimposed rigid rotation to finite-amplitude disturbances at high Reynolds number. The non-axisymmetric mode that requires the least amount of rotation for linear instability is considered. An amplitude expansion is developed close to the corresponding neutral stability curve; the appropriate Landau constant is calculated. It is demonstrated that the flow exhibits nonlinear subcritical instability, the nonlinear effects being particularly strong owing to the large magnitude of the Landau constant. These findings support the view that a small amount of extraneous rotation could play a significant role in the transition to turbulence of pipe flow.

scholarly journals Transition to turbulence in slowly divergent pipe flow

2013 ◽  
Vol 25 (11) ◽  
pp. 111702 ◽  
Author(s):  
Jorge Peixinho ◽  
Hugues Besnard
Keyword(s):  
Pipe Flow ◽  
Transition To Turbulence

Experiments on transition to turbulence in an oscillatory pipe flow

1976 ◽  
Vol 75 (2) ◽  
pp. 193-207 ◽  
Author(s):  
Mikio Hino ◽  
Masaki Sawamoto ◽  
Shuji Takasu
Keyword(s):  
Reynolds Number ◽  
Turbulent Flow ◽  
Pipe Flow ◽  
Stokes Parameter ◽  
Angular Frequency ◽  
Transition To Turbulence ◽  
Mean Velocity ◽  
Cross Sectional ◽  
Velocity Amplitude ◽  
Turbulent Flow Regime

Experiments on transition to turbulence in a purely oscillatory pipe flow were performed for values of the Reynolds number Rδ, defined using the Stokes-layer thickness δ = (2ν/ω)½ and the cross-sectional mean velocity amplitude Û, from 19 to 1530 (or for values of the Reynolds number Re, defined using the pipe diameter d and Û, from 105 to 5830) and for values of the Stokes parameter λ = ½d(ω/2ν)½ (ν = kinematic viscosity and ω = angular frequency) from 1·35 to 6·19. Three types of turbulent flow regime have been detected: weakly turbulent flow, conditionally turbulent flow and fully turbulent flow. Demarcation of the flow regimes is possible on Rλ, λ or Re, λ diagrams. The critical Reynolds number of the first transition decreases as the Stokes parameter increases. In the conditionally turbulent flow, turbulence is generated suddenly in the decelerating phase and the profile of the velocity distribution changes drastically. In the accelerating phase, the flow recovers to laminar. This type of partially turbulent flow persists even at Reynolds numbers as high as Re = 5830 if the value of the Stokes parameter is high.

Sign in / Sign up

Export Citation Format

Share Document