A Wind-Tunnel Investigation of the Aerodynamic Environment of a Full Scale Helicopter Rotor in Forward Flight

1970 ◽  
Author(s):  
Thomas H. Bowden ◽  
Gerald A. Shockey
Keyword(s):  
Wind Tunnel ◽  
Full Scale ◽  
Helicopter Rotor ◽  
Forward Flight

Wind Tunnel to Full Scale Mapping of Winds and Loads for Launch-Vehicle Ground Wind Loads

2021 ◽  
Author(s):  
Thomas G. Ivanco ◽  
Donald F. Keller ◽  
Jennifer L. Pinkerton
Keyword(s):  
Wind Tunnel ◽  
Launch Vehicle ◽  
Full Scale ◽  
Wind Loads

Characterization of wind-induced pressure on membrane roofs based on full-scale wind tunnel testing

2021 ◽  
Vol 235 ◽  
pp. 112101
Author(s):  
Johnny Estephan ◽  
Changda Feng ◽  
Arindam Gan Chowdhury ◽  
Mauricio Chavez ◽  
Appupillai Baskaran ◽  
...  
Keyword(s):  
Wind Tunnel ◽  
Full Scale ◽  
Wind Tunnel Testing ◽  
Tunnel Testing

Some improvements of hybrid trim method for a helicopter rotor in forward flight

2021 ◽  
Vol 113 ◽  
pp. 106709
Author(s):  
Weili Lyu ◽  
Shiyuan Wang ◽  
Aiming Yang
Keyword(s):  
Helicopter Rotor ◽  
Forward Flight

A New Method of Modeling Underexpanded Exhaust Plumes for Wind Tunnel Aerodynamic Testing

1989 ◽  
Vol 111 (4) ◽  
pp. 748-754
Author(s):  
V. Salemann ◽  
J. M. Williams
Keyword(s):  
Wind Tunnel ◽  
Free Stream ◽  
Dynamic Pressure ◽  
Pressure Ratio ◽  
Area Ratio ◽  
Full Scale ◽  
New Method ◽  
Thrust Coefficient ◽  
Model Scale ◽  
Exhaust Plumes

A new method for modeling hot underexpanded exhaust plumes with cold model scale plumes in aerodynamic wind tunnel testing has been developed. The method is applicable to aeropropulsion testing where significant interaction between the exhaust and the free stream and aftbody may be present. The technique scales the model and nozzle external geometry, including the nozzle exit area, matches the model jet to free-stream dynamic pressure ratio to full-scale jet to free-stream dynamic pressure ratio, and matches the model thrust coefficient to full-scale thrust coefficient. The technique does not require scaling of the internal nozzle geometry. A generalized method of characteristic computer code was used to predict the plume shapes of a hot (γ = 1.2) half-scale nozzle of area ratio 3.2 and of a cold (γ = 1.4) model scale nozzle of area ratio 1.3, whose pressure ratio and area ratio were selected to satisfy the above criteria and other testing requirements. The plume shapes showed good agreement. Code validity was checked by comparing code results for cold air exhausting into a quiescent atmosphere to pilot surveys and shadowgraphs of model nozzle plumes taken in a static facility.

Sign in / Sign up

Export Citation Format

Share Document