Analysis of Stratospheric Balloon Programs

1971 ◽  
Author(s):  
M. P. Hagan
Keyword(s):  
Stratospheric Balloon

Method for Prediction and Optimization of a Stratospheric Balloon Ascent Trajectory

2009 ◽  
Vol 46 (1) ◽  
pp. 126-133 ◽  
Author(s):  
Gianfranco Morani ◽  
Roberto Palumbo ◽  
Giovanni Cuciniello ◽  
Federico Corraro ◽  
Michelangelo Russo
Keyword(s):  
Stratospheric Balloon

Monitoring of air pollutants using a stratospheric balloon

2021 ◽  
Author(s):  
Federico Toson ◽  
Dumitrita Sandu ◽  
Luca Vitali ◽  
Andrea Conte ◽  
Daniele Panariti ◽  
...  
Keyword(s):  
Air Pollutants ◽  
Stratospheric Balloon

scholarly journals Measurements of Aerosols and Charged Particles On the BEXUS18 Stratospheric Balloon

2019 ◽  
Author(s):  
Erika Brattich ◽  
Encarnación Serrano Castillo ◽  
Fabrizio Giulietti ◽  
Jean-Baptiste Renard ◽  
Sachi N. Tripathi ◽  
...  
Keyword(s):  
Fine Particles ◽  
Low Cost ◽  
Charged Particles ◽  
Negative Ions ◽  
Ground Level ◽  
Experimental Setup ◽  
Vertical Profiles ◽  
Aerosol Model ◽  
Analysis Experiment ◽  
Stratospheric Balloon

Abstract. This paper describes the aerosol measurements setup and results obtained during the BEXUS18 stratospheric balloon within the A5-Unibo (Advanced Atmospheric Aerosol Acquisition and Analysis) experiment performed on October 10th, 2014 in northern Sweden (Kiruna). The experimental setup was designed and developed by the University of Bologna with the aim of collecting and analyzing vertical profiles of atmospheric ions and particles together with atmospheric parameters (temperature, relative humidity and pressure) all along the stratospheric ascent of the BEXUS18 stratospheric balloon. Particles size distributions were measured with the MeteoModem Light Optical Aerosol Counter (LOAC) and air ion density was measured with a set of two commercial and portable ion counters. Though the experimental setup was based upon relatively low-cost and light-weight sensors, vertical profiles of all the parameters up to an altitude of about 27 km were successfully collected. The results obtained are useful for elucidating the relationships between aerosols and charged particles between ground level and the stratosphere with great potential in collecting and adding useful information in this field, also in the stratosphere where such measurements are rare. In particular, the equipment detected coherent vertical profiles for particles and ions, with a particularly strong correlation between negative ions and fine particles, possibly resulting from proposed associations between cosmic rays and ions as previously suggested. In addition, the detection of charged aerosols in the stratosphere is in agreement with the results obtained by a previous flight and with simulations conducted with a stratospheric ion-aerosol model. However, further measurements under stratospheric balloon flights equipped with a similar setup are needed to reach general conclusions on such important issues.

scholarly journals Instrumentation of Stratospheric Balloon Straps with Optical Fibre for Temperature and Strain Monitoring

Sensors ◽  
2020 ◽  
Vol 20 (5) ◽  
pp. 1433 ◽  
Author(s):  
Yann Lecieux ◽  
Cyril Lupi ◽  
Dominique Leduc ◽  
Quentin Macé ◽  
Valentin Jeanneau ◽  
...  
Keyword(s):  
Optical Fibre ◽  
Pressure Field ◽  
Numerical Models ◽  
Industrial Process ◽  
Mechanical Tests ◽  
Optical Fibres ◽  
Frequency Shifts ◽  
Strain Monitoring ◽  
Stratospheric Balloon

This article is devoted to the instrumentation, with optical fibres, of the straps holding the envelope of stratospheric balloons. This instrumentation is motivated in the first instance by the need to validate the numerical models used in the design of balloons. It must also be used to measure the temperature along the envelope in order to deduce the pressure field. It is shown at first that the optical fibres can be inserted inside a strap during its fabrication. Different kinds of insertion are considered, none of them perturb the industrial process. The instrumented straps were then submitted to thermal and mechanical tests and the distributed Brillouin frequency shifts were measured. We thus determined the type of insertion to be used according to the parameter (temperature or strain) to be measured and assessed the performance of the measurement chain.

scholarly journals Infrasound and Gravity Waves Over the Andes Observed by a Pressure Sensor on Board a Stratospheric Balloon

2020 ◽  
Vol 125 (6) ◽  
Author(s):  
Guerman Poler ◽  
Raphaël F. Garcia ◽  
Daniel C. Bowman ◽  
Léo Martire
Keyword(s):  
Gravity Waves ◽  
Pressure Sensor ◽  
The Andes ◽  
Stratospheric Balloon
Sign in / Sign up

Export Citation Format

Share Document