Simulation of Intelligent Well Completion Predicts Oil Recovery Increase in a Commingled Production Scenario: A Case Study

2003 ◽  
Author(s):  
Arashi Ajayi ◽  
Mike Konopczynski
Keyword(s):  
Oil Recovery ◽  
Well Completion

scholarly journals The Effect of Carbonyl and Hydroxyl Compounds on Swelling Factor, Interfacial Tension, and Viscosity in CO2 Injection: A Case Study on Aromatic Oils

Processes ◽  
2021 ◽  
Vol 9 (1) ◽  
pp. 94
Author(s):  
Asep Kurnia Permadi ◽  
Egi Adrian Pratama ◽  
Andri Luthfi Lukman Hakim ◽  
Doddy Abdassah
Keyword(s):  
Interfacial Tension ◽  
Oil Recovery ◽  
Viscosity Reduction ◽  
Co2 Injection ◽  
Minimum Miscibility Pressure ◽  
Lower Viscosity ◽  
Hydroxyl Compounds ◽  
Swelling Factor

A factor influencing the effectiveness of CO2 injection is miscibility. Besides the miscible injection, CO2 may also contribute to oil recovery improvement by immiscible injection through modifying several properties such as oil swelling, viscosity reduction, and the lowering of interfacial tension (IFT). Moreover, CO2 immiscible injection performance is also expected to be improved by adding some solvent. However, there are a lack of studies identifying the roles of solvent in assisting CO2 injection through observing those properties simultaneously. This paper explains the effects of CO2–carbonyl and CO2–hydroxyl compounds mixture injection on those properties, and also the minimum miscibility pressure (MMP) experimentally by using VIPS (refers to viscosity, interfacial tension, pressure–volume, and swelling) apparatus, which has a capability of measuring those properties simultaneously within a closed system. Higher swelling factor, lower viscosity, IFT and MMP are observed from a CO2–propanone/acetone mixture injection. The role of propanone and ethanol is more significant in Sample A1, which has higher molecular weight (MW) of C7+ and lower composition of C1–C4, than that in the other Sample A9. The solvents accelerate the ways in which CO2 dissolves and extracts oil, especially the extraction of the heavier component left in the swelling cell.

Undersaturated Hydrocarbon Reservoir Waterflooding: A simulation Approach to Performance Assessment

2021 ◽  
Author(s):  
Adekunle Tirimisiyu Adeniyi ◽  
Miracle Imwonsa Osatemple ◽  
Abdulwahab Giwa
Keyword(s):  
Oil Recovery ◽  
Net Present Value ◽  
Oil Production ◽  
Base Case ◽  
Present Value ◽  
Sweep Efficiency ◽  
Recovery Method ◽  
Solution Approach ◽  
Hydrocarbon Reservoir

Abstract There are a good numbers of brown hydrocarbon reservoirs, with a substantial amount of bypassed oil. These reservoirs are said to be brown, because a huge chunk of its recoverable oil have been produced. Since a significant number of prominent oil fields are matured and the number of new discoveries is declining, it is imperative to assess performances of waterflooding in such reservoirs; taking an undersaturated reservoir as a case study. It should be recalled that Waterflooding is widely accepted and used as a means of secondary oil recovery method, sometimes after depletion of primary energy sources. The effects of permeability distribution on flood performances is of concerns in this study. The presence of high permeability streaks could lead to an early water breakthrough at the producers, thus reducing the sweep efficiency in the field. A solution approach adopted in this study was reserve water injection. A reverse approach because, a producing well is converted to water injector while water injector well is converted to oil producing well. This optimization method was applied to a waterflood process carried out on a reservoir field developed by a two - spot recovery design in the Niger Delta area of Nigeria that is being used as a case study. Simulation runs were carried out with a commercial reservoir oil simulator. The result showed an increase in oil production with a significant reduction in water-cut. The Net Present Value, NPV, of the project was re-evaluated with present oil production. The results of the waterflood optimization revealed that an increase in the net present value of up to 20% and an increase in cumulative production of up to 27% from the base case was achieved. The cost of produced water treatment for re-injection and rated higher water pump had little impact on the overall project economy. Therefore, it can conclude that changes in well status in wells status in an heterogenous hydrocarbon reservoir will increase oil production.

scholarly journals UNDERWATER RECOVERY OF SUBMERGED OIL DURING A COLD WEATHER RESPONSE

1997 ◽  
Vol 1997 (1) ◽  
pp. 765-772 ◽  
Author(s):  
CDR Randolph C. Heiland ◽  
LTJG Benjamin L. Smith ◽  
William Edward Hazel ◽  
Michael Popa ◽  
Dennis J. McCarthy
Keyword(s):  
Oil Recovery ◽  
Coal Tar ◽  
Cold Weather ◽  
Transfer System ◽  
Storage Tanks ◽  
Hydraulic Power ◽  
Detroit River ◽  
Subzero Temperatures ◽  
Harsh Conditions

ABSTRACT On February 5, 1996, a failed gasket on a transfer system between two 700,000-gallon storage tanks caused a spill of coal tar. The spill migrated through an outfall and entered the Detroit River. Eventually it was determined that 3500 gallons of the heavy coal tar had entered the river and sunk to the bottom. Responders used submersible pumps powered by hydraulic power packs and an environmental clamshell dredge to recover the submerged coal tar. Responders constantly battled subzero temperatures on the shore and frigid temperatures below the surface throughout the entire operation. Water recovered during the operation was filtered and discharged on site under the direction of the Michigan Department of Environmental Quality. This case study presents the spill response community with an in-depth view of submerged oil recovery during unusual and harsh conditions.

Sign in / Sign up

Export Citation Format

Share Document