Karstic High Permeability Layers: Characterization and Preservation While Modeling Carbonate Reservoirs

2002 ◽  
Author(s):  
Roselyne Botton-Dumay ◽  
Thierry Manivit ◽  
Gerard Massonnat ◽  
Viviane Gay
Keyword(s):  
Carbonate Reservoirs ◽  
High Permeability

A Novel Coreflood Test to Evaluate EOR Potential of Wettability-Altering Surfactants in Oil-Wet Heterogeneous Carbonate Reservoirs

2021 ◽  
Author(s):  
Yue Shi ◽  
Kishore Mohanty ◽  
Manmath Panda
Keyword(s):  
Oil Recovery ◽  
Carbonate Reservoirs ◽  
Wettability Alteration ◽  
Low Permeability ◽  
High Permeability ◽  
Matrix Permeability ◽  
Rock Heterogeneity ◽  
The Matrix ◽  
Flow Through ◽  
Main Factors

Abstract Oil-wetness and heterogeneity (i.e., existence of low and high permeability regions) are two main factors that result in low oil recovery by waterflood in carbonate reservoirs. The injected water is likely to flow through high permeability regions and bypass the oil in low permeability matrix. In this study, systematic coreflood tests were carried out in both "homogeneous" cores and "heterogeneous" cores. The heterogeneous coreflood test was proposed to model the heterogeneity of carbonate reservoirs, bypassing in low-permeability matrix during waterfloods, and dynamic imbibition of surfactant into the low-permeability matrix. The results of homogeneous coreflood tests showed that both secondary-waterflood and secondary-surfactant flood can achieve high oil recovery (>50%) from relatively homogenous cores. A shut-in phase after the surfactant injection resulted in an additional oil recovery, which suggests enough time should be allowed while using surfactants for wettability alteration. The core with a higher extent of heterogeneity produced lower oil recovery to waterflood in the coreflood tests. Final oil recovery from the matrix depends on matrix permeability as well as the rock heterogeneity. The results of heterogeneous coreflood tests showed that a slow surfactant injection (dynamic imbibition) can significantly improve the oil recovery if the oil-wet reservoir is not well-swept.

The New Flow Control Devices Autonomously Controlling the Performance of Matrix Acid Stimulation Operations in Carbonate Reservoirs

2021 ◽  
Author(s):  
Mojtaba Moradi ◽  
Michael R Konopczynski
Keyword(s):  
Flow Control ◽  
Dynamic Change ◽  
Injection Rate ◽  
Control Flow ◽  
Carbonate Reservoir ◽  
Operating Conditions ◽  
Carbonate Reservoirs ◽  
High Permeability ◽  
The Impact ◽  
Stimulation Of

Abstract Matrix acidizing is a common but complex stimulation treatment that could significantly improve production/injection rate, particularly in carbonate reservoirs. However, the desired improvement in all zones of the well by such operation may not be achieved due to existing and/or developing reservoir heterogeneity. This paper describes how a new flow control device (FCD) previously used to control water injection in long horizontal wells can also be used to improve the conformance of acid stimulation in carbonate reservoirs. Acid stimulation of a carbonate reservoir is a positive feedback process. Acid preferentially takes the least resistant path, an area with higher permeability or low skin. Once acid reacts with the formation, the injectivity in that zone increases, resulting in further preferential injection in the stimulated zone. Over-treating a high permeability zone results in poor distribution of acid to low permeability zones. Mechanical, chemical or foam diversions have been used to improve stimulation conformance along the wellbore, however, they may fail in carbonate reservoirs with natural fractures where fracture injectivity dominates the stimulation process. A new FCD has been developed to autonomously control flow and provide mechanical diversion during matrix stimulation. Once a predefined upper limit flowrate is reached at a zone, the valve autonomously closes. This eliminates the impact of thief zone on acid injection conformance and maintains a prescribed acid distribution. Like other FCDs, this device is installed in several compartments in the wells. The device has two operating conditions, one, as a passive outflow control valve, and two, as a barrier when the flow rate through the valve exceeds a designed limit, analogous to an electrical circuit breaker. Once a zone has been sufficiently stimulated by the acid and the injection rate in that zone exceeds the device trip point, the device in that zone closes and restricts further stimulation. Acid can then flow to and stimulate other zones This process can be repeated later in well life to re-stimulate zones. This performance enables the operators to minimise the impacts of high permeability zones on the acid conformance and to autonomously react to a dynamic change in reservoirs properties, specifically the growth of wormholes. The device can be installed as part of lower completions in both injection and production wells. It can be retrofitted in existing completions or be used in a retrievable completion. This technology allows repeat stimulation of carbonate reservoirs, providing mechanical diversion without the need for coiled tubing or other complex intervention. This paper will briefly present an overview of the device performance, flow loop testing and some results from numerical modelling. The paper also discusses the completion design workflow in carbonates reservoirs.

Polymer Injection to Unlock Bypassed Oil in a Giant Carbonate Reservoir: Bridging the Gap Between Laboratory and Large Scale Polymer Project

2021 ◽  
Author(s):  
Clement Fabbri ◽  
Haitham Ali Al Saadi ◽  
Ke Wang ◽  
Flavien Maire ◽  
Carolina Romero ◽  
...  
Keyword(s):  
High Salinity ◽  
Water Injection ◽  
Cross Flow ◽  
Carbonate Reservoir ◽  
Carbonate Reservoirs ◽  
Laboratory Work ◽  
High Permeability ◽  
Polymer Injection ◽  
Single Well ◽  
Pilot Design

Abstract Polymer flooding has long been proposed to improve sweep efficiency in heterogeneous reservoirs where polymer enhances cross flow between layers and forces water into the low permeability layers, leading to more homogeneous saturation profile. Although this approach could unlock large volumes of by-passed oil in layered carbonate reservoirs, compatibility of polymer solutions with high salinity - high temperature carbonate reservoirs has been hindering polymer injection projects in such harsh conditions. The aim of this paper is to present the laboratory work, polymer injection field test results and pilot design aimed to unlock target tertiary oil recovery in a highly heterogeneous mixed to oil-wet giant carbonate reservoir. This paper focuses on a highly layered limestone reservoir with various levels of cyclicity in properties. This reservoir may be divided in two main bodies, i.e., an Upper zone and a Lower zone with permeability contrast of up to two orders of magnitude. The main part of the reservoir is currently under peripheral and mid-flank water injection. Field observations show that injected water tends to channel quickly through the Upper zone along the high permeability layers and bypass the oil in the Lower zone. Past studies have indicated that this water override phenomenon is caused by a combination of high permeability contrast and capillary forces which counteract gravity forces. In this setting, adequate polymer injection strategy to enhance cross-flow between these zones is investigated, building on laboratory and polymer injection test field results. A key prerequisite for defining such EOR development scenario is to have representative static and dynamic models that captures the geological heterogeneity of this kind of reservoirs. This is achieved by an improved and integrated reservoir characterization, modelling and water injection history matching procedure. The history matched model was used to investigate different polymer injection schemes and resulted in an optimum pilot design. The injection scheme is defined based on dynamic simulations to maximize value, building on results from single-well polymer injection test, laboratory work and on previous published work, which have demonstrated the potential of polymer flooding for this reservoir. Our study evidences the positive impact of polymer propagation at field scale, improving the water-front stability, which is a function of pressure gradient near producer wells. Sensitivities to the position and number of polymer injectors have been performed to identify the best injection configuration, depending on the existing water injection scheme and the operating constraints. The pilot design proposed builds on laboratory work and field monitoring data gathered during single-well polymer injection field test. Together, these elements represent building blocks to enable tertiary polymer recovery in giant heterogeneous carbonate reservoirs with high temperature - high salinity conditions.

Low-IFT Foaming System for Enhanced Oil Recovery in Highly Heterogeneous/Fractured Oil-Wet Carbonate Reservoirs

SPE Journal ◽  
2018 ◽  
Vol 23 (06) ◽  
pp. 2243-2259 ◽  
Author(s):  
Pengfei Dong ◽  
Maura Puerto ◽  
Guoqing Jian ◽  
Kun Ma ◽  
Khalid Mateen ◽  
...  
Keyword(s):  
Oil Recovery ◽  
Fractured Reservoirs ◽  
Surfactant Solution ◽  
Capillary Forces ◽  
Mobility Control ◽  
Carbonate Reservoirs ◽  
Residual Oil ◽  
High Permeability ◽  
The Matrix ◽  
Foam Flooding

Summary Oil recovery in heterogeneous carbonate reservoirs is typically inefficient because of the presence of high-permeability fracture networks and unfavorable capillary forces within the oil-wet matrix. Foam, as a mobility-control agent, has been proposed to mitigate the effect of reservoir heterogeneity by diverting injected fluids from the high-permeability fractured zones into the low-permeability unswept rock matrix, hence improving the sweep efficiency. This paper describes the use of a low-interfacial-tension (low-IFT) foaming formulation to improve oil recovery in highly heterogeneous/fractured oil-wet carbonate reservoirs. This formulation provides both mobility control and oil/water IFT reduction to overcome the unfavorable capillary forces preventing invading fluids from entering an oil-filled matrix. Thus, as expected, the combination of mobility control and low-IFT significantly improves oil recovery compared with either foam or surfactant flooding. A three-component surfactant formulation was tailored using phase-behavior tests with seawater and crude oil from a targeted reservoir. The optimized formulation simultaneously can generate IFT of 10−2 mN/m and strong foam in porous media when oil is present. Foam flooding was investigated in a representative fractured core system, in which a well-defined fracture was created by splitting the core lengthwise and precisely controlling the fracture aperture by applying a specific confining pressure. The foam-flooding experiments reveal that, in an oil-wet fractured Edward Brown dolomite, our low-IFT foaming formulation recovers approximately 72% original oil in place (OOIP), whereas waterflooding recovers only less than 2% OOIP; moreover, the residual oil saturation in the matrix was lowered by more than 20% compared with a foaming formulation lacking a low-IFT property. Coreflood results also indicate that the low-IFT foam diverts primarily the aqueous surfactant solution into the matrix because of (1) mobility reduction caused by foam in the fracture, (2) significantly lower capillary entry pressure for surfactant solution compared with gas, and (3) increasing the water relative permeability in the matrix by decreasing the residual oil. The selective diversion effect of this low-IFT foaming system effectively recovers the trapped oil, which cannot be recovered with single surfactant or high-IFT foaming formulations applied to highly heterogeneous or fractured reservoirs.

Study on the Nonlinear Flow Percolation Law in Low Permeability Carbonate Reservoir of HF Oilfield

2014 ◽  
Vol 644-650 ◽  
pp. 5065-5070
Author(s):  
Shuai Jiang ◽  
Zheng Ming Yang ◽  
Xue Wei Liu ◽  
Meng Ting Wang ◽  
Qian Zhang
Keyword(s):  
Oil Industry ◽  
Carbonate Reservoir ◽  
Oil Field ◽  
Carbonate Reservoirs ◽  
Nonlinear Flow ◽  
Low Permeability ◽  
High Permeability ◽  
Threshold Pressure Gradient ◽  
Flow Situation ◽  
Low Permeability Reservoirs

With the development of the global oil industry,the production of the normal or high permeability reservoirs decline rapidly. Therefore, more and more low permeability reservoirs are used to the production stimulation. The oilfields overseas make great contribution to CNPC. The HF oilfield is one oilfield that the CNPC have in overseas. The HF oilfield is mainly the low permeability carbonate reservoirs which make it not easy to economically exploit. Due to the reason that the low permeability carbonate reservoirs present small porosity and the fluid’s flow situation in the low permeability carbonate reservoirs, the flow doesn't obey the Darcy's law. Thus it is greatly necessary to study the non-Darcy percolation characteristics. In this paper, the HF ‘s low permeability is tested and the threshold pressure gradient test is finished ,according to the experiment results, the nonlinear percolation ‘s law ,which is suited to HF-oil field , is illustrated and the reservoir classification is achieved.

High-permeability zones in folded and faulted silicified carbonate rocks – Implications for karstified carbonate reservoirs

2021 ◽  
Vol 128 ◽  
pp. 105046
Author(s):  
Vincenzo La Bruna ◽  
Francisco H.R. Bezerra ◽  
Victor H.P. Souza ◽  
Rubson P. Maia ◽  
Augusto S. Auler ◽  
...  
Keyword(s):  
Carbonate Rocks ◽  
Carbonate Reservoirs ◽  
High Permeability

High Permeability Streaks Characterisations in Middle East Carbonate Reservoirs

2009 ◽  
Author(s):  
P. Emmanuelle ◽  
C. Maza ◽  
A. Virgone ◽  
F. Gisquet ◽  
C. Fraisse ◽  
...  
Keyword(s):  
Middle East ◽  
Carbonate Reservoirs ◽  
High Permeability
Sign in / Sign up

Export Citation Format

Share Document