Sensitivity Analysis of Petrophysical Properties Spatial Distributions, and Flow Performance Forecasts to Geostatistical Parameters Using Derivative Coefficients

2002 ◽  
Author(s):  
Jorge L. Landa ◽  
Sebastien Strebelle
Keyword(s):  
Sensitivity Analysis ◽  
Spatial Distributions ◽  
Petrophysical Properties

Sensitivity analysis of data-related factors controlling AVA simultaneous inversion of partially stacked seismic amplitude data: Application to deepwater hydrocarbon reservoirs in the central Gulf of Mexico

Geophysics ◽  
2007 ◽  
Vol 72 (1) ◽  
pp. C19-C29 ◽  
Author(s):  
Arturo Contreras ◽  
Carlos Torres-Verdín ◽  
Tim Fasnacht
Keyword(s):  
Sensitivity Analysis ◽  
Gulf Of Mexico ◽  
P Wave ◽  
Spatial Distributions ◽  
Vertical Resolution ◽  
Elastic Parameters ◽  
Related Factors ◽  
Seismic Amplitude ◽  
Amplitude Data ◽  
Seismic Amplitudes

We consider the inversion of synthetic and recorded seismic amplitude variation with angle AVA data to appraise the influence of several data-related factors that control the vertical resolution and accuracy of the estimated spatial distributions of elastic properties. We use measurements acquired in deepwater hydrocarbon reservoirs in the central Gulf of Mexico to generate synthetic seismic amplitude data and evaluate inversion results with both synthetic and recorded seismic amplitudes. Detailed sensitivity analysis of synthetic amplitude data indicates that, even in the most ideal scenario (perfectly migrated data, isotropic media, noise-free seismic amplitude data, sufficient far-angle coverage, and accurate estimates of angle-dependent wavelets and low-frequency components), input elastic models are not reconstructedaccurately by the inversion of synthetic seismic amplitudes. We attribute this result to the relatively low vertical resolution of the seismic amplitude data. P-wave impedance is the most accurate of the inverted properties, followed by S-impedance and bulk density. Additionally, sufficient far-angle coverage is crucial for the accurate estimation of 1D distributions of S-impedance and bulk density. We show that time alignment of partial-angle stacks for correcting residual NMO effects improves the vertical resolution of the estimated spatial distributions of elastic parameters and consistently decreases the data misfit. Finally, we found that the accuracy of the inverted distributions of elastic parameters is improved substantially by (1) increasing the preserved AVA information via multiple single-angle stacks, (2) correcting the P-wave velocity field used for calculating angles in partial-angle stacking, and (3) excluding far-angle data with low signal-to-noise ratios.

Reaction couples of ceramic thin films prepared by CVD

1988 ◽  
Vol 46 ◽  
pp. 798-799
Author(s):  
D.W. Susnitzky ◽  
S.R. Summerfelt ◽  
C.B. Carter
Keyword(s):  
Thin Film ◽  
Vapor Deposition ◽  
Chemical Vapor ◽  
Deposition Process ◽  
Solid State Reactions ◽  
Spatial Distributions ◽  
Diffusion Couples ◽  
Kinetics Studies ◽  
Ceramic Thin Films ◽  
Initial Stage

Solid-state reactions have traditionally been studied in the form of diffusion couples. This ‘bulk’ approach has been modified, for the specific case of the reaction between NiO and Al2O3, by growing NiAl2O4 (spinel) from electron-transparent Al2O3 TEM foils which had been exposed to NiO vapor at 1415°C. This latter ‘thin-film’ approach has been used to characterize the initial stage of spinel formation and to produce clean phase boundaries since further TEM preparation is not required after the reaction is completed. The present study demonstrates that chemical-vapor deposition (CVD) can be used to deposit NiO particles, with controlled size and spatial distributions, onto Al2O3 TEM specimens. Chemical reactions do not occur during the deposition process, since CVD is a relatively low-temperature technique, and thus the NiO-Al2O3 interface can be characterized. Moreover, a series of annealing treatments can be performed on the same sample which allows both Ni0-NiAl2O4 and NiAl2O4-Al2O3 interfaces to be characterized and which therefore makes this technique amenable to kinetics studies of thin-film reactions.

Application of high-resolution field-emission LVSEM, backscatter imaging, immunogold staining to definition of the spatial distributions of two human neutrophil adherence receptors

1993 ◽  
Vol 51 ◽  
pp. 36-37
Author(s):  
Robert D. Nelson ◽  
Sharon R. Hasslen ◽  
Stanley L. Erlandsen
Keyword(s):  
Cell Surface ◽  
Surface Membrane ◽  
Three Dimensional ◽  
Human Neutrophils ◽  
Spatial Distributions ◽  
Immunogold Staining ◽  
Functional Control ◽  
Neutrophil Adherence ◽  
Definition Of ◽  
Mode Of Attachment

Receptors are commonly defined in terms of number per cell, affinity for ligand, chemical structure, mode of attachment to the cell surface, and mechanism of signal transduction. We propose to show that knowledge of spatial distribution of receptors on the cell surface can provide additional clues to their function and components of functional control.L-selectin and Mac-1 denote two receptor populations on the neutrophil surface that mediate neutrophil-endothelial cell adherence interactions and provide for targeting of neutrophil recruitment to sites of inflammation. We have studied the spatial distributions of these receptors using LVSEM and backscatter imaging of isolated human neutrophils stained with mouse anti-receptor (primary) antibody and goat anti-mouse (secondary) antibody conjugated to 12 nm colloidal gold. This combination of techniques provides for three-dimensional analysis of the expression of these receptors on different surface membrane domains of the neutrophil: the ruffles and microvilli that project from the cell surface, and the cell body between these projecting structures.

Sign in / Sign up

Export Citation Format

Share Document