Retardation Of Water Coning In Oil Wells Using Polymers - A Reservoir Simulation Application

1974 ◽  
Author(s):  
G.C. Thakur ◽  
A.R. Tachuk
Keyword(s):  
Reservoir Simulation ◽  
Oil Wells ◽  
Water Coning

Rich-Gas Condensate Huff and Puff Process in High-Volume, Watered-Out, and Highly Viscous Heavy Oil Wells, Case Study in Iraq

2021 ◽  
Author(s):  
Xueqing Tang ◽  
Ruifeng Wang ◽  
Zhongliang Cheng ◽  
Hui Lu
Keyword(s):  
High Pressure ◽  
Heavy Oil ◽  
Oil Quality ◽  
Oil Wells ◽  
Gas Condensate ◽  
Oil Viscosity ◽  
Foamy Oil ◽  
Artificial Lift ◽  
Water Coning ◽  
The Dead

Abstract Halfaya field in Iraq contains multiple vertically stacked oil and gas accumulations. The major oil horizons at depth of over 10,000 ft are under primary development. The main technical challenges include downdip heavy oil wells (as low as 14.56 °API) became watered-out and ceased flow due to depleted formation pressure. Heavy crude, with surface viscosities of above 10,000 cp, was too viscous to lift inefficiently. The operator applied high-pressure rich-gas/condensate to re-pressurize the dead wells and resumed production. The technical highlights are below: Laboratory studies confirmed that after condensate (45-52ºAPI) mixed with heavy oil, blended oil viscosity can cut by up to 90%; foamy oil formed to ease its flow to the surface during huff-n-puff process.In-situ gas/condensate injection and gas/condensate-lift can be applied in oil wells penetrating both upper high-pressure rich-gas/condensate zones and lower oil zones. High-pressure gas/condensate injected the oil zone, soaked, and then oil flowed from the annulus to allow large-volume well stream flow with minimal pressure drop. Gas/condensate from upper zones can lift the well stream, without additional artificial lift installation.Injection pressure and gas/condensate rate were optimized through optimal perforation interval and shot density to develop more condensate, e.g. initial condensate rate of 1,000 BOPD, for dilution of heavy oil.For multilateral wells, with several drain holes placed toward the bottom of producing interval, operating under gravity drainage or water coning, if longer injection and soaking process (e.g., 2 to 4 weeks), is adopted to broaden the diluted zone in heavy oil horizon, then additional recovery under better gravity-stabilized vertical (downward) drive and limited water coning can be achieved. Field data illustrate that this process can revive the dead wells, well production achieved approximately 3,000 BOPD under flowing wellhead pressure of 800 to 900 psig, with oil gain of over 3-fold compared with previous oil rate; water cut reduction from 30% to zero; better blended oil quality handled to medium crude; and saving artificial-lift cost. This process may be widely applied in the similar hydrocarbon reservoirs as a cost-effective technology in Middle East.

A Superior Shale Oil EOR Method for the Permian Basin

2021 ◽  
Author(s):  
Robert Downey ◽  
Kiran Venepalli ◽  
Jim Erdle ◽  
Morgan Whitelock
Keyword(s):  
Oil Recovery ◽  
Reservoir Simulation ◽  
Simulation Modeling ◽  
Lower Cost ◽  
Oil Production ◽  
Oil Wells ◽  
Oil Well ◽  
Shale Oil ◽  
Permian Basin ◽  
Artificial Lift

Abstract The Permian Basin of west Texas is the largest and most prolific shale oil producing basin in the United States. Oil production from horizontal shale oil wells in the Permian Basin has grown from 5,000 BOPD in February, 2009 to 3.5 Million BOPD as of October, 2020, with 29,000 horizontal shale oil wells in production. The primary target for this horizontal shale oil development is the Wolfcamp shale. Oil production from these wells is characterized by high initial rates and steep declines. A few producers have begun testing EOR processes, specifically natural gas cyclic injection, or "Huff and Puff", with little information provided to date. Our objective is to introduce a novel EOR process that can greatly increase the production and recovery of oil from shale oil reservoirs, while reducing the cost per barrel of recovered oil. A superior shale oil EOR method is proposed that utilizes a triplex pump to inject a solvent liquid into the shale oil reservoir, and an efficient method to recover the injectant at the surface, for storage and reinjection. The process is designed and integrated during operation using compositional reservoir simulation in order to optimize oil recovery. Compositional simulation modeling of a Wolfcamp D horizontal producing oil well was conducted to obtain a history match on oil, gas, and water production. The matched model was then utilized to evaluate the shale oil EOR method under a variety of operating conditions. The modeling indicates that for this particular well, incremental oil production of 500% over primary EUR may be achieved in the first five years of EOR operation, and more than 700% over primary EUR after 10 years. The method, which is patented, has numerous advantages over cyclic gas injection, such as much greater oil recovery, much better economics/lower cost per barrel, lower risk of interwell communication, use of far less horsepower and fuel, shorter injection time, longer production time, smaller injection volumes, scalability, faster implementation, precludes the need for artificial lift, elimination of the need to buy and sell injectant during each cycle, ability to optimize each cycle by integration with compositional reservoir simulation modeling, and lower emissions. This superior shale oil EOR method has been modeled in the five major US shale oil plays, indicating large incremental oil recovery potential. The method is now being field tested to confirm reservoir simulation modeling projections. If implemented early in the life of a shale oil well, its application can slow the production decline rate, recover far more oil earlier and at lower cost, and extend the life of the well by several years, while precluding the need for artificial lift.

Segregated production method for oil wells with active water coning

1994 ◽  
Vol 11 (1) ◽  
pp. 21-35 ◽  
Author(s):  
Andrew K. Wojtanowicz ◽  
Hui Xu ◽  
Zaki Bassiouni
Keyword(s):  
Production Method ◽  
Oil Wells ◽  
Water Coning

Unleashing Full Production Potential of Mature-Water Coning Sensitive-Oil Field through Simple Reservoir Simulation and Artificial Lift Installation

2019 ◽  
Author(s):  
M. Arief Salman Alfarizi ◽  
Agus Aryanto ◽  
Tejo Sukotrihadiyono ◽  
Farid Ghozali ◽  
Dwi Hudya Febrianto ◽  
...  
Keyword(s):  
Reservoir Simulation ◽  
Oil Field ◽  
Production Potential ◽  
Artificial Lift ◽  
Water Coning ◽  
Full Production
Sign in / Sign up

Export Citation Format

Share Document