Multiphase Flowmeter Successfully Measures Three-Phase Flow at Extremely High Gas-Volume Fractions - Gulf of Suez, Egypt

1998 ◽  
Vol 13 (01) ◽  
pp. 41-46
Author(s):  
R.B. Leggett ◽  
D.C. Borling ◽  
B.S. Powers ◽  
Khalid Shehata ◽  
Martin Halvorsen ◽  
...  
Author(s):  
Florian Schmidt ◽  
Dieter Mewes ◽  
Marc Lo¨rcher

Twin-fluid atomizers are widely used for spray-drying application. The suspension to be dried can be atomized very efficiently if the atomizer is operated at critical conditions. The three-phase flow containing solids, gas and liquid is accelerated inside the atomizer due to a pressure gradient. If the upstream pressure is sufficiently high, a maximum possible mass flow rate is achieved. This operating condition is called “critical”. The velocity of the three-phase flow and the flow pattern in the exit cross section has a major impact on the jet break-up and thus on the spray characteristics. In this experimental work the flow velocity and flow pattern inside the nozzle of the atomizer is measured. A laser-sensor is used to determine the flow velocity via cross-correlation at different operating conditions and positions inside the nozzle. The same sensor is used to measure the flow pattern by analyzing the time dependent laser light absorption of of the flow. The influence of various compositions of the suspension concerning gas volume flow rate and particle concentration on the measured velocities and flow patterns are derived. Higher gas volume flow rates increase the velocities and higher particle concentration have a decreasing influence. For a pure gas-liquid flow the obtained results are in good agreement with a theoretical model. In the exit cross-section plug flow and annular flow is observed depending on the gas volume flow fraction. The particles in the suspension have no significant influence on the flow pattern.


Mathematics ◽  
2021 ◽  
Vol 9 (13) ◽  
pp. 1460
Author(s):  
Abdulaziz S. Alkabaa ◽  
Ehsan Nazemi ◽  
Osman Taylan ◽  
El Mostafa Kalmoun

To the best knowledge of the authors, in former studies in the field of measuring volume fraction of gas, oil, and water components in a three-phase flow using gamma radiation technique, the existence of a scale layer has not been considered. The formed scale layer usually has a higher density in comparison to the fluid flow inside the oil pipeline, which can lead to high photon attenuation and, consequently, reduce the measuring precision of three-phase flow meter. The purpose of this study is to present an intelligent gamma radiation-based, nondestructive technique with the ability to measure volume fraction of gas, oil, and water components in the annular regime of a three-phase flow independent of the scale layer. Since, in this problem, there are several unknown parameters, such as gas, oil, and water components with different amounts and densities and scale layers with different thicknesses, it is not possible to measure the volume fraction using a conventional gamma radiation system. In this study, a system including a 241Am-133Ba dual energy source and two transmission detectors was used. The first detector was located diametrically in front of the source. For the second detector, at first, a sensitivity investigation was conducted in order to find the optimum position. The four extracted signals in both detectors (counts under photo peaks of both detectors) were used as inputs of neural network, and volume fractions of gas and oil components were utilized as the outputs. Using the proposed intelligent technique, volume fraction of each component was predicted independent of the barium sulfate scale layer, with a maximum MAE error of 3.66%.


Author(s):  
Lifeng Zhang

The tomographic imaging of process parameters for oil-gas-water three-phase flow can be obtained through different sensing modalities, such as electrical resistance tomography (ERT) and electrical capacitance tomography (ECT), both of which are sensitive to specific properties of the objects to be imaged. However, it is hard to discriminate oil, gas and water phases merely from reconstructed images of ERT or ECT. In this paper, the feasibility of image fusion based on ERT and ECT reconstructed images was investigated for oil-gas-water three-phase flow. Two cases were discussed and pixel-based image fusion method was presented. Simulation results showed that the cross-sectional reconstruction images of oil-gas-water three-phase flow can be obtained using the presented methods.


Sign in / Sign up

Export Citation Format

Share Document