Successful Acid Stimulation in Limestone - Tobo-Monserrate Formation in Gigante Field - Colombia

2021 ◽  
Author(s):  
Zhenguo Zheng ◽  
Oscar Julian Jaramillo ◽  
Jhon Patiño ◽  
John Fredy Reina ◽  
Carlos Francisco Pacheco

Abstract This paper presents the successful stimulation workflow case for a carbonate acidizing pilot project performed in Gigante field in the Matambo block of the Upper Magdalena Valley basin in Colombia. An adecuate diagnostic, laboratory testing, treatment fluid selection, on-site QAQC and placement technique selection was fundamental to obtain a successful design and an optimized application. Gigante field production is mainly coming from Tetuan and Caballos units producing 32-degree API crude oil during several years. Specifically, in Gigante-2 ST well, oil production has declined until its commercial limit. During a candidate wells review, it was identified a previous acid stimulation treatment performed in Tobo-Monserrate formation in Gigante-1 with very poor results in oil production –short production time in natural flow– giving to this zone a low potential as oil producer and it was not considered as a primary target zone. The well was completed in its main target at Tetuan formation leaving Tobo-Monserrate behind an intermediate 7 in casing with no future expectatives to produce. After a reservoir evaluation of Tobo-Monserrate formation done in Gigante-2 ST well, it was selected as a candidate for an intermedia matrix stimulation job to evaluate the real potential of this formation in Matambo block. During this phase, reservoir samples were tested against different acid treatments in the laboratory. A gelled HCL based acid was selected based on their laboratory testing performance to delay acid reaction –improving acid penetration– and having fluid loss control to enhance reservoir coverage. The complete chemical formula was customized to match the oil-treatment compatibility. An organic solvents treatment was added to dissolve organic scale prior to the acidizing. Acid was deployed directly through a TCP string to optimatize the operational time and managing treatment rate according to the pressure behavior. During the acid pumping, a pressure drop is observed and treatment rate was increased to generate rate diversion. Gigante-2 ST well came in production at natural flow reaching 502 BOPD and 105 MSCFD evaluated after 35 days of the stimulation job proving and adding important hydrocarbon reserves from Tobo-Monserrate formation. A post job evaluation using a specialized chemical stimulation simulator shows a significant skin removal. Measured treatment pressure and rate were matched with the simulated parameters resulting in −3.24 of skin value post acid stimulation having a productivity improvement factor of 4.35 and an average wormhole penetration estimated from 60 to 75 in into the reservoir. A correct diagnostic, reservoir understanding, design, laboratory testing, execution and post job evaluation was the right route to obtain a successful stimulation job in operational terms and production results. This paper is intended as a guideline for stimulation jobs in future interventions where the exact reservoir mineralogy is unknown. It shows a step-by-step methodology, a customized acid formula and finally, stimulation results as well as recommendations and learned lessons.

2021 ◽  
Author(s):  
Valentina Zharko ◽  
Dmitriy Burdakov

Abstract The paper presents the results of a pilot project implementing WAG injection at the oilfield with carbonate reservoir, characterized by low efficiency of traditional waterflooding. The objective of the pilot project was to evaluate the efficiency of this enhanced oil recovery method for conditions of the specific oil field. For the initial introduction of WAG, an area of the reservoir with minimal potential risks has been identified. During the test injections of water and gas, production parameters were monitored, including the oil production rates of the reacting wells and the water and gas injection rates of injection wells, the change in the density and composition of the produced fluids. With first positive results, the pilot area of the reservoir was expanded. In accordance with the responses of the producing wells to the injection of displacing agents, the injection rates were adjusted, and the production intensified, with the aim of maximizing the effect of WAG. The results obtained in practice were reproduced in the simulation model sector in order to obtain a project curve characterizing an increase in oil recovery due to water-alternating gas injection. Practical results obtained during pilot testing of the technology show that the injection of gas and water alternately can reduce the water cut of the reacting wells and increase overall oil production, providing more efficient displacement compared to traditional waterflooding. The use of WAG after the waterflooding provides an increase in oil recovery and a decrease in residual oil saturation. The water cut of the produced liquid decreased from 98% to 80%, an increase in oil production rate of 100 tons/day was obtained. The increase in the oil recovery factor is estimated at approximately 7.5% at gas injection of 1.5 hydrocarbon pore volumes. Based on the received results, the displacement characteristic was constructed. Methods for monitoring the effectiveness of WAG have been determined, and studies are planned to be carried out when designing a full-scale WAG project at the field. This project is the first pilot project in Russia implementing WAG injection in a field with a carbonate reservoir. During the pilot project, the technical feasibility of implementing this EOR method was confirmed, as well as its efficiency in terms of increasing the oil recovery factor for the conditions of the carbonate reservoir of Eastern Siberia, characterized by high water cut and low values of oil displacement coefficients during waterflooding.


2011 ◽  
Vol 16 (1) ◽  
pp. 5646 ◽  
Author(s):  
Clarence D. Kreiter ◽  
Thomas Haugen ◽  
Timothy Leaven ◽  
Christopher Goerdt ◽  
Nancy Rosenthal ◽  
...  

2021 ◽  
Author(s):  
Fazeel Ahmad ◽  
Zohaib Channa ◽  
Fahad Al Hosni ◽  
Salman Farhan Nofal ◽  
Ziad Talat Libdi ◽  
...  

Abstract The paper discusses the pilot project in ADNOC Offshore to assess the Autonomous Inflow Control Device (AICD) technology as an effective solution for increasing oil production over the life of the field. High rate of water and gas production in horizontal wells is one of the key problems from the commencement of operation due to the high cost of produced water and gas treatment including several other factors. Early Gas breakthrough in wells can result in shut-in to conserve reservoir energy and to meet the set GOR guidelines. The pilot well was shut-in due to high GOR resulted from the gas breakthrough. A pilot project was implemented to evaluate the ability of autonomous inflow control technology to manage gas break through early in the life of the well spanned across horizontal wellbore. And also to balance the production influx profile across the entire lateral length and to compensate for the permeability variation and therefore the productivity of each zone. Each compartment in the pilot well was equipped with AICD Screens and Swell-able Packers across horizontal open hole wellbore to evaluate oil production and defer gas breakthrough. Some AICDs were equipped with treatment valve for the compartments that needed acid simulation to enhance the effectiveness of the zone. The selection factors for installing number of production valves in the pilot well per each AICD was based on reservoir and field data. Pre-modeling of the horizontal wellbore section with AICD was performed using commercial simulation software (NETool). After the first pilot was completed, a detailed technical analysis was conducted and based on the early production results from the pilot well showed that AICD completions effectively managed gas production by delaying the gas break through and restricting gas inflow from the reservoir with significant GOR reduction ±40% compared to baseline production performance data from the open hole without AICD thus increasing oil production. The pilot well performed positively to the AICD completion allowing to produce healthy oil and meeting the guidelines. The early production results are in line with NETool simulation modelling, thereby increasing assurance in the methods employed in designing the AICD completion for the well and candidate selection. This paper discusses the successful AICD completion installation and production operation in pilot well in ADNOC Offshore to manage GOR and produced the well with healthy oil under the set guidelines. This will enable to re-activate wells shut-in due to GOR constraint to help meeting the sustainable field production target.


Author(s):  
L. B. Sanborn

This paper describes the application of gas turbines to crude-oil production in a Venezuelan underwater reservoir. Decreasing pressure caused a gradual slowing down of the natural flow, and Creole Corporation was faced with the problem of either artificial lifting of the crude or curtailment of operations with several years of ample supply remaining untapped. This challenge was met successfully through repressurization of the wells by gas turbines. The design of these turbine facilities, their operation, and some of the problems involved are described. The author summarizes with a review of the performance of the gas turbines at their various locations.


Life ◽  
2021 ◽  
Vol 11 (11) ◽  
pp. 1158
Author(s):  
Arti Easwar ◽  
Alexa J. Siddon

Chronic myeloproliferative neoplasms (MPNs) are hematopoietic stem cell neoplasms with driver events including the BCR-ABL1 translocation leading to a diagnosis of chronic myeloid leukemia (CML), or somatic mutations in JAK2, CALR, or MPL resulting in Philadelphia-chromosome-negative MPNs with constitutive activation of the JAK-STAT signaling pathway. In the Philadelphia-chromosome-negative MPNs, modern sequencing panels have identified a vast molecular landscape including additional mutations in genes involved in splicing, signal transduction, DNA methylation, and chromatin modification such as ASXL1, SF3B1, SRSF2, and U2AF1. These additional mutations often influence prognosis in MPNs and therefore are increasingly important for risk stratification. This review focuses on the molecular alterations within the WHO classification of MPNs and laboratory testing used for diagnosis.


2020 ◽  
Vol 103 (3) ◽  
pp. 1339-1340 ◽  
Author(s):  
Stephen H. Waterman ◽  
Gabriela Paz-Bailey ◽  
Jose L. San Martin ◽  
Gamaliel Gutierrez ◽  
Luis G. Castellanos ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document