This article, written by JPT Technology Editor Chris Carpenter, contains highlights of paper SPE 203226, “First Multistage Fracturing of Horizontal Well Drilled in a Conventional Tight Carbonate Reservoir in an Onshore Field in the UAE: Challenges and Lessons Learned,” by Muhammad Aftab, SPE, Noor Talib, and Maad Subaihi, ADNOC, et al., prepared for the 2020 Abu Dhabi International Petroleum Exhibition and Conference, Abu Dhabi, held virtually 9–12 November. The paper has not been peer reviewed.
The reservoir upon which this case study is focused is a tight, low-permeability carbonate reservoir with thin layers. The objective of the field case was to increase and sustain productivity of a pilot well consisting of an openhole completion. The complete paper summarizes the design processes, selection criteria, challenges, and lessons learned during design and execution phases. The study may provide a potential approach for selecting the proper hydraulic fracturing method and technique in similar cases.
Introduction
Reservoir X is divided into six layers. Layers X-3 through X-6 have reasonable porosity development; valid pressure points exist in X-3 and X-6. Pumpout was performed while collecting samples from X-3 and X-6, followed by short buildups. Production-logging-tool measurement was performed and found two major oil-producing layers across X-3 (60% of total production) and X-6 (40% of total production). The remaining intervals of the perforation were almost inactive. Petrophyscial and testing results of vertical Well A resulted in a decision to drill a horizontal oil producer (Well B) through Layer X-3.
Well B was steered with a 2,220-ft horizontal length, out of which 1,930 ft was inside X-3 and 290 ft were above X-3 be-cause of a fault throw of 16 ft true vertical depth. The well was steered with a horizontal length of 2,080 ft in X-6. Well B was completed with a 3½-in. completion and horizontal section as an openhole.
Matrix stimulation using coiled tubing was performed with 15% hydrochloric acid in Well B. The well ceased to flow after 2 weeks of declining production.
Rapid pressure depletion was observed in Well B. Localized depletion around the wellbore was anticipated because of poor matrix/matrix connectivity. After comprehensive studies and risk assessments, the decision was made to recomplete Well B with a cemented fracturing string to perform hydraulic fracturing with the plug-and-perf technique. This technique will allow flexibility of stage count and stage spacing and a multi-cluster design to maximize the stimulated reservoir volume (SRV) along the upper, middle, and lower layers. In addition, the operator and service provider collaborated to enhance this design through a zero-overflush technique with diverting agents.
The complete paper provides a detailed discussion of the core measurement and 1D mechanical Earth model used in the hydraulic fracturing design.
Hydraulic Fracturing Design
The main challenge in fracturing Well B was to ensure that the fracture generated is contained within the reservoir. Well B is completed in two layers (X-3 and X-6). The bottom part of the well is in X-6 and close to another underlying reservoir (Fig. 1).