In Situ Heavy Oil Upgrading by Electric Enhanced Oil Recovery, Complex Carbonate Heavy Oil Field Case

2018 ◽  
Author(s):  
Kresimir Keglevic
Keyword(s):  
Enhanced Oil Recovery ◽  
Oil Recovery ◽  
Heavy Oil ◽  
Oil Field ◽  
Field Case ◽  
Heavy Oil Upgrading

Improving heavy oil oxidation performance by oil-dispersed CoFe2O4 nanoparticles in In-situ combustion process for enhanced oil recovery

Fuel ◽  
2021 ◽  
Vol 285 ◽  
pp. 119216
Author(s):  
Seyedsaeed Mehrabi-Kalajahi ◽  
Mikhail A. Varfolomeev ◽  
Chengdong Yuan ◽  
Almaz L. Zinnatullin ◽  
Nikolay O. Rodionov ◽  
...  
Keyword(s):  
Enhanced Oil Recovery ◽  
Oil Recovery ◽  
Heavy Oil ◽  
Combustion Process ◽  
Oil Oxidation ◽  
Cofe2o4 Nanoparticles ◽  
In Situ Combustion ◽  
Oxidation Performance

Research on Efficient Microbial Enhanced Oil Recovery Technology Based on Low-Temperature Heavy Oil

2013 ◽  
Vol 734-737 ◽  
pp. 1434-1439 ◽  
Author(s):  
Gang Wu ◽  
Fu Ping Ren ◽  
Jing You ◽  
Ji Liang Yu ◽  
Ya Tuo Pei ◽  
...  
Keyword(s):  
Low Temperature ◽  
Enhanced Oil Recovery ◽  
Oil Recovery ◽  
Heavy Oil ◽  
Average Concentration ◽  
Oil Field ◽  
Oil Reservoir ◽  
Oil Degradation ◽  
Microbial Enhanced Oil Recovery ◽  
Well Pattern

Based on the low-temperature and heavy oil reservoir of conventional injection well pattern separated two strains of oil degradation bacteria LC and JH which had satisfactory compatibleness with BaoLige oill field. In order to study the feasibility of enhancing oil recovery rate of the two strains, the experiment of huff and puff with 15 wells were carried out. The average concentration of bacteria increase from 4.7×102cells/ml to 8.1×106cells/ml. The average reduction of surface tension and viscosity is 33.1% and 31.9%. The accumulative total was 1163.2t. The ratio of input to output was 1:2.12. Microbial enhanced oil recovery can improve the low-temperature and heavy oil production status, which provide a effective method for the similar oil field.

scholarly journals Half a century of continuous oil production by in-situ combustion in Romania – case study Suplacu de Barcau field

2021 ◽  
Vol 343 ◽  
pp. 09009
Author(s):  
Gheorghe Branoiu ◽  
Florinel Dinu ◽  
Maria Stoicescu ◽  
Iuliana Ghetiu ◽  
Doru Stoianovici
Keyword(s):  
Oil Recovery ◽  
Heavy Oil ◽  
Oil Production ◽  
Oil Field ◽  
Oil Reservoir ◽  
In Situ Combustion ◽  
Cyclic Steam Stimulation ◽  
The Impact ◽  
Steam Stimulation

Thermal oil recovery is a special technique belonging to Enhanced Oil Recovery (EOR) methods and includes steam flooding, cyclic steam stimulation, and in-situ combustion (fire flooding) applied especially in the heavy oil reservoirs. Starting 1970 in-situ combustion (ISC) process has been successfully applied continuously in the Suplacu de Barcau oil field, currently this one representing the most important reservoir operated by ISC in the world. Suplacu de Barcau field is a shallow clastic Pliocene, heavy oil reservoir, located in the North-Western Romania and geologically belonging to Eastern Pannonian Basin. The ISC process are operated using a linear combustion front propagated downstructure. The maximum oil production was recorded in 1985 when the total air injection rate has reached maximum values. Cyclic steam stimulation has been continuously applied as support for the ISC process and it had a significant contribution in the oil production rates. Nowadays the oil recovery factor it’s over 55 percent but significant potential has left. In the paper are presented the important moments in the life-time production of the oil field, such as production history, monitoring of the combustion process, technical challenges and their solving solutions, and scientific achievements revealed by many studies performed on the impact of the ISC process in the oil reservoir.

Effects of Steam on Heavy Oil Combustion

2009 ◽  
Vol 12 (04) ◽  
pp. 508-517 ◽  
Author(s):  
Alexandre Lapene ◽  
Louis Castanier ◽  
Gerald Debenest ◽  
Michel Yves Quintard ◽  
Arjan Matheus Kamp ◽  
...  
Keyword(s):  
Crude Oil ◽  
Enhanced Oil Recovery ◽  
Oil Recovery ◽  
Heavy Oil ◽  
Combustion Front ◽  
Oil Viscosity ◽  
In Situ Combustion ◽  
Temperature Oxidation ◽  
Recovery Method

Summary In-Situ Combustion. In-situ combustion (ISC) is an enhanced oil-recovery method. Enhanced oil recovery is broadly described as a group of techniques used to extract crude oil from the subsurface by the injection of substances not originally present in the reservoir with or without the introduction of extraneous energy (Lake 1996). During ISC, a combustion front is propagated through the reservoir by injected air. The heat generated results in higher temperatures leading to a reduction in oil viscosity and an increase of oil mobility. There are two types of ISC processes, dry and wet combustion. In the dry-combustion process, a large part of the heat generated is left unused downstream of the combustion front in the burned-out region. During the wet-injection process, water is co-injected with the air to recover some of the heat remaining behind the combustion zone. ISC is a very complex process. From a physical point of view, it is a problem coupling transport in porous media, chemistry, and thermodynamics. It has been studied for several decades, and the technique has been applied in the field since the 1950s. The complexity was not well understood earlier by ISC operators. This resulted in a high rate of project failures in the 1960s, and contributed to the misconception that ISC is a problem-prone process with low probability of success. However, ISC is an attractive oil-recovery process and capable of recovering a high percentage of oil-in-place, if the process is designed correctly and implemented in the right type of reservoir (Sarathi 1999). This paper investigates the effect of water on the reaction kinetics of a heavy oil by way of ramped temperature oxidation under various conditions. Reactions. Earlier studies about reaction kinetic were conducted by Bousaid and Ramey (1968), Weijdema (1968), Dabbous and Fulton (1974), and Thomas et al. (1979). In these experiments, temperature of a sample of crude oil and solid matrix was increased over time or kept constant. The produced gas was analyzed to determine the concentrations of outlet gases, such as carbon dioxide, carbon monoxide, and oxygen. This kind of studies shows two types of oxidation reactions, the Low-Temperature Oxidation (LTO) and the High-Temperature Oxidation (HTO) (Burger and Sahuquet 1973; Fassihi et al. 1984a; Mamora et al. 1993). In 1984, Fassihi et al. (1984b) presented an analytical method to obtain kinetics parameters. His method requires several assumptions.

Estimation of the Combustion Temperature Profile in a Romanian Oil Field

2018 ◽  
Vol 69 (10) ◽  
pp. 2669-2676
Author(s):  
Gheorghe Branoiu ◽  
Tudora Cristescu ◽  
Iulian Nistor
Keyword(s):  
Crude Oil ◽  
Oil Recovery ◽  
Heavy Oil ◽  
Thermal Regime ◽  
Oil Field ◽  
In Situ Combustion ◽  
Wide Range ◽  
Heavy Crude ◽  
Thermal Oil

Developing and producing of the heavy crude oil involved significant economic and technological challenges. The oil industry ability to prospect and capitalize the huge world heavy oil resources both economically and environmentally friendly will be crucial in helping meet future energy needs. Thermal oil recovery is one of the three types of techniques belonging to Enhanced Oil Recovery. It is applied for increasing the cumulative of crude oil that can be produced in an oil field. One of the oldest thermal oil recovery is in-situ combustion or fireflooding applied for the first time about 100 years ago. Despite in-situ combustion has not found widespread acceptance among operators like other thermal processes (such as steam injection), analysis of the successful projects indicates that the process is applicable to a wide range of oil reservoirs, especially to heavy crude oils. An important monitoring parameter of thermal oil recovery process is represented by thermal regime especially in heavy oil fields in which a high-temperature regime must be occur as the in-situ combustion to be successful. In the paper the authors are using thermal analysis (thermogravimetric and thermodifferential analysis) for investigation of the thermal regime involved in the production process of an oil reservoir by in-situ combustion.

Sign in / Sign up

Export Citation Format

Share Document