Evaluation of Single Point Gas Lift System for a Deep Water Oil Field, India

2015 ◽  
Author(s):  
Simanta Hazarika ◽  
Niladri Sinha ◽  
Rajeev Bansal ◽  
Rajan Jayaram
Keyword(s):  
Deep Water ◽  
Single Point ◽  
Oil Field ◽  
Gas Lift

Evaluation of Abrasive Wear of Polymeric Materials Using Single-Pass Pendulum Scratching

2002 ◽  
Author(s):  
Marcelo Torres Piza Paes ◽  
Antonio Marcos Rego Motta ◽  
Lauro Lemos Lontra Filho ◽  
Juliano Ose´ias de Morais ◽  
Sine´sio Domingues Franco
Keyword(s):  
Deep Water ◽  
Wear Mechanisms ◽  
Degradation Mechanism ◽  
Single Point ◽  
Polymeric Materials ◽  
Scratch Resistance ◽  
Wear Behaviour ◽  
Sediment Layer ◽  
Materials Used ◽  
Energy Dissipated

Scratching abrasion due to rubbing against the sediment layer is an important degradation mechanism of flexible cable in deep water oil and natural gas exploitation. The present study was initiated to gain relevant data on the wear behaviour of some commercial materials used to externally protect these cables. So, Comparison tests were carried out using the single-point scratching technique, which consists of a sharp point mounted at the extremity of a pendulum. The energy dissipated during the scratching is used to evaluate the relative scratch resistance. The results showed, that the contact geometry strongly affects the specific scratching energy. Using SEM imaging, it was found, that these changes were related to the operating wear mechanisms. The observed wear mechanisms are also compared with those observed on some cables in deep water operations.

FPSO fuel consumption and hydrocarbon liquids recovery optimization over the lifetime of a deep-water oil field

Energy ◽  
2019 ◽  
Vol 181 ◽  
pp. 927-942 ◽  
Author(s):  
Ali Allahyarzadeh-Bidgoli ◽  
Daniel Jonas Dezan ◽  
Leandro Oliveira Salviano ◽  
Silvio de Oliveira Junior ◽  
Jurandir Itizo Yanagihara
Keyword(s):  
Fuel Consumption ◽  
Deep Water ◽  
Oil Field

Numerical Simulation of Gas Lift Optimization Using Artificial Intelligence for a Middle Eastern Oil Field

2021 ◽  
Author(s):  
Mohammed Ahmed Al-Janabi ◽  
Omar F. Al-Fatlawi ◽  
Dhifaf J. Sadiq ◽  
Haider Abdulmuhsin Mahmood ◽  
Mustafa Alaulddin Al-Juboori
Keyword(s):  
Genetic Algorithm ◽  
Sensitivity Analysis ◽  
Middle Eastern ◽  
Optimization Technique ◽  
Injection Rate ◽  
Oil Field ◽  
Oil Fields ◽  
Reservoir Pressure ◽  
Artificial Lift ◽  
Gas Lift

Abstract Artificial lift techniques are a highly effective solution to aid the deterioration of the production especially for mature oil fields, gas lift is one of the oldest and most applied artificial lift methods especially for large oil fields, the gas that is required for injection is quite scarce and expensive resource, optimally allocating the injection rate in each well is a high importance task and not easily applicable. Conventional methods faced some major problems in solving this problem in a network with large number of wells, multi-constrains, multi-objectives, and limited amount of gas. This paper focuses on utilizing the Genetic Algorithm (GA) as a gas lift optimization algorithm to tackle the challenging task of optimally allocating the gas lift injection rate through numerical modeling and simulation studies to maximize the oil production of a Middle Eastern oil field with 20 production wells with limited amount of gas to be injected. The key objective of this study is to assess the performance of the wells of the field after applying gas lift as an artificial lift method and applying the genetic algorithm as an optimization algorithm while comparing the results of the network to the case of artificially lifted wells by utilizing ESP pumps to the network and to have a more accurate view on the practicability of applying the gas lift optimization technique. The comparison is based on different measures and sensitivity studies, reservoir pressure, and water cut sensitivity analysis are applied to allow the assessment of the performance of the wells in the network throughout the life of the field. To have a full and insight view an economic study and comparison was applied in this study to estimate the benefits of applying the gas lift method and the GA optimization technique while comparing the results to the case of the ESP pumps and the case of naturally flowing wells. The gas lift technique proved to have the ability to enhance the production of the oil field and the optimization process showed quite an enhancement in the task of maximizing the oil production rate while using the same amount of gas to be injected in the each well, the sensitivity analysis showed that the gas lift method is comparable to the other artificial lift method and it have an upper hand in handling the reservoir pressure reduction, and economically CAPEX of the gas lift were calculated to be able to assess the time to reach a profitable income by comparing the results of OPEX of gas lift the technique showed a profitable income higher than the cases of naturally flowing wells and the ESP pumps lifted wells. Additionally, the paper illustrated the genetic algorithm (GA) optimization model in a way that allowed it to be followed as a guide for the task of optimizing the gas injection rate for a network with a large number of wells and limited amount of gas to be injected.

A Success Story in Managing and Optimising Gas Lift Wells in Matured Oil Field: Automated Workflows in Digital Fields as Enablers to Accelerate Opportunities Creation and Production Optimisation

2021 ◽  
Author(s):  
Amir Badzly M. Nazri ◽  
W. M. Anas W. Khairul Anuar ◽  
Lucas Ignatius Avianto Nasution ◽  
Hayati Turiman ◽  
Shar Kawi Hazim Shafie ◽  
...  
Keyword(s):  
Model Validation ◽  
Field Performance ◽  
Oil Field ◽  
Working Environment ◽  
Key Factors ◽  
Collaborative Working ◽  
Water Cut ◽  
Integrated Operations ◽  
Collaborative Working Environment ◽  
Gas Lift

Abstract Field S located in offshore Malaysia had been producing for more than 30 years with nearly 90% of current active strings dependent on gas lift assistance. Subsurface challenges encountered in this matured field such as management of increasing water-cut, sand production, and depleting reservoir pressure are one of key factors that drive the asset team to continuously monitor the performance of gaslifted wells to ensure better control of production thereby meeting target deliverability of the field. Hence, Gas Lift Optimization (GLOP) campaign was embarked in Field S to accelerate short term production with integration of Gas Lift Management Modules in Integrated Operations (IO). A workflow was created to navigate asset team in this campaign from performing gaslift health check, diagnostic and troubleshooting to data and model validation until execution prior to identification of GLOP candidates with facilitation from digital workflows. Digital Fields and Integrated Operations (IO) developed in Field S provided an efficient collaborative working environment to monitor field performance real time and optimize production continuously. Digital Fields comprises of multiple engineering workflows developed and operationalized to act as enablers for the asset team to quickly identify the low-hanging fruit opportunities. This paper will focus on entire cycle process of digital workflows with engineer's intervention in data hygiene and model validation, the challenges to implement GLOP, and results from the campaign in Field S.

The Emerald Field, Blocks 2/10a, 2/15a, 3/11b, UK North Sea

1991 ◽  
Vol 14 (1) ◽  
pp. 111-116 ◽  
Author(s):  
D. M. Stewart ◽  
A. J. G. Faulkner
Keyword(s):  
North Sea ◽  
Water Injection ◽  
Maximum Flow ◽  
Oil Field ◽  
Injection Wells ◽  
Initial Development ◽  
Flexible Risers ◽  
Northern North Sea ◽  
The Uk ◽  
Gas Lift

AbstractThe Emerald Oil Field lies in Blocks 2/10a, 2/15a and 3/1 lb in the UK sector of the northern North Sea. The field is located on the 'Transitional Shelf, an area on the western flank of the Viking Graben, downfaulted from the East Shetland Platform. The first well was drilled on the structure in 1978. Subsequently, a further seven wells have been drilled to delineate the field.The Emerald Field is an elongate dip and fault closed structure subparallel to the local NW-SE regional structural trend. the 'Emerald Sandstone' forms the main reservoir of the field and comprises a homogeneous transgressive unit of Callovian to Bathonian age, undelain by tilted Precambrian and Devonian Basement Horst blocks. Sealing is provided by siltstones and shales of the overlying Healther and Kimmeridge Clay Formations. The reservoir lies at depths between 5150-5600 ft, and wells drilled to date have encountered pay thicknesses of 42-74 ft. Where the sandstone is hydrocarbon bearing, it has a 100% net/ gross ratio. Porosities average 28% and permeabilities lie in the range 0-1 to 1.3 darcies. Wireline and test data indicate that the field contains a continouous oil column of 200 ft. Three distinct structural culminations exist on and adjacent to the field, which give rise to three separate gas caps, centred around wells 2/10a-4, 2/10a-7 and 2/10a-6 The maximum flow rate achieved from the reservoir to date is 6822 BOPD of 24° API oil with a GOR of 300 SCF/STBBL. In-place hydrocarbons are estimated to be 216 MMBBL of oil and 61 BCF of gas, with an estimated 43 MMBBL of oil recoverable by the initial development plan. initial development drilling began in Spring 1989 and the development scheme will use a floating production system. Production to the facility, via flexible risers, is from seven pre-drilled deviated wells with gas lift. An additional four pre-drilled water injection wells will provide reservoir pressure support.

Sign in / Sign up

Export Citation Format

Share Document