Exact Solution of Double-Porosity, Double-Permeability Systems Including Wellbore Storage and Skin Effect

Author(s):  
X. Liu ◽  
Z. Chen ◽  
L. Jiang
Water ◽  
2020 ◽  
Vol 12 (3) ◽  
pp. 744
Author(s):  
Daniel Kahuda ◽  
Pavel Pech

This study analyzes the unsteady groundwater flow to a real well (with wellbore storage and the skin effect) that fully penetrates the confined aquifer. The well is located within an infinite system, so the effect of boundaries is not considered. The Laplace-domain solution for a partial differential equation is used to describe the unsteady radial flow to a well. The real space solution is obtained by means of the numerical inversion of the Laplace transform using the Stehfest algorithm 368. When wellbore storage and the skin effect dominate pumping test data and testing is conducted for long enough, two semilogarithmic straight lines are normally obtained. The first straight line can be identified readily as the line of the maximum slope. The correlation of the dimensionless drawdown for the intersection time of this first straight line, with the log time axis as a function of the dimensionless wellbore storage and the skin factor, is shown. This paper presents a new method for evaluating the skin factor from the early portion of a pumping test. This method can be used to evaluate the skin factor when the well-known Cooper–Jacob semilogarithmic method cannot be used due to the second straight line not being achieved in the semilogarithmic graph drawdown vs. the log time. A field example is presented to evaluate the well rehabilitation in Veselí nad Lužnicí by means of the new correlation.


1970 ◽  
Vol 10 (03) ◽  
pp. 279-290 ◽  
Author(s):  
Ram G. Agarwal ◽  
Rafi Al-Hussainy ◽  
H.J. Ramey

Agarwal, Ram G., Pan American Petroleum Corp. Tulsa, Okla., Pan American Petroleum Corp. Tulsa, Okla., Al-Hussainy, Rafi, Junior Members AIME, Mobil Research and Development Corp., Dallas, Tex., Ramey Jr., H.J., Member AIME, Stanford U. Stanford, Calif. Abstract Due to the cost of extended pressure-drawdownor buildup well tests and the possibility of acquisitionof additional information from well tests, the moderntrend has been toward development of well-testanalysis methods pertinent for short-time data."Short-time" data may be defined as pressureinformation obtained prior to the usual straight-lineportion of a well test. For some time there has been portion of a well test. For some time there has been a general belief that the factors affecting short-timedata are too complex for meaningful interpretations. Among these factors are wellbore storage, variousskin effects such as perforations, partial penetration, fractures of various types, the effect of a finiteformation thickness, and non-Darcy flow. A numberof recent publications have dealt with short-timewell-test analysis. The purpose of this paper isto present a fundamental study of the importance ofwellbore storage with a skin effect to short-timetransient flow. Results indicate that properinterpretations of short-time well-test data can bemade under favorable circumstances. Upon starting a test, well pressures appearcontrolled by wellbore storage entirely, and datacannot be interpreted to yield formation flowcapacity or skin effect. Data can be interpreted toyield the wellbore storage constant, however. Afteran initial period, a transition from wellbore storagecontrol to the usual straight line takes place. Dataobtained during this period can be interpreted toobtain formation flow capacity and skin effect incertain cases. One important result is that thesteady-state skin effect concept is invalid at veryshort times. Another important result is that thetime required to reach the usual straight line isnormally not affected significantly by a finite skineffect. Introduction Many practical factors favor short-duration welltesting. These include loss of revenue during shut-in, costs involved in measuring drawdown or buildupdata for extended periods, and limited availabilityof bottomhole-pressure bombs where it is necessaryto survey large numbers of wells. on the other hand, reservoir engineers are well aware of the desirabilityof running long-duration tests. The result is usuallya compromise, and not necessarily a satisfactoryone. This situation is a common dilemma for thefield engineers who must specify the details of specialwell tests and annual surveys, and interpret theresults. For this reason, much effort has been givento the analysis of short-time tests. The term"short-time" is used herein to indicate eitherdrawdown or buildup tests run for a period of timeinsufficient to reach the usual straight-line portions. Drawdown data taken before the traditional straight-lineportion are ever used in analysis of oil or gas portion are ever used in analysis of oil or gas well performance. Well files often contain well-testdata that were abandoned when it was realized thatthe straight line had not been reached. This situationis particularly odd when it is realized that earlydata are used commonly in other technologies whichemploy similar, or analogous, transient test. It is the objective of this study to investigatetechniques which may be used to interpret informationobtained form well tests at times prior to the normalstraight-line period. THEORY The problem to be considered is the classic oneof flow of a slightly compressible (small pressuregradients) fluid in an ideal radial flow system. Thatis, flow is perfectly radial to a well of radius rwin an isotropic medium, and gravitational forces areneglected. We will consider that the medium isinfinite in extent, since interest is focused on timesshort enough for outer boundary effects not to befelt at the well. SPEJ p. 279


1970 ◽  
Vol 10 (03) ◽  
pp. 291-297 ◽  
Author(s):  
Robert A. Wattenbarger ◽  
H.J. Ramey

Abstract An investigation of the effect of wellbore storage and skin effect on transient flow was conducted using a finite-difference solution to the basic partial differential equation. The concept of skin partial differential equation. The concept of skin effect was generalized to include a composite annular region adjacent to the wellbore (a composite reservoir). The numerical solutions were compared with analytical solutions for cases with the usual steady-state skin effect. It was found that the solutions for a finite-capacity skin effect compared closely with analytical solutions at short times (wellbore storage controlled) and at long times after the usual straight line was reached. For intermediate times, presence of a unite-capacity skin effect caused significant departures from the infinitesimal skin solutions. Two straight lines occurred on the drawdown plot for cases of large radius of damage. The first had a slope characteristic of the flow, capacity of the damaged region; the second straight line had a slope characteristic of the flow capacity of the undamaged region. Results are presented both in tabular form and as log-log plots of dimensionless pressures vs dimensionless times. The log-log pressures vs dimensionless times. The log-log plot may be used in a type-curve matching plot may be used in a type-curve matching procedure to analyze short-time (before normal procedure to analyze short-time (before normal straight line) well-test data. Introduction Skin effect was defined by van Everdingen and Hurst as being an impediment to flow that is caused by an infinitesimally thin damaged region around the wellbore. The additional pressure drop through this skin is proportional to the wellbore flow rate and behaves as though flow through the skin were steady-state. Wellbore storage is caused by having a moving liquid level in a wellbore, or by simply having a volume of compressible fluid stored in the wellbore. When surface flow rates change abruptly, wellbore storage causes a time lag in formation flow rates and a corresponding damped pressure response. A recent study was made to determine the combined effects of infinitesimally thin skin and wellbore storage. Analytical methods were used along with numerical integration of a Laplace transformation inversion integral. Tabular and graphical results were presented for various cases. It was recognized during the study that this representation of skin was oversimplified; that skin effect should be thought of as a result of formation damage or improvement to a finite region adjacent to the wellbore. It was suggested that a skin effect could arise physical in a number of ways. One simple example physical in a number of ways. One simple example would be to assume that an annular volume adjacent to the wellbore is reduced uniformly to a lower permeability than the original value. This would be similar to the composite reservoir problem. Perhaps a better example would be to problem. Perhaps a better example would be to assume that the permeability increases continuously from a low value at the wellbore to a constant value in the undamaged reservoir. In either case, the damaged region would have a finite storage capacity and would lead to transient behavior within the skin region. A negative skin effect could arise from an increase in permeability within an annular region adjacent to the wellbore. This might physically result from acidizing. But it is believed that cases of more practical importance are those in which negative skin effects are caused by hydraulic fracturing. A high-permeability fracture communicating with the wellbore gives the appearance of a negative skin effect. For the purposes of this study, it was decided to represent a skin effect, either positive or negative as an annular region adjacent to the wellbore with either decreased or increased permeability. permeability. SPEJ P. 291


2017 ◽  
Vol 2 (3) ◽  
pp. 240-251
Author(s):  
Zheno Kareem Ahmed ◽  
Halkawt Ismail Ismail M-Amin

The aim of this paper is to discuss and evaluate the result of DST which was conducted in a limestone reservoir of an oil field at the depth interval 3764.29-3903.0 meter in well-1 to evaluate the dynamic characteristics of the reservoirs, for instance: skin effect, permeability, wellbore storage, reservoir boundary and average reservoir pressure. Reservoir Pressure profiles has been recorded for both Buildup and draw down intervals.  Semi-log and log-log coordinates have been used to plot the pressure signature date of both buildup period and its derivative to improve diagnostic and Horner plot. In addition, a dual porosity reservoir and infinite acting characteristic was discovered as a result of the well test data interpretation. Wellbore storage, skin factor and transient flow effects have been detected in the DST analysis on the dual porosity behavior due to phase re distribution.  Using final buildup sections, the flow parameters of dual porosity reservoir were determined as the flow between fissure and matrix was (7.558 x 10-6) while, the storability ratio between fissure and matrix was calculated as 0.3 and permeability is 102 MD for both matrix and the fissure together. However, negative value of skin factor mostly appears in double porosity limestone reservoirs, positive skin factor of the reservoir has been observed in this study. It can be considered that the positive skin factor can be resulted in either the formation was partially penetrated and /or wells were not cleaned up properly.


2019 ◽  
Vol 13 (1) ◽  
pp. 1
Author(s):  
Daniel Kahuda ◽  
Michal Kuraz ◽  
Jiri Holub ◽  
Pavel Pech ◽  
Petr Maca

1981 ◽  
Vol 21 (03) ◽  
pp. 354-362 ◽  
Author(s):  
Giovanni Da Prat ◽  
Heber Cinco-Ley ◽  
Henry Ramey

Abstract Constant producing pressure solutions that define declining production rates with time for a naturally fractured reservoir are presented. The solutions for the dimensionless flow rate are based on a model presented by Warren and Root. The model was extended to include constant producing pressure in both infinite and finite systems. The results obtained for a finite no-flow outer boundary are new and surprising. It was found that the flow rate shows a rapid decline initially, becomes nearly constant for a period, and then a final decline in rat,- takes place.A striking result of the present study is that ignoring the presence of a constant flow rate period in a type-curve match can lead to erroneous estimates of the dimensionless outer radius of a reservoir. An example is presented to illustrate the method of type-curve matching for a naturally fractured system. Introduction Naturally fractured reservoirs consist of heterogeneous porous media where the openings (fissures and fractures) vary considerably in size. Fractures and openings of large size form vugs and interconnected channel, whereas the tine cracks form block systems which are the main body of the reservoir (Fig. 1). The porous blocks store most of the fluid in the reservoir and are often of low permeability, whereas the fractures have a low storage capacity and high permeability. Most of the fluid flow will occur through the fissures with the blocks acting as fluid sources. Even though the volumetric average permeability in a naturally fractured system is low, such systems often exhibit an effective permeability that is higher than the block matrix permeability, and behave differently from ordinary homogeneous media. These systems have been studied extensively in the petroleum literature. One of the first such studies was published by Pirson in 1953. In 1959, Pollard presented one of the first pressure transient models available for interpretation of well test data from two-porosity systems. The most complete analysis of transient flow in two-porosity systems was presented in 1960 by Barenblatt and Zheltov. The Warren and Root study in 1963 is considered the forerunner of modern interpretation of two-porosity systems. Their paper has been the subject of study by many authors. The behavior of fractured systems has long been a topic of controversy Many authors have indicated that the graphical technique proposed by Pollard in 1959 is susceptible to error caused by approximations in the mathematical model. Nevertheless, the Pollard method still is used. The most complete study of two-porosity systems appears to be the Mavor and Cinco-Ley study in 1979. This study considers wellbore storage and skin effect, and also considers production, both at constant rate and at constant pressure. However, little information is presented concerning the effect of the size of the system on pressure buildup behavior.Although decline curve analysis is widely used, methods specific to two-porosity fractured systems do not appear to be available. It is the objective of this paper to produce and study decline curve analysis for a naturally fractured reservoir. The Warren and Root model was chosen as the basis for this work. Partial Differential Equations The basic partial differential equations for fluid flow in a two-porosity system were presented by Warren and Root in 1963. The model was extended by Mavor and Cinco-Ley to include wellbore storage and skin effect. SPEJ P. 354^


Sign in / Sign up

Export Citation Format

Share Document