Application of a Numerical Simulation Model for Work over Plans Assessment Prior Operations and Determination of Best Well Intervention Technique for Production Enhancement

2013 ◽  
Author(s):  
Yosra Yousef Abugren ◽  
Sameer Joshi ◽  
Marie V. Van Steene ◽  
Enas Thabet
Keyword(s):  
Numerical Simulation ◽  
Simulation Model ◽  
Intervention Technique

scholarly journals Mining-Induced Redistribution of the Abnormal Stress under the Close Bearing Coal Pillar for Entry Design

2021 ◽  
Vol 2021 ◽  
pp. 1-13
Author(s):  
Xudong Liu ◽  
Wenlong Shen ◽  
Jianbiao Bai ◽  
Rui Wang ◽  
Jizhong Kang ◽  
...  
Keyword(s):  
Numerical Simulation ◽  
Stress Concentration ◽  
Simulation Model ◽  
Lateral Pressure ◽  
Pressure Coefficient ◽  
Stress Gradient ◽  
Coal Pillar ◽  
Concentration Coefficient ◽  
Stress Concentration Coefficient

Underground space is vulnerable to large deformation influenced by the abnormal stress induced by the bearing coal pillar. A numerical simulation model was established to determine the redistribution of the abnormal stress induced by the mining activities. The double-yield model, the strain softening model, the interface model, and the Mohr–Coulomb model were determined to simulate the gob compaction effect, the pillar strength reduction effect, the structure plane discontinuity effect, and the rock mechanical behavior, respectively. This numerical simulation model is reliable to predict the abnormal stress under the bearing coal pillar by the comparison of the abutment stress from this model and the existing theoretical model as well as the entry roof surface displacement from this model and the field measuring method. The results from the validated numerical model indicate that the abnormal stress including stress concentration coefficient, stress gradient, and lateral pressure coefficient will redistribute to another state that the stress concentration coefficient and stress gradient increase gradually and then decrease, and the lateral pressure coefficient decreases gradually, then increases, and finally decreases sharply with the approach of the mining working face. Their maximum increasing rates are calculated as 121.05%, 198.56%, and 236.82%, respectively. This predicted mining-induced redistribution of the abnormal stress is available for designing the underground entry layout in the determination of the entry position, determination of the driving operation time, mining disturbing range warning, and the prediction of the strengthening support area.

Fundamental Examination of Numerical Simulation Model for Pressure Rise due to Underwater Arc

2014 ◽  
Vol 134 (7) ◽  
pp. 604-613 ◽  
Author(s):  
Toshiya Ohtaka ◽  
Tomo Tadokoro ◽  
Masashi Kotari ◽  
Tadashi Amakawa
Keyword(s):  
Numerical Simulation ◽  
Simulation Model ◽  
Pressure Rise

Evaluation of an improvement in runoff control by means of a construction of an infiltration sewer pipe under a porous asphalt pavement

1997 ◽  
Vol 36 (8-9) ◽  
pp. 397-402
Author(s):  
Yasuhiko Wada ◽  
Hiroyuki Miura ◽  
Rituo Tada ◽  
Yasuo Kodaka
Keyword(s):  
Numerical Simulation ◽  
Simulation Model ◽  
Asphalt Pavement ◽  
Considerable Effect ◽  
Rainfall Infiltration ◽  
Sewer Pipe ◽  
Porous Asphalt ◽  
Runoff Control

We examined the possibility of improved runoff control in a porous asphalt pavement by installing beneath it an infiltration pipe with a numerical simulation model that can simulate rainfall infiltration and runoff at the porous asphalt pavement. From the results of simulations about runoff and infiltration at the porous asphalt pavement, it became clear that putting a pipe under the porous asphalt pavement had considerable effect, especially during the latter part of the rainfall.

scholarly journals Study on the regional characteristics during foam flooding by population balance model

2020 ◽  
pp. 014459872098361
Author(s):  
Zhongbao Wu ◽  
Qingjun Du ◽  
Bei Wei ◽  
Jian Hou
Keyword(s):  
Numerical Simulation ◽  
Simulation Model ◽  
Oil Recovery ◽  
Population Balance ◽  
Growth Zone ◽  
Balance Model ◽  
Population Balance Model ◽  
Liquid Ratio ◽  
One Dimensional ◽  
Foam Flooding

Foam flooding is an effective method for enhancing oil recovery in high water-cut reservoirs and unconventional reservoirs. It is a dynamic process that includes foam generation and coalescence when foam flows through porous media. In this study, a foam flooding simulation model was established based on the population balance model. The stabilizing effect of the polymer and the coalescence characteristics when foam encounters oil were considered. The numerical simulation model was fitted and verified through a one-dimensional displacement experiment. The pressure difference across the sand pack in single foam flooding and polymer-enhanced foam flooding both agree well with the simulation results. Based on the numerical simulation, the foam distribution characteristics in different cases were studied. The results show that there are three zones during foam flooding: the foam growth zone, stable zone, and decay zone. These characteristics are mainly influenced by the adsorption of surfactant, the gas–liquid ratio, the injection rate, and the injection scheme. The oil recovery of polymer-enhanced foam flooding is estimated to be 5.85% more than that of single foam flooding. Moreover, the growth zone and decay zone in three dimensions are considerably wider than in the one-dimensional model. In addition, the slug volume influences the oil recovery the most in the foam enhanced foam flooding, followed by the oil viscosity and gas-liquid ratio. The established model can describe the dynamic change process of foam, and can thus track the foam distribution underground and aid in optimization of the injection strategies during foam flooding.

scholarly journals Optimal design of the solar tracking system of parabolic trough concentrating collectors

2020 ◽  
Vol 15 (4) ◽  
pp. 613-619
Author(s):  
Li Kong ◽  
Yunpeng Zhang ◽  
Zhijian Lin ◽  
Zhongzhu Qiu ◽  
Chunying Li ◽  
...  
Keyword(s):  
Numerical Simulation ◽  
Solar Radiation ◽  
Tracking System ◽  
Low Cost ◽  
Parabolic Trough ◽  
The North ◽  
Tracking Mode ◽  
Solar Tracking ◽  
East West

Abstract The present work aimed to select the optimum solar tracking mode for parabolic trough concentrating collectors using numerical simulation. The current work involved: (1) the calculation of daily solar radiation on the Earth’s surface, (2) the comparison of annual direct solar radiation received under different tracking modes and (3) the determination of optimum tilt angle for the north-south tilt tracking mode. It was found that the order of solar radiation received in Shanghai under the available tracking modes was: dual-axis tracking > north-south Earth’s axis tracking > north-south tilt tracking (β = 15°) > north-south tilt tracking (β = 45) > north-south horizontal tracking > east-west horizontal tracking. Single-axis solar tracking modes feature simple structures and low cost. This study also found that the solar radiation received under the north-south tilt tracking mode was higher than that of the north-south Earth’s axis tracking mode in 7 out of 12 months. Therefore, the north-south tilt tracking mode was studied separately to determine the corresponding optimum tilt angles in Haikou, Lhasa, Shanghai, Beijing and Hohhot, respectively, which were shown as follows: 18.81°, 27.29°, 28.67°, 36.21° and 37.97°.

scholarly journals Numerical Simulation Model for Granulation Kinetics of Iron Ores

2005 ◽  
Vol 45 (4) ◽  
pp. 500-505 ◽  
Author(s):  
Junya KANO ◽  
Eiki KASAI ◽  
Fumio SAITO ◽  
Takazo KAWAGUCHI
Keyword(s):  
Numerical Simulation ◽  
Simulation Model ◽  
Iron Ores ◽  
Kinetics Of
Sign in / Sign up

Export Citation Format

Share Document