Analytical Model to Estimate the Drag Forces for Microhole Coiled Tubing Drilling

2013 ◽  
Author(s):  
Yuan Zhang ◽  
Ye Hao ◽  
Robello Samuel
Keyword(s):  
Analytical Model ◽  
Coiled Tubing ◽  
Drag Forces

Analytical Model to Estimate the Drag Forces for Microhole Coiled Tubing Drilling

2013 ◽  
Vol 135 (3) ◽  
Author(s):  
Yuan Zhang ◽  
Ye Hao ◽  
Robello Samuel
Keyword(s):  
Analytical Model ◽  
New Technology ◽  
Drilling Process ◽  
Fluid Viscosity ◽  
Coiled Tubing ◽  
Drag Forces ◽  
Drag Models ◽  
Improved Model ◽  
Horizontal Portion ◽  
Surface Loads

Microhole coiled tubing drilling is a new technology that provides many added advantages but at the same time poses numerous operational challenges. This manifests itself in a number of ways, all of which adversely affect the efficiency of the drilling process. These problems include increased wellbore friction, poor hole-cleaning, tubular failures, and associated problems during tripping operations. Presently conventional torque and drag models are used to calculate drag forces and surface loads during microhole coiled tubing drilling. However, these estimates might be under conservative. Therefore, an improved model and more comprehensive analysis are required. Conditions expected during microhole coiled tubing drilling are completely different from those encountered during conventional drilling. Further complexity is added when the wellbore is undulated. This paper describes a new analytical model for estimating drag forces by assuming that pipe in the horizontal portion follows a sine function wave due to residual bends and snubbing force. In addition, the model takes into account when the wellbore is also tortuous. Fluid viscosity (an important force in the microhole) is also included so we can calculate appropriate surface loads in addition to drag. This study concludes that besides wellbore inclination, curvature, and wellbore torsion, parameters such as wavelength and contact area also influence the results. This paper documents the comparison between the predicted mathematical simulation results with actual data from wells describing the accuracy and applicability of the model. The analysis results and comparison are presented along with three examples (Zhang et al., 2013, “Analytical Model to Estimate the Drag Forces for Microhole Coiled Tubing Drilling,” Society of Petroleum Engineers, Paper No. SPE 163480.).

Modeling Coiled Tubing Drag Forces - Small Factors Have a Big Impact

2004 ◽  
Author(s):  
A.R. Terry ◽  
Mahesh. Mahajan ◽  
Lance Portman
Keyword(s):  
Coiled Tubing ◽  
Drag Forces

The E-ring: interactions with plasma and implications for its evolution

1984 ◽  
Vol 75 ◽  
pp. 599-602
Author(s):  
T.V. Johnson ◽  
G.E. Morfill ◽  
E. Grun
Keyword(s):  
Time Scale ◽  
Particle Density ◽  
High Energy ◽  
Particle Removal ◽  
Density Region ◽  
Drag Forces ◽  
Orbit Evolution ◽  
History Of ◽  
Ring Particle ◽  
Ring Material

A number of lines of evidence suggest that the particles making up the E-ring are small, on the order of a few microns or less in size (Terrile and Tokunaga, 1980, BAAS; Pang et al., 1982 Saturn meeting; Tucson, AZ). This suggests that a variety of electromagnetic and plasma affects may be important in considering the history of such particles. We have shown (Morfill et al., 1982, J. Geophys. Res., in press) that plasma drags forces from the corotating plasma will rapidly evolve E-ring particle orbits to increasing distance from Saturn until a point is reached where radiation drag forces acting to decrease orbital radius balance this outward acceleration. This occurs at approximately Rhea's orbit, although the exact value is subject to many uncertainties. The time scale for plasma drag to move particles from Enceladus' orbit to the outer E-ring is ~104yr. A variety of effects also act to remove particles, primarily sputtering by both high energy charged particles (Cheng et al., 1982, J. Geophys. Res., in press) and corotating plasma (Morfill et al., 1982). The time scale for sputtering away one micron particles is also short, 102 - 10 yrs. Thus the detailed particle density profile in the E-ring is set by a competition between orbit evolution and particle removal. The high density region near Enceladus' orbit may result from the sputtering yeild of corotating ions being less than unity at this radius (e.g. Eviatar et al., 1982, Saturn meeting). In any case, an active source of E-ring material is required if the feature is not very ephemeral - Enceladus itself, with its geologically recent surface, appears still to be the best candidate for the ultimate source of E-ring material.

Saturn's E, G and F rings: modulated by the plasma sheet

1984 ◽  
Vol 75 ◽  
pp. 597
Author(s):  
E. Grün ◽  
G.E. Morfill ◽  
T.V. Johnson ◽  
G.H. Schwehm
Keyword(s):  
Solar Wind ◽  
Direct Contact ◽  
Transport Processes ◽  
Time Variable ◽  
Dust Particles ◽  
Spatial Diffusion ◽  
Drag Forces ◽  
Orbit Perturbation ◽  
Time Variations ◽  
F Ring

ABSTRACTSaturn's broad E ring, the narrow G ring and the structured and apparently time variable F ring(s), contain many micron and sub-micron sized particles, which make up the “visible” component. These rings (or ring systems) are in direct contact with magnetospheric plasma. Fluctuations in the plasma density and/or mean energy, due to magnetospheric and solar wind processes, may induce stochastic charge variations on the dust particles, which in turn lead to an orbit perturbation and spatial diffusion. It is suggested that the extent of the E ring and the braided, kinky structure of certain portions of the F rings as well as possible time variations are a result of plasma induced electromagnetic perturbations and drag forces. The G ring, in this scenario, requires some form of shepherding and should be akin to the F ring in structure. Sputtering of micron-sized dust particles in the E ring by magnetospheric ions yields lifetimes of 102to 104years. This effect as well as the plasma induced transport processes require an active source for the E ring, probably Enceladus.

ANALYTICAL MODEL OF SUPEREXCHANGE

1988 ◽  
Vol 49 (C8) ◽  
pp. C8-911-C8-912
Author(s):  
Yu. V. Rakitin ◽  
V. T. Kalinnikov
Keyword(s):  
Analytical Model
Sign in / Sign up

Export Citation Format

Share Document