A Correlation of the Viscosity of Hydrocarbon Systems With Pressure, Temperature and Composition

1968 ◽  
Vol 8 (02) ◽  
pp. 157-162 ◽  
Author(s):  
J.E. Little ◽  
H.T. Kennedy

Abstract An empirical equation for the prediction of the viscosity of several pure paraffin hydrocarbons and nitrogen is presented. It involves temperature, pressure and six constants of the material, and it applies reliably to both liquids and gases. The equation is similar in form to van der Waal's equation of state. For the paraffin hydrocarbons methane through n-hexane and nitrogen, an average absolute deviation of 1.9 percent was obtained on 1,006 data points described in the literature by 14 authors. When this equation is extended to complex, liquid hydrocarbon mixtures, a correlation was obtained with an average absolute deviation of 9.9 percent. Introduction Equations describing the flow of gas and liquid through porous media contain the viscosity coefficient of the fluid. If other pertinent variables remain constant, the volume rate of flow is inversely proportional to this coefficient. In dealing with condensate fluids and volatile oils, however, the compositional effects resulting from changing pressure materially affect the viscosity. The effect of compositional changes also may be significant in certain secondary recovery or pressure maintenance processes, notably miscible displacement or gas injection. Early attempts to describe the performance of reservoirs utilized a volumetric material balance method wherein gas and liquid in the reservoir were identified as produced gas and liquid at the surface. This method of analysis proved adequate for reservoirs at moderate temperature and pressure that contained gas with moderately low amounts of condensable materials. The volumetric material balance procedures for "black oil" reservoirs leave much to be desired when applied to condensate and volatile oil reservoirs because phase behavior and compositional changes the relatively more important in these cases. The alternative is a compositional material balance, which in turn, requires a correlation of properties of the reservoir fluid with composition. This paper supplies this correlation in regard to viscosity, for reservoir crude oils. REVIEW OF LITERATURE The literature contains many empirical equations describing the effects of composition, temperature and pressure on the viscosities of pure liquids and binary liquid mixtures. However, the applicability of a majority of these equations is limited to very low pressures and to a small number of systems. Most of the, when applied to complex hydrocarbon systems, are of little value. The lack of utility of the majority of equations results from the fact that they were developed to show the separate effect of temperature, pressure or composition on viscosity, but not to predict the viscosity as a function of all three variables. And with the few exceptions noted below, they were developed to apply to much simpler systems than hydrocarbon mixtures. P. 157ˆ

2016 ◽  
Vol 142 ◽  
pp. 77-84 ◽  
Author(s):  
Adel Najafi-Marghmaleki ◽  
Ali Barati-Harooni ◽  
Aboozar Soleymanzadeh ◽  
Seyed Jamal Samadi ◽  
Babak Roshani ◽  
...  

Author(s):  
N. Santhi ◽  
P.L. Sabarathinam ◽  
G. Alamelumangai ◽  
J. Madhumitha ◽  
M. Emayavaramban

By combining the van der Waals’ equation of state and the Free Length Theory of Jacobson, a new theoretical model is developed for the prediction of internal pressure of pure liquids and liquid mixtures. It requires only the molar volume data in addition to the ratio of heat capacities and critical temperature. The proposed model is simple, reliably accurate and capable of predicting internal pressure of pure liquids with an average absolute deviation of 4.24% in the predicted internal pressure values compared to those given in literature. The average absolute deviation in the predicted internal pressure values through the proposed model for the five binary liquid mixtures tested varies from 0.29% to 1.9% when compared to those of literature values.


2020 ◽  
Vol 117 ◽  
pp. 107965
Author(s):  
M.Yu. Petrushina ◽  
E.S. Dedova ◽  
K.V. Yusenko ◽  
A.S. Portnyagin ◽  
E.K. Papynov ◽  
...  

1952 ◽  
Vol 44 (1) ◽  
pp. 211-212 ◽  
Author(s):  
E. J. Bradbury ◽  
Dorothy McNulty ◽  
R. I. Savage ◽  
E. E. McSweeney

2000 ◽  
Vol 78 (2) ◽  
pp. 184-190 ◽  
Author(s):  
Karina M De Fina ◽  
Tina L Sharp ◽  
Michael A Spurgin ◽  
Ivette Chuca ◽  
William E Acree, Jr. ◽  
...  

Experimental solubilities are reported at 25.0°C for diuron (also called 3-(3,4-dichlorophenyl)-1,1-dimethyl urea) dissolved in 49 different organic nonelectrolyte solvents containing ether-, chloro-, hydroxy-, ester-, methyl-, and tert-butyl-functional groups. Results of these measurements are used to test the applications and limitations of expressions derived from Mobile Order theory. For the 28 nonalcoholic solvents for which predictions could be made computations show that Mobile Order theory does provide fairly reasonable estimates of the saturation mole fraction solubilities. Average absolute deviation between predicted and observed values is 60.1%. Diuron solubilities in the alcohol solvents are used to calculate stability constants for presumed solute-solvent hydrogen bonds that are believed to occur in solution.Key words: pesticide, diuron solubilities, organic nonelectrolyte solvents, solubility predictions.


1992 ◽  
Vol 276 ◽  
Author(s):  
D-G. Oei ◽  
S. L. McCarthy

ABSTRACTMeasurements of the residual stress in polysilicon films made by Low Pressure Chemical Vapor Deposition (LPCVD) at different deposition pressures and temperatures are reported. The stress behavior of phosphorus (P)-ion implanted/annealed polysilicon films is also reported. Within the temperature range of deposition, 580 °C to 650 °C, the stress vs deposition temperature plot exhibits a transition region in which the stress of the film changes from highly compressive to highly tensile and back to highly compressive as the deposition temperature increases. This behavior was observed in films that were made by the LPCVD process at reduced pressures of 210 and 320 mTORR. At deposition temperatures below 590 °C the deposit is predominantly amorphous, and the film is highly compressive; at temperatures above 610 °C (110) oriented polycrystalline silicon is formed exhibiting high compressive residual stress.


Nanoscale ◽  
2015 ◽  
Vol 7 (19) ◽  
pp. 8803-8810 ◽  
Author(s):  
Ya. Grosu ◽  
G. Renaudin ◽  
V. Eroshenko ◽  
J.-M. Nedelec ◽  
J.-P. E. Grolier

Sign in / Sign up

Export Citation Format

Share Document