Evaluation of the Clearwater Formation Caprock for a Proposed, Low-Pressure, Steam-Assisted Gravity Drainage Pilot Project

2011 ◽  
Author(s):  
Michelle Uwiera-Gartner ◽  
Michael Robert Carlson ◽  
Claes T.S. Palmgren
Keyword(s):  
Pilot Project ◽  
Low Pressure ◽  
Gravity Drainage ◽  
Steam Assisted Gravity Drainage ◽  
Pressure Steam ◽  
Clearwater Formation

Modelling Steam-Assisted Gravity Drainage Process in the UTF Pilot Project

1991 ◽  
Author(s):  
A.L. Siu ◽  
L.X. Nghiem ◽  
S.D. Gittins ◽  
B.I. Nzekwu ◽  
D.A. Redford
Keyword(s):  
Pilot Project ◽  
Gravity Drainage ◽  
Steam Assisted Gravity Drainage

Dynamic Viscosity of Compressed Water to 10 Kilobar and Steam to 1500°C

1969 ◽  
Vol 11 (2) ◽  
pp. 189-205 ◽  
Author(s):  
E. A. Bruges ◽  
M. R. Gibson
Keyword(s):  
Gaseous Phase ◽  
Dynamic Viscosity ◽  
Low Temperatures ◽  
Pressure Range ◽  
Low Pressure ◽  
Temperature Range ◽  
Inversion Temperature ◽  
Pressure Steam ◽  
Correlating Equations ◽  
First Time

Equations specifying the dynamic viscosity of compressed water and steam are presented. In the temperature range 0-100cC the location of the inversion locus (mu) is defined for the first time with some precision. The low pressure steam results are re-correlated and a higher inversion temperature is indicated than that previously accepted. From 100 to 600°C values of viscosity are derived up to 3·5 kilobar and between 600 and 1500°C up to 1 kilobar. All the original observations in the gaseous phase have been corrected to a consistent set of densities and deviation plots for all the new correlations are given. Although the equations give values within the tolerances of the International Skeleton Table it is clear that the range and tolerances of the latter could with some advantage be revised to give twice the existing temperature range and over 10 times the existing pressure range at low temperatures. A list of the observations used and their deviations from the correlating equations is available as a separate publication.

scholarly journals Identifying Reservoir Features via iSOR Response Behaviour

Energies ◽  
2021 ◽  
Vol 14 (2) ◽  
pp. 427
Author(s):  
Jingyi Wang ◽  
Ian Gates
Keyword(s):  
Oil Sands ◽  
Gravity Drainage ◽  
Athabasca Oil Sands ◽  
Steam Chamber ◽  
Heterogeneous Reservoirs ◽  
Steam Assisted Gravity Drainage ◽  
Response Behaviour

To extract viscous bitumen from oil sands reservoirs, steam is injected into the formation to lower the bitumen’s viscosity enabling sufficient mobility for its production to the surface. Steam-assisted gravity drainage (SAGD) is the preferred process for Athabasca oil sands reservoirs but its performance suffers in heterogeneous reservoirs leading to an elevated steam-to-oil ratio (SOR) above that which would be observed in a clean oil sands reservoir. This implies that the SOR could be used as a signature to understand the nature of heterogeneities or other features in reservoirs. In the research reported here, the use of the SOR as a signal to provide information on the heterogeneity of the reservoir is explored. The analysis conducted on prototypical reservoirs reveals that the instantaneous SOR (iSOR) can be used to identify reservoir features. The results show that the iSOR profile exhibits specific signatures that can be used to identify when the steam chamber reaches the top of the formation, a lean zone, a top gas zone, and shale layers.

scholarly journals Failure Analysis in Lacing Wire Of Last Stage Low Pressure Steam Turbine Blade

2021 ◽  
Vol 1096 (1) ◽  
pp. 012097
Author(s):  
A M Kongkong ◽  
H Setiawan ◽  
J Miftahul ◽  
A R Laksana ◽  
I Djunaedi ◽  
...  
Keyword(s):  
Failure Analysis ◽  
Steam Turbine ◽  
Turbine Blade ◽  
Low Pressure ◽  
Pressure Steam ◽  
Steam Turbine Blade ◽  
Last Stage
Sign in / Sign up

Export Citation Format

Share Document