scholarly journals Is the Folded-chain Structure Possible in Cellulose Molecule?

2000 ◽  
Vol 56 (8) ◽  
pp. 402-409 ◽  
Author(s):  
Fumio Tanaka ◽  
Noriko Fukui
Keyword(s):  
Chain Structure ◽  
Cellulose Molecule

Rapid Isolation of High Molecular Weight Urokinase from Native Human Urine

1982 ◽  
Vol 47 (03) ◽  
pp. 197-202 ◽  
Author(s):  
Kurt Huber ◽  
Johannes Kirchheimer ◽  
Bernd R Binder
Keyword(s):  
Molecular Weight ◽  
High Molecular Weight ◽  
Human Urine ◽  
Gel Filtration ◽  
Chain Structure ◽  
The Other ◽  
Single Chain ◽  
Apparent Homogeneity ◽  
Sequential Adsorption

SummaryUrokinase (UK) could be purified to apparent homogeneity starting from crude urine by sequential adsorption and elution of the enzyme to gelatine-Sepharose and agmatine-Sepharose followed by gel filtration on Sephadex G-150. The purified product exhibited characteristics of the high molecular weight urokinase (HMW-UK) but did contain two distinct entities, one of which exhibited a two chain structure as reported for the HMW-UK while the other one exhibited an apparent single chain structure. The purification described is rapid and simple and results in an enzyme with probably no major alterations. Yields are high enough to obtain purified enzymes for characterization of UK from individual donors.

Investigating the Rheological Properties and Heat Stability of Polyarylsulphone Sulphides of Domestic Grades

2017 ◽  
Vol 44 (1) ◽  
pp. 23-26
Author(s):  
A.B. Baranov ◽  
I.D. Simonov-Emel'yanov ◽  
T.I. Andreeva ◽  
T.N. Prudskova ◽  
V.I. Sazikov
Keyword(s):  
Molecular Weight ◽  
Heat Stability ◽  
Chain Structure ◽  
Low Flow ◽  
Processing Temperature ◽  
Rheological Characteristics ◽  
Melt Viscosity ◽  
Full Curve ◽  
Temperature Range ◽  
Service Characteristics

The rheological characteristics of melts of polyarylsulphone sulphides of domestic grades were investigated in the temperature range 240–360°C. Full curves of heat stability were obtained, and formulae were proposed for their description. Polyarylsulphone sulphides (PSPSs) are heat-resistant polymers of structural designation of the polysulphone (PSP) class, the domestic production technology of which was developed at OAO “Institut plastmass”, which makes it possible to carry out the production of a wide grade range of PSP of different polymer chain structure and molecular weight. The main problem in the processing of PSPSs is their high melt viscosity and fairly low flow. Increase in the processing temperature lowers their melt viscosity, but there is then the danger of thermooxidative degradation of the polymer and consequently of deterioration in the service characteristics and appearance of articles. The aim of this work was to investigate the rheological characteristics and to obtain the full curve of heat stability for domestic grades of PSPSs and PSP of different molecular weight in a wide processing temperature range.

scholarly journals Relationship of 25-hydroxyvitamin D3 side chain structure to biological activity.

1975 ◽  
Vol 250 (1) ◽  
pp. 226-230
Author(s):  
M F Holick ◽  
M Garabedian ◽  
H K Schnoes ◽  
H F DeLuca
Keyword(s):  
Biological Activity ◽  
Chain Structure ◽  
Side Chain ◽  
Relationship Of

scholarly journals Rendering Fat and Heavy Fischer-Tropsch Waxes Mixtures (0–100%) Fast Pyrolysis Tests for the Production of Ethylene and Propylene

Processes ◽  
2021 ◽  
Vol 9 (2) ◽  
pp. 367
Author(s):  
Martyna Murat ◽  
Zahra Gholami ◽  
Josef Šimek ◽  
Daily Rodríguez-Padrón ◽  
José Miguel Hidalgo-Herrador
Keyword(s):  
Linear Chain ◽  
High Energy ◽  
Chain Structure ◽  
Nitrogen Atmosphere ◽  
Energy Materials ◽  
Fischer Tropsch ◽  
Pyrolysis Products ◽  
Product Composition ◽  
Rendered Fat ◽  
Linear Chain Structure

A great emphasis is placed on searching for efficient sources to produce renewable fuels due to the actual trends in avoiding the use of fossil resources to mitigate the environment’s deterioration. Thus, the use of waste from the food or wood industry for the production of biofuels is widely researched and may contribute to sustainable general development. Rendered fat and Fischer-Tropsch waxes are high-energy materials which could be used for the pyrolysis reaction. Therefore, in this study, the effect of reaction parameters and feedstock composition on the distribution of the pyrolysis products has been examined. The experiments were carried out in a nitrogen atmosphere in a multi-shot pyrolizer instrument equipped with GC-FID. First, the influence of the temperature was examined at 785, 800, and 815 °C. The highest yield to olefins was observed at 815 °C. The effect of triglycerides and paraffins contents (0–100% with 10% ramp) in the feedstock on the product composition was investigated at 815 °C. The gas chromatography analyses revealed that the feedstock composition did not significantly affect the product composition due to the high temperature and the long linear chain structure similarities between the free fatty acids and Fischer-Tropsch waxes.

scholarly journals Effect of Surfactant Molecular Structure on Emulsion Stability Investigated by Interfacial Dilatational Rheology

Polymers ◽  
2021 ◽  
Vol 13 (7) ◽  
pp. 1127
Author(s):  
Yuejie Jin ◽  
Dingrong Liu ◽  
Jinhua Hu
Keyword(s):  
Emulsion Stability ◽  
Chain Structure ◽  
Interfacial Film ◽  
Future Design ◽  
Rheological Method ◽  
Viscoelastic Modulus ◽  
Hydrophobic Chain ◽  
Branched Chain ◽  
The Stability ◽  
Branched Structure

Polyglycerol polyricinolate (PGPR) and polyglycerol-2 dioleate were selected as model surfactants to construct water-in-oil (W/O) emulsions, and the effect of interfacial rheological properties of surfactant film on the stability of emulsions were investigated based on the interfacial dilatational rheological method. The hydrophobicity chain of PGPR is polyricinic acid condensed from ricinic acid, and that of polyglycerol-2 dioleate is oleic acid. Their dynamic interfacial tensions in 15 cycles of interfacial compression-expansion were determined. The interfacial dilatational viscoelasticity was analyzed by amplitude scanning in the range of 1–28% amplitude and frequency sweep in the range of 5–45 mHz under 2% amplitude. It was found that PGPR could quickly reach adsorption equilibrium and form interfacial film with higher interfacial dilatational viscoelastic modulus to resist the deformation of interfacial film caused by emulsion coalescence, due to its branched chain structure and longer hydrophobic chain, and the emulsion thus presented good stability. However, polyglycerol-2 dioleate with a straight chain structure had lower interfacial tension, and it failed to resist the interfacial disturbance caused by coalescence because of its lower interfacial dilatational viscoelastic modulus, and thus the emulsion was unstable. This study reveals profound understanding of the influence of branched structure of PGPR hydrophobic chain on the interfacial film properties and the emulsion stability, providing experimental reference and theoretical guidance for future design or improvement of surfactant.

Programming cell communications with pH-responsive DNA nanodevices

2021 ◽  
Author(s):  
Junjun Hou ◽  
Shitai Zhu ◽  
Ziwei Zhao ◽  
Jianlei Shen ◽  
Jie Chao ◽  
...  
Keyword(s):  
Cell Surface ◽  
Chain Structure ◽  
Ph Responsive ◽  
Double Chain ◽  
Physiological Conditions

The DNA nanoswitchs on cell surface could respond to the changes of pH under physiological conditions by switching from a three-chain structure to a double-chain structure, thus connecting another set...

Structure study of the chalcogens and chalcogenides by X-ray absorption fine structure

2020 ◽  
Vol 0 (0) ◽  
Author(s):  
Hiroyuki Ikemoto ◽  
Takafumi Miyanaga
Keyword(s):  
Fine Structure ◽  
Covalent Bond ◽  
Narrow Channel ◽  
Structure Study ◽  
Chain Structure ◽  
Covalent Bonds ◽  
X Ray ◽  
Absorption Fine ◽  
Amorphous States ◽  
X Ray Absorption

AbstractIn this review, we make a survey of the structure studies for the chalcogen elements and several chalcogenides in liquid, amorphous and nanosized state by using X-ray absorption fine structure (XAFS). The chalcogen elements have hierarchic structures; the chain structure constructed with the strong covalent bond as a primary structure, and the weaker interaction between chains as a secondary one. Existence of these two kinds of interactions induces exotic behaviors in the liquid, amorphous and nanosized state of the chalcogen and chalcogenides. XAFS is a powerful structure analysis technique for multi-element systems and the disordered materials, so it is suitable for the study of such as liquid, amorphous and nanosized mixtures. In section 2, the structures for the liquid state are discussed, which show the interesting semiconductor-metal transition depending on their temperatures and components. In section 3, the structure for the amorphous states are discussed. Especially, some of chalcogens and chalcogenides present the photostructural change, which is important industrial application. In section 4, the structures of nanosized state, nanoparticles and isolated chain confined into the narrow channel, are discussed. The studies of the nanoparticle and the isolated chain reveal the alternative role between the intrachain covalent bonds and the interchain interaction.

scholarly journals Conformation of Polyethylene Glycol inside Confined Space: Simulation and Experimental Approaches

Nanomaterials ◽  
2021 ◽  
Vol 11 (1) ◽  
pp. 244
Author(s):  
Tianji Ma ◽  
Nicolas Arroyo ◽  
Jean Marc Janot ◽  
Fabien Picaud ◽  
Sebastien Balme
Keyword(s):  
Polyethylene Glycol ◽  
Ion Transport ◽  
Chain Structure ◽  
Confined Space ◽  
Cation Type ◽  
Experimental Approaches

The modification of the inner nanopore wall by polymers is currently used to change the specific properties of the nanosystem. Among them, the polyethylene glycol (PEG) is the most used to prevent the fouling and ensure the wettability. However, its properties depend mainly on the chain structure that is very difficult to estimate inside this confined space. Combining experimental and simulation approaches, we provide an insight to the consequence of the PEG presence inside the nanopore on the nanopore properties. We show, in particular, that the cation type in the electrolyte, together with the type of electrolyte (water or urea), is at the origin of the ion transport modification in the nanopore.

Sign in / Sign up

Export Citation Format

Share Document