scholarly journals Low-level windshear associated with atmospheric boundary layer jets – Case studies

Atmósfera ◽  
2020 ◽  
Vol 34 (4) ◽  
pp. 461-490
Author(s):  
P. W. Chan ◽  
K. K. Hon ◽  
Q. S. Li

Jet streams in the atmospheric boundary layer may lead to hazardous weather over southern China. In this paper, the jet-related low-level windshear to be encountered by an aircraft is documented. Two typical cases under the northeast monsoon regime are considered, namely, easterly jet disrupted by the mountains to the south of Hong Kong International Airport, and outbreak of monsoon surge that produces a low-level northeasterly jet. The Doppler Light Detection and Ranging (LIDAR) systems are found to capture the corresponding windshear features very well, e.g., consistent with pilot reports and flight data. They are useful in providing timely alert to the aircraft. In particular, the LIDAR captures a double jet structure in the atmospheric boundary layer for the easterly wind case, which has not been reported in the literature before. The physical mechanism for the occurrence of the double jet is yet to be revealed. Moreover, the performance of a high spatial resolution (200 m) numerical weather prediction (NWP) model in predicting the jet and the associated low-level windshear is studied. The model is found to provide reasonable prediction of the windshear features at a few hours ahead, and, for the cases studied, shows skills in providing timely alerts to the aircraft.

2019 ◽  
Vol 2 (3) ◽  
Author(s):  
Aditi Singh

Air pollution is an issue of great concern in any urban region due to its serious health implications. The capital of India, New Delhi continues to be in the list of most polluted cities since 2014. The air quality of any region depends on the ability of dispersion of air pollutants. The height or depth of the atmospheric boundary layer (ABL) is one measure of dispersion of air pollutants. Ventilation coefficient is another crucial parameter in determining the air quality of any region. Both of these parameters are obtained over Delhi from the operational global numerical weather prediction (NWP) model of National Centre for Medium Range Weather forecasting (NCMRWF) known as NCMRWF Unified Model (NCUM). The height of ABL over Delhi, is also obtained from radiosonde observations using the parcel method. A good agreement is found between the observed and predicted values of ABL height. The maximum height of ABL is obtained during summer season and minimum is obtained in winter season. High values of air pollutants are found when the values of ABL height and ventilation coefficient are low. 


2017 ◽  
Author(s):  
Norbert Kalthoff ◽  
Fabienne Lohou ◽  
Barbara Brooks ◽  
Gbenga Jegede ◽  
Bianca Adler ◽  
...  

Abstract. A ground-based field campaign was conducted in southern West Africa from mid June to the end of July 2016 within the framework of the Dynamics–Aerosol–Chemistry–Cloud Interactions in West Africa (DACCIWA) project. It aimed to provide a high-quality comprehensive data set for process studies, in particular into interactions between low-level clouds (LLCs) and boundary-layer conditions. In this region missing observations are still a major issue. During the campaign, extensive remote sensing and in-situ measurements were conducted at three supersites: Kumasi (Ghana), Savè (Benin) and Ile-Ife (Nigeria). Daily radiosoundings were performed at 06:00 UTC and 15 intensive observation periods (IOPs) were performed during which additional radiosondes were launched every 1.5 to 3 h. Remotely piloted aerial systems were also operated during the IOPs. Extended stratiform LLCs form frequently in southern West Africa during the night time and persist long into the following day. They affect the radiation budget and hence the evolution of the atmospheric boundary layer and regional climate. The relevant parameters and processes governing the formation and dissolution of the LLCs are still not fully understood. This paper gives an overview of the diurnal cycles of the energy-balance components, near-surface temperature, humidity, wind speed and direction as well as the conditions (LLCs, low-level jet) in the boundary layer at the supersites and relates them to synoptic-scale conditions (monsoon layer, Harmattan layer, African easterly jet, tropospheric stratification) in the DACCIWA operational area. The characteristics of LLCs vary considerably from day to day, including a few almost cloud-free nights. During cloudy nights we found large differences in the LLC's formation and dissolution times as well as in the cloud-base height. The differences exist at individual sites and also between the sites. The synoptic conditions are characterised by a monsoon layer with south-westerly wind, on average about 1.9 km deep, and easterly wind above; the depth and strength of the monsoon flow show great day-to-day variability. Within the monsoon layer, a nocturnal low-level jet forms in approximately the same layer as the LLC. Its strength and duration is highly variable from night to night. This unique data set will allow us to test some new hypotheses about the processes involved in the development of LLCs and their interaction with the boundary layer and can also be used for model evaluation.


2007 ◽  
Vol 22 (2) ◽  
pp. 255-277 ◽  
Author(s):  
Kelly M. Mahoney ◽  
Gary M. Lackmann

Abstract Operational forecasters in the southeast and mid-Atlantic regions of the United States have noted a positive quantitative precipitation forecast (QPF) bias in numerical weather prediction (NWP) model forecasts downstream of some organized, cold-season convective systems. Examination of cold-season cases in which model QPF guidance exhibited large errors allowed identification of two representative cases for detailed analysis. The goals of the case study analyses are to (i) identify physical mechanisms through which the upstream convection (UC) alters downstream precipitation amounts, (ii) determine why operational models are challenged to provide accurate guidance in these situations, and (iii) suggest future research directions that would improve model forecasts in these situations and allow forecasters to better anticipate such events. Two primary scenarios are identified during which downstream precipitation is altered in the presence of UC for the study region: (i) a fast-moving convective (FC) scenario in which organized convective systems oriented parallel to the lower-tropospheric flow are progressive relative to the parent synoptic system, and appear to disrupt poleward moisture transport, and (ii) a situation characterized by slower-moving convection (SC) relative to the parent system. Analysis of a representative FC case indicated that moisture consumption, stabilization via convective overturning, and modification of the low-level flow to a more westerly direction in the postconvective environment all appear to contribute to the reduction of downstream precipitation. In the FC case, operational Eta Model forecasts moved the organized UC too slowly, resulting in an overestimate of downstream moisture transport. A 4-km explicit convection model forecast from the Weather Research and Forecasting model produced a faster-moving upstream convective system and improved downstream QPF. In contrast to the FC event, latent heat release in the primary rainband is shown to enhance the low-level jet ahead of the convection in the SC case, thereby increasing moisture transport into the downstream region. A negative model QPF bias was observed in Eta Model forecasts for the SC event. Suggestions are made for precipitation forecasting in UC situations, and implications for NWP model configuration are discussed.


MAUSAM ◽  
2022 ◽  
Vol 53 (1) ◽  
pp. 75-86
Author(s):  
R. SURESH ◽  
P. V. SANKARAN ◽  
S. RENGARAJAN

Thermodynamic structure of atmospheric boundary layer during October - December covering southwest and northeast monsoon activities over interior Tamilnadu (ITN), coastal Tamilnadu (CTN) and adjoining Bay of Bengal (BOB) has been studied using  TIROS Operational Vertical Sounder (TOVS) data of 1996-98. Heights of neutral stratified mixed layer, cloud layer and planetary boundary layer (PBL) have been estimated through available standard pressure level data. Highest PBL occurs during active northeast monsoon. Cloud layer thickness during weak northeast monsoon over interior Tamilnadu  is significantly higher than that over coastal Tamilnadu and  also over Bay of Bengal. Convective stability (instability)  of the atmosphere in 850-700 hPa layer is associated with weak / withdrawal (active) phase of northeast monsoon. One of  the plausible reasons for  subdued rainfall activity during weak northeast monsoon over interior Tamilnadu could be convective instability  seen over this region in 850-700 hPa layer. But the same is absent in CTN and BOB where no rainfall activity exists during weak monsoon phase. Virtual temperature lapse rate in 850-700 hPa layer exceeding (less than) 6oK/km is associated with active (weak) phase of northeast monsoon over the interior, coastal Tamilnadu and Bay of Bengal.


2019 ◽  
Vol 11 (13) ◽  
pp. 1590 ◽  
Author(s):  
Ruijun Dang ◽  
Yi Yang ◽  
Xiao-Ming Hu ◽  
Zhiting Wang ◽  
Shuwen Zhang

The height of the atmospheric boundary layer (ABLH) or the mixing layer height (MLH) is a key parameter characterizing the planetary boundary layer, and the accurate estimation of that is critically important for boundary layer related studies, which include air quality forecasts and numerical weather prediction. Aerosol lidar is a powerful remote sensing instrument frequently used to retrieve the ABLH through detecting the vertical distributions of aerosol concentration. Presently available methods for ABLH determination from aerosol lidar are summarized in this review, including a lot of classical methodologies as well as some improved versions of them. Some new recently developed methods applying advanced techniques such as image edge detection, as well as some new methods based on multi-wavelength lidar systems, are also summarized. Although a lot of techniques have been proposed and have already given reasonable results in several studies, it is impossible to recommend a technique which is suitable in all atmospheric scenarios. More accurate instantaneous ABLH from robust techniques is required, which can be used to estimate or improve the boundary layer parameterization in the numerical model, or maybe possible to be assimilated into the weather and environment models to improve the simulation or forecast of weather and air quality in the future.


Atmosphere ◽  
2019 ◽  
Vol 10 (11) ◽  
pp. 654
Author(s):  
Marta Wenta ◽  
Agnieszka Herman

Sea ice fragmentation results in the transformation of the surface from relatively homogeneous to highly heterogeneous. Atmospheric boundary layer (ABL) rapidly responds to those changes through a range of processes which are poorly understood and not parametrized in numerical weather prediction (NWP) models. The aim of this work is to increase our understanding and develop parametrization of the ABL response to different floe size distributions (FSD). The analysis is based on the results of simulations with the Weather Research and Forecasting model. Results show that FSD determines the distribution and intensity of convection within the ABL through its influence on the atmospheric circulation. Substantial differences between various FSDs are found in the analysis of spatial arrangement and strength of ABL convection. To incorporate those sub-grid effects in the NWP models, a correction factor for the calculation of surface moisture heat flux is developed. It is expressed as a function of floe size, sea ice concentration and wind speed, and enables a correction of the flux computed from area-averaged quantities, as is typically done in NWP models. In general, the presented study sheds some more light on the sea ice–atmosphere interactions and provides the first attempt to parametrize the influence of FSD on the ABL.


Sign in / Sign up

Export Citation Format

Share Document