scholarly journals Investigations of nanoparticle emissions of two gasoline cars MPI & DI at stationary part load operation

2014 ◽  
Vol 158 (3) ◽  
pp. 3-11
Author(s):  
Jan CZERWIŃSKI ◽  
Pierre COMTE ◽  
Alejandro KELLER ◽  
Andreas MAYER

Starting from Euro 6 not only for diesel but also for gasoline vehicles, with direct injection technology (GDI) a solid particle number emissions limit of 6 × 1011 #/km becomes effective. The limit was temporary extended for GDI to 6 x 1012 #/km. Nuclei of metals as well as organics are suspected to significantly contribute especially to the ultrafine particle size fractions, and thus to the particle number concentration. In the project GasOMeP (Gasoline Organic & Metal Particulates) metal-nanoparticles (including sub 20 nm) from gasoline cars are investigated for different engine technologies. In the present paper some results of basic investigations of nanoparticles from two gasoline cars – an older one with MPI and a never one with DI – are represented. The measurements were performed at vehicle tailpipe, with varying sampling conditions and with different SMPS-systems, which enabled the mobility scanning in different size ranges. The results show that the older vehicle with MPI emits high particle count concentrations. The size distributions are decisively bimodal with high numbers in nuclei mode. In this case, the particle counting below 10 nm yields important information. The emissions of the newer vehicle with DI show no typical uniform shape of particle size distributions and are at lower level, than for the older vehicle. There is no visible nuclei mode and the ultrafine particle concentrations below 10 nm are insignificant. A sampling with a strongly increased primary dilution has a clear influence on the indicated (higher) particle concentrations.

2003 ◽  
Vol 3 (6) ◽  
pp. 5513-5546 ◽  
Author(s):  
M. Ketzel ◽  
P. Wåhlin ◽  
A. Kristensson ◽  
E. Swietlicki ◽  
R. Berkowicz ◽  
...  

Abstract. Particle size distribution (size-range 3–900 nm) and PM10 was measured simultaneously at an urban background station in Copenhagen, a near-city background and a rural location during a period in September-November 2002. The study investigates the contribution from urban versus regional sources of particle number and mass concentration. The total particle number (ToN) and NOx are well correlated at the urban and near-city level and show a distinct diurnal variation, indicating the common traffic source. The average ToN at the three stations differs by a factor of 3. The observed concentrations are 2500 # cm−3, 4500 # cm−3 and 7700 # cm−3 at rural, near-city and urban level, respectively. PM10 and total particle volume (ToV) are well correlated between the three different stations and show similar concentration levels, in average within 30% relative difference, indicating a common source from long-range transport that dominates the concentrations at all locations. Measures to reduce the local urban emissions of NOx and ToN are likely to affect both the street level and urban background concentrations, while for PM10 and ToV only measurable effects at the street level are probable. Taking into account the supposed stronger health effects of ultrafine particles reduction measures should address particle number emissions. The traffic source contributes strongest in the 10–200 nm particle size range. The maximum of the size distribution shifts from about 20–30 nm at kerbside to 50–60 nm at rural level. We also observe particle formation events in the 3–20 nm size range at rural location in the afternoon hours, mainly under conditions with low concentrations of pre-existing aerosol particles. The maximum in the size distribution of the "traffic contribution" seems to be shifted to about 28 nm in the urban location compared to 22 nm at kerbside. Assuming NOx as an inert tracer on urban scale let us estimate that ToN at urban level is reduced by 15–30% compared to kerbside. Particle removal processes, e.g. deposition and coagulation, which are most efficient for smallest particle sizes (<20 nm) and condensational growth are likely mechanisms for the loss of particle number and the shift in particle size.


2020 ◽  
Vol 20 (19) ◽  
pp. 11329-11348 ◽  
Author(s):  
Jenni Kontkanen ◽  
Chenjuan Deng ◽  
Yueyun Fu ◽  
Lubna Dada ◽  
Ying Zhou ◽  
...  

Abstract. The climate and air quality effects of aerosol particles depend on the number and size of the particles. In urban environments, a large fraction of aerosol particles originates from anthropogenic emissions. To evaluate the effects of different pollution sources on air quality, knowledge of size distributions of particle number emissions is needed. Here we introduce a novel method for determining size-resolved particle number emissions, based on measured particle size distributions. We apply our method to data measured in Beijing, China, to determine the number size distribution of emitted particles in a diameter range from 2 to 1000 nm. The observed particle number emissions are dominated by emissions of particles smaller than 30 nm. Our results suggest that traffic is the major source of particle number emissions with the highest emissions observed for particles around 10 nm during rush hours. At sizes below 6 nm, clustering of atmospheric vapors contributes to calculated emissions. The comparison between our calculated emissions and those estimated with an integrated assessment model GAINS (Greenhouse Gas and Air Pollution Interactions and Synergies) shows that our method yields clearly higher particle emissions at sizes below 60 nm, but at sizes above that the two methods agree well. Overall, our method is proven to be a useful tool for gaining new knowledge of the size distributions of particle number emissions in urban environments and for validating emission inventories and models. In the future, the method will be developed by modeling the transport of particles from different sources to obtain more accurate estimates of particle number emissions.


2018 ◽  
Author(s):  
Luciana Varanda Rizzo ◽  
Pontus Roldin ◽  
Joel Brito ◽  
John Backman ◽  
Erik Swietlicki ◽  
...  

Abstract. The Amazon Basin is a unique region to study atmospheric aerosols, given their relevance for the regional hydrological cycle and large uncertainty of their sources. Multi-year datasets are crucial when contrasting periods of natural conditions and periods influenced by anthropogenic emissions. In the wet season, biogenic sources and processes prevail, and the Amazonian atmospheric composition resembles pre-industrial conditions. In the dry season, the Basin is influenced by widespread biomass burning emissions. This work reports multi-year observations of high time resolution submicrometer (10–600 nm) particle number size distributions at a rain forest site in Amazonia (TT34 tower, 60 km NW from Manaus city), between years 2008–2010 and 2012–2014. Median particle number concentration was 403 cm−3 in the wet season and 1254 cm−3 in the dry season. The Aitken mode (~ 30–100 nm in diameter) was prominent during the wet season, while accumulation mode (~ 100–600 nm in diameter) dominated the particle size spectra during the dry season. Cluster analysis identified groups of aerosol number size distribution influenced by convective downdrafts, nucleation events and fresh biomass burning emissions. New particle formation and subsequent growth was rarely observed during the 749 days of observations, similar to previous observations in the Amazon Basin. A stationary 1D column model (ADCHEM – Aerosol Dynamics, gas and particle phase CHEMistry and radiative transfer model) was used to assess importance of processes behind the observed diurnal particle size distribution trends. Three major particle source types are required in the model to reproduce the observations: (i) a surface source of particles in the evening, possibly related to primary biological emissions (ii) entrainment of accumulation mode aerosols in the morning, and (iii) convective downdrafts transporting Aitken mode particles into the boundary layer mostly during the afternoon. The latter process has the largest influence on the modelled particle number size distributions. However, convective downdrafts are often associated with rain and thus act both as a source of Aitken mode particles, and as a sink of accumulation mode particles, causing a net reduction in the median total particle number concentrations in the surface layer. Our study shows that the combination of the three mentioned particle sources are essential to sustain particle number concentrations in Amazonia.


2010 ◽  
Vol 10 (10) ◽  
pp. 4643-4660 ◽  
Author(s):  
W. Birmili ◽  
K. Heinke ◽  
M. Pitz ◽  
J. Matschullat ◽  
A. Wiedensohler ◽  
...  

Abstract. Aerosol particle number size distributions (size range 0.003–10 μm) in the urban atmosphere of Augsburg (Germany) were examined with respect to the governing anthropogenic sources and meteorological factors. The two-year average particle number concentration between November 2004 and November 2006 was 12 200 cm−3, i.e. similar to previous observations in other European cities. A seasonal analysis yielded twice the total particle number concentrations in winter as compared to summer as consequence of more frequent inversion situations and enhanced particulate emissions. The diurnal variations of particle number were shaped by a remarkable maximum in the morning during the peak traffic hours. After a mid-day decrease along with the onset of vertical mixing, an evening concentration maximum could frequently be observed, suggesting a re-stratification of the urban atmosphere. Overall, the mixed layer height turned out to be the most influential meteorological parameter on the particle size distribution. Its influence was even greater than that of the geographical origin of the prevailing synoptic-scale air mass. Size distributions below 0.8 μm were also measured downstream of a thermodenuder (temperature: 300 °C), allowing to retrieve the volume concentration of non-volatile compounds. The balance of particle number upstream and downstream of the thermodenuder suggests that practically all particles >12 nm contain a non-volatile core while additional nucleation of particles smaller than 6 nm could be observed after the thermodenuder as an interfering artifact of the method. The good correlation between the non-volatile volume concentration and an independent measurement of the aerosol absorption coefficient (R2=0.9) suggests a close correspondence of the refractory and light-absorbing particle fractions. Using the "summation method", an average diameter ratio of particles before and after volatilisation could be determined as a function of particle size. The results indicated that particles >60 nm contain a significantly higher fraction of non-volatile compounds, most likely black carbon, than particles <60 nm. The results are relevant for future health-related studies in that they explore the size distribution and time-dependent behaviour of the refractory component of the urban aerosol over an extended time period.


2008 ◽  
Vol 8 (5) ◽  
pp. 18155-18217 ◽  
Author(s):  
F. Costabile ◽  
W. Birmili ◽  
S. Klose ◽  
T. Tuch ◽  
B. Wehner ◽  
...  

Abstract. Due to the presence of diffusive anthropogenic sources in urban areas, the spatio-temporal variability of fine (diameter <1 μm) and ultrafine (<0.1 μm) aerosol particles has been a challenging issue in particle exposure assessment as well as atmospheric research in general. We examined number size distributions of atmospheric aerosol particles (size range 3–800 nm) that were measured simultaneously at a maximum of eight observation sites in and around a city in Central Europe (Leipzig, Germany). Two main experiments were conducted with different time span and number of observation sites (2 years at 3 sites; 1 month at 8 sites). A general observation was that the particle number size distribution varied in time and space in a complex fashion as a result of interaction between local and far-range sources, and the meteorological conditions. To identify statistically independent factors in the urban aerosol, different runs of principal component analysis were conducted encompassing aerosol, gas phase, and meteorological parameters from the multiple sites. Several of the resulting principal components, outstanding with respect to their temporal persistence and spatial coverage, could be associated with aerosol particle modes: a first accumulation mode ("droplet mode", 300–800 nm), considered to be the result of liquid phase processes and far-range transport; a second accumulation mode (centered around diameters 90–250 nm), considered to result from primary emissions as well as aging through condensation and coagulation; an Aitken mode (30–200 nm) linked to urban traffic emissions in addition to an urban and a rural Aitken mode; a nucleation mode (5–20 nm) linked to urban traffic emissions; nucleation modes (3–20 nm) linked to photochemically induced particle formation; an aged nucleation mode (10–50 nm). A number of additional components were identified to represent only local sources at a single site each, or infrequent phenomena. In summary, the analysis of size distributions of high time and size resolution yielded a surprising wealth of statistical aerosol components occurring in the urban atmosphere over one single city. Meanwhile, satisfactory physical explanations could be found for the components with the greatest temporal persistence and spatial coverage. Therefore a paradigm on the behaviour of sub-μm urban aerosol particles is proposed, with recommendations how to efficiently monitor individual sub-fractions across an entire city.


2002 ◽  
Vol 2 (6) ◽  
pp. 2413-2448
Author(s):  
U. Uhrner ◽  
W. Birmili ◽  
F. Stratmann ◽  
M. Wilck ◽  
I. J. Ackermann ◽  
...  

Abstract. At Hohenpeissenberg (47°48'N, 11°07'E, 988 m asl), a rural site 200-300 m higher than the surrounding terrain, sulphuric acid concentrations, particle size distributions, and other trace gas concentrations were measured over a two and a half year period. Measured particle number concentrations and inferred particle surface area-concentrations were compared with box-model simulations based on a multimodal lognormal aerosol module that included a binary sulphuric acid water nucleation scheme. The calculated nucleation rates were corrected with a factor to match measured particle number concentrations. These corrections varied over a range of 10-3 - 1017. The correction factors were close to 1 for the measurements made in the winter, which represented stable thermal stratification and low wind conditions. In contrast, the correction factors were the largest for measurements made under strong convective conditions. Our comparison of measured and simulated particle size distributions suggest a distant particle-formation process under convective conditions near the interface of the mixed layer and the entrainment zone, followed by downward transport and particle growth. For stable stratification and low winds, our comparisons suggest that particles formed close to the measurement site.


1974 ◽  
Vol 18 ◽  
pp. 588-597
Author(s):  
R. Akselsson ◽  
C. Orsini ◽  
D. L. Meinert ◽  
T. B. Johansson ◽  
R. E. Van Grieken ◽  
...  

AbstractThe St. Louis aerosol was sampled during the period 16-22 August 1973 simultaneously at two locations using cascade impactors for sequential 12-hour samples. The six particle size fractions of each sampling were individually analyzed using PIXE for elements from S to Br and beyond and for heavy elements including Pb which permitted time variations of concentrations and particle size distributions to be followed and related to meteorological changes during the sampling period. In addition, the data were compared with average levels of the elements in coastal north Florida and maritime Bermuda as well as at a third St. Louis site. From this it appeared that some of the concentrations in St. Louis were at natural levels whereas others appeared to be higher and linked to air pollution sources. These relationships and others in this study may lead to criteria for distinguishing between pollutants and natural background in urban aerosols.


Sign in / Sign up

Export Citation Format

Share Document