The Concentration Distribution Surrounded the Growing of Gas Bubbles in the Bio Tissues of Divers

2019 ◽  
Vol 7 (1) ◽  
pp. 1-9 ◽  
Author(s):  
A. K. Abu-Nab ◽  
S. A. Mohammadein
Keyword(s):  
Concentration Distribution ◽  
Gas Bubbles

Fission Gas Bubbles in Fractured UO2

1968 ◽  
Vol 26 ◽  
pp. 286-287
Author(s):  
O. M. Katz
Keyword(s):  
Electron Microscopy ◽  
Thermal Gradient ◽  
Gas Bubbles ◽  
Inert Gas ◽  
Thermal Gradients ◽  
Fission Gas ◽  
Beam Heating ◽  
Limited Application ◽  
Bubble Characteristics ◽  
Electron Beam Heating

The swelling of irradiated UO2 has been attributed to the migration and agglomeration of fission gas bubbles in a thermal gradient. High temperatures and thermal gradients obtained by electron beam heating simulate reactor behavior and lead to the postulation of swelling mechanisms. Although electron microscopy studies have been reported on UO2, two experimental procedures have limited application of the results: irradiation was achieved either with a stream of inert gas ions without fission or at depletions less than 2 x 1020 fissions/cm3 (∼3/4 at % burnup). This study was not limited either of these conditions and reports on the bubble characteristics observed by transmission and fractographic electron microscopy in high density (96% theoretical) UO2 irradiated between 3.5 and 31.3 x 1020 fissions/cm3 at temperatures below l600°F. Preliminary results from replicas of the as-polished and etched surfaces of these samples were published.

Photosynthesis as a Possible Source of Gas Bubbles in Shallow Sandy Coastal Sediments

2011 ◽  
Author(s):  
D. V. Holliday ◽  
C. F. Greenlaw ◽  
David Thistle ◽  
Jan E. Rines
Keyword(s):  
Gas Bubbles ◽  
Coastal Sediments

Uniform Horizontal Groundwater Flow against Dispersion in a Shallow Aquifer: Two Analytical Models

1992 ◽  
Vol 23 (1) ◽  
pp. 1-12
Author(s):  
Ram Raj Vinda ◽  
Raja Ram Yadava ◽  
Naveen Kumar
Keyword(s):  
Point Source ◽  
Groundwater Flow ◽  
Cross Section ◽  
Analytical Solutions ◽  
Concentration Distribution ◽  
Analytical Models ◽  
Shallow Aquifer ◽  
Horizontal Cross Section ◽  
Flow Components ◽  
Reactive Pollutant

Analytical solutions converging rapidly at large and small values of times have been obtained for two mathematical models which describe the concentration distribution of a non reactive pollutant from a point source against the flow in a horizontal cross-section of a finite saturated shallow aquifer possessing uniform horizontal groundwater flow. Zero concentration or the conditions in which the flux across the extreme boundaries are proportional to the respective flow components are applied. The effects of flow and dispersion on concentration distribution are also discussed.

Measured and Modelled Chlorinated Contaminant Distributions in the St. Clair River Water

1986 ◽  
Vol 21 (3) ◽  
pp. 332-343 ◽  
Author(s):  
C.H. Chan ◽  
Y.L. Lau ◽  
B.G. Oliver
Keyword(s):  
River Water ◽  
Suspended Sediment ◽  
Water Samples ◽  
Concentration Distribution ◽  
Suspended Solids ◽  
Industrial Area ◽  
Concentration Profiles ◽  
Detroit River ◽  
Chemical Partitioning ◽  
Transverse Mixing

Abstract The concentration distribution of hexachlorobutadiene (HCBD), pentachloro-benzene (QCB), hexachlorobenzene (HCB) and octachlorostyrene (OCS) in water samples from transects across the upper and lower St. Clair River and the upper Detroit River were determined on four occasions in 1985. The data show a plume of these contaminants from the Sarnia industrial area. The fluxes and concentration profiles of the contaminants at Port Lambton have been modelled success fully using a simple transverse mixing model. A study on the chemical partitioning between the “dissolved” and “suspended sediment” phases shows that an important contaminant fraction is carried in the river by the suspended solids, particularly for lipophilie compounds such as HCB and OCS,

scholarly journals A study on highly concentrated lactic acid and the synthesis of lactide from its solution

2021 ◽  
pp. 174751982110210
Author(s):  
Xiaolong Xu ◽  
Lijuan Liu
Keyword(s):  
Lactic Acid ◽  
Acid Solution ◽  
Concentration Distribution ◽  
Raw Material ◽  
High Concentration ◽  
Composition Distribution ◽  
Lactic Acid Solution ◽  
H Nmr ◽  
Back Titration ◽  
Condensed Water

Lactic acid is an important platform compound used as raw material for the production of lactide and polylactic acid. However, its concentration and composition distribution are not as simple as those of common compounds. In this work, the mass concentration distribution of highly concentrated lactic acid is determined by back titration. The components of highly concentrated lactic acid, crude lactide, and polymer after the reaction are analyzed by HPLC. Different concentrations of lactic acid solution were prepared for the synthesis of lactide and its content in the product was determined by 1H NMR analysis. We found that lactide is more easily produced from high-concentration lactic acid solution with which the condensed water is easier to release. Hence, the removal of condensed water is crucial to the formation of lactide, although it is not directly formed by esterification of two molecules of lactic acid.

Sign in / Sign up

Export Citation Format

Share Document