scholarly journals Estimation and Mode Selection of Deuterium Flux Supply into Ampoule Device Through Diffusion Filter in Experiments with Pb15.7Li Eutectic at the IVG1.M Reactor

2019 ◽  
pp. 19 ◽  
Author(s):  
Ye. Tulubayev ◽  
Yu. Ponkratov ◽  
M. Skakov ◽  
Yu. Gordienko ◽  
Zh. Zaurbekova
Keyword(s):  
Neutron Irradiation ◽  
Nuclear Reactions ◽  
Fuel Cycle ◽  
Mode Selection ◽  
Differential Method ◽  
Lithium Content ◽  
Experimental Cell ◽  
Through Diffusion ◽  
Deuterium Flux ◽  
Palladium Silver

One of the most promising materials to produce tritium in fuel cycle of fusion facilities is the lead-lithium eutectic Pb15.7Li. Tritium will be generated in nuclear reactions in a lithium-containing material under the influence of neutron irradiation. However, nowadays a limited number of studies have been conducted with the eutectic of such a composition (with a lithium content of 15.7%) and consequently, there is a lack of data on mechanisms of tritium generation and release from Pb15.7Li. In this regard, there is an urgent necessity for research of tritium generation and release from Pb15.7 Li directly under neutron irradiation conditions. For these studies a differential method will be used, which consists in follows: a controlled flux of spectrally pure deuterium will be continuously fed into the experimental cell with the eutectic sample during the reactor experiment. The regulated flux of deuterium will be fed to the experimental cell with the Pb15.7Li sample using diffusion palladium-silver filter. The article describes the process of determination of deuterium flux supply modes into the experimental cell. The temperature dependences of deuterium penetration through diffusion palladium-silver filter are presented. The coefficients of diffusion, solubility and permeability of deuterium through a palladium-silver filter are estimated and the activation energies of these processes as well as the Arrhenius dependence are presented.

Environmental impact of the nuclear fuel cycle: Fate of actinides

MRS Bulletin ◽  
2010 ◽  
Vol 35 (11) ◽  
pp. 859-866 ◽  
Author(s):  
Rodney C. Ewing ◽  
Wolfgang Runde ◽  
Thomas E. Albrecht-Schmitt
Keyword(s):  
Environmental Impact ◽  
Nuclear Fuel ◽  
Nuclear Power ◽  
Fossil Fuels ◽  
Nuclear Reactions ◽  
Fuel Cycle ◽  
Ghg Emissions ◽  
Nuclear Fuel Cycle ◽  
Bearing Materials ◽  
Electronic Configurations

The resurgence of nuclear power as a strategy for reducing greenhouse gas (GHG) emissions has, in parallel, revived interest in the environmental impact of actinides. Just as GHG emissions are the main environmental impact of the combustion of fossil fuels, the fate of actinides, consumed and produced by nuclear reactions, determines whether nuclear power is viewed as an environmentally “friendly” source of energy. In this article, we summarize the sources of actinides in the nuclear fuel cycle, how actinides are separated by chemical processing, the development of actinide-bearing materials, and the behavior of actinides in the environment. At each stage, actinides present a unique and complicated behavior because of the 5f electronic configurations.

scholarly journals Determination of lithium content in solids by nuclear reaction technique

2020 ◽  
pp. 28-34
Author(s):  
V. B. Vykhodets ◽  
◽  
T. E. Kurennykh ◽  
A. Yu. Nikolaev ◽  
A. V. Suzdaltsev ◽  
...  
Keyword(s):  
Nuclear Reaction ◽  
Nuclear Power ◽  
Nuclear Reactions ◽  
Lithium Concentration ◽  
Direct Methods ◽  
Lithium Content ◽  
Zirconium Oxides ◽  
Acceleration Method ◽  
Electrochemical Devices

The acceleration method of nuclear reactions is used to measure the content of lithium and oxygen in zirconium oxides. The purpose of the study stems from the fact that there are no direct methods for determining lithium concentration in solids, while lithium is currently widely used for alloying alloys in aircraft construction, nuclear power engineering, electrochemical devices, and other fields of technology. It is shown that satisfactory metrological characteristics of the method are provided when using the 6Li(d, p0)7Li and 7Li(d, p)8Li reactions at a deuteron energy of 650 keV.

scholarly journals Current sources based on supercapacitors with β-active isotopes

2020 ◽  
Vol 6 (2) ◽  
pp. 113-116
Author(s):  
Vladimir A. Stepanov ◽  
Vladimir A. Chernov ◽  
Yury G. Parshikov ◽  
Viktor P. Lebedev ◽  
Evgeny V. Kharanzhevskiy
Keyword(s):  
Neutron Irradiation ◽  
Charge Separation ◽  
Electrode Materials ◽  
Nuclear Reactions ◽  
Accumulation Rate ◽  
Radioactive Isotopes ◽  
Β Decay ◽  
Supercapacitor Electrode ◽  
Charging Rate ◽  
Radiation Induced

In asymmetric supercapacitors, electric charges are separated and accumulated in conditions of neutron irradiation. The paper presents the results of studying current sources with radioactive isotopes (CSRI) based on supercapacitors of 100 F made by neutron activation of the elements of the substances (BN or SrO) introduced to the electrodes. Following the neutron irradiation with a dose of up to 400 Gy, the supercapacitors turn into CSRIs and have a charging rate of up to 7.8 μV/day. The CSRI charging rate increases in proportion to the activation with a neutron dose up to 14 kGy. This is explained by the production of β-active isotopes as a result of the 14N(n, p)14C and 88Sr(n, γ)89Sr reactions in the supercapacitor electrode materials. Estimation of the radiation-induced charge accumulation rate, with regard for the energy released during β-decay of 14C and 89Sr, excludes the known mechanisms of charge separation in a condensed environment due to the ionization and production of secondary electrons, the production of electron-hole pairs, etc. The electric charge separation and accumulation in CSRIs take place as a result of non-equilibrium thermoelectric phenomena in the near-electrode nanoregions. Nuclear reactions in nanoscale regions produce “temperature gradients” of up to 105 K/nm, this leading to up to 1013 electrons “evaporating” from nanocrystallites at times of ~ 10-11 s.

Nuclear Processes Related to the Ap Stars and the Heaviest Chemical Elements

1976 ◽  
Vol 32 ◽  
pp. 169-182
Author(s):  
B. Kuchowicz
Keyword(s):  
Nuclear Physics ◽  
Nuclear Reactions ◽  
Chemical Elements ◽  
Fission Products ◽  
Abundance Pattern ◽  
Isotopic Shifts ◽  
Processed Material ◽  
R Process ◽  
Ap Stars ◽  
Nuclear Processes

SummaryIsotopic shifts in the lines of the heavy elements in Ap stars, and the characteristic abundance pattern of these elements point to the fact that we are observing mainly the products of rapid neutron capture. The peculiar A stars may be treated as the show windows for the products of a recent r-process in their neighbourhood. This process can be located either in Supernovae exploding in a binary system in which the present Ap stars were secondaries, or in Supernovae exploding in young clusters. Secondary processes, e.g. spontaneous fission or nuclear reactions with highly abundant fission products, may occur further with the r-processed material in the surface of the Ap stars. The role of these stars to the theory of nucleosynthesis and to nuclear physics is emphasized.

Voids in Irradiated Tungsten and Molybdenum

1969 ◽  
Vol 27 ◽  
pp. 190-191
Author(s):  
Robert C. Rau ◽  
Robert L. Ladd
Keyword(s):  
Melting Point ◽  
Fast Neutron ◽  
Neutron Irradiation ◽  
Elevated Temperatures ◽  
Irradiation Temperature ◽  
The Body ◽  
Face Centered Cubic ◽  
Body Centered Cubic ◽  
Cubic Metals ◽  
Face Centered

Recent studies have shown the presence of voids in several face-centered cubic metals after neutron irradiation at elevated temperatures. These voids were found when the irradiation temperature was above 0.3 Tm where Tm is the absolute melting point, and were ascribed to the agglomeration of lattice vacancies resulting from fast neutron generated displacement cascades. The present paper reports the existence of similar voids in the body-centered cubic metals tungsten and molybdenum.

Nuclear Reactions in Deuterium Titanium

1990 ◽  
Vol 48 (2) ◽  
pp. 134-135
Author(s):  
D.M. Vanderwalker
Keyword(s):  
Nuclear Reactions ◽  
Ion Beam ◽  
Exothermic Reaction ◽  
Pure Titanium ◽  
Fundamental Interest ◽  
Transmission Electron ◽  
Iodide Titanium ◽  
A Cell ◽  
After Hours ◽  
Quantity Of Heat

There is a fundamental interest in electrochemical fusion of deuterium in palladium and titanium since its supposed discovery by Fleischmann and Pons. Their calorimetric experiments reveal that a large quantity of heat is released by Pd after hours in a cell, suggesting fusion occurs. They cannot explain fusion by force arguments, nor can it be an exothermic reaction on the formation of deuterides because a smaller quantity of heat is released. This study examines reactions of deuterium in titanium.Both iodide titanium and 99% pure titanium samples were encapsulated in vacuum tubes, annealed for 2h at 800 °C. The Ti foils were charged with deuterium in a D2SO4 D2O solution at a potential of .45V with respect to a calomel reference junction. Samples were ion beam thinned for transmission electron microscopy. The TEM was performed on the JEOL 200CX.The structure of D charged titanium is α-Ti with hexagonal and fee deuterides.

The evolution of the microstructure of 600 Mev proton irradiated materials

1990 ◽  
Vol 48 (4) ◽  
pp. 1002-1003
Author(s):  
R. Gotthardt ◽  
A. Horsewell ◽  
F. Paschoud ◽  
S. Proennecke ◽  
M. Victoria
Keyword(s):  
Nuclear Reactions ◽  
Dislocation Loops ◽  
Defect Clusters ◽  
Weak Beam ◽  
Stacking Fault Tetrahedra ◽  
Small Defect ◽  
Sufficient Intensity ◽  
Reactor Materials ◽  
Metallic Impurities ◽  
Beam Technique

Fusion reactor materials will be damaged by an intense field of energetic neutrons. There is no neutron source of sufficient intensity at these energies available at present, so the material properties are being correlated with those obtained in irradiation with other irradiation sorces. Irradiation with 600 MeV protons produces both displacement damage and impurities due to nuclear reactions. Helium and hydrogen are produced as gaseous impurities. Other metallic impurities are also created . The main elements of the microstructure observed after irradiation in the PIREX facility, are described in the following paragraphs.A. Defect clusters at low irradiation doses: In specimens irradiated to very low doses (1021-1024 protons.m-2), so that there is no superimposition of contrast, small defect clusters have been observed by the weak beam technique. Detailed analysis of the visible contrast (>0.5 nm diameter) revealed the presence of stacking fault tetrahedra, dislocation loops and a certain number of unidentified clusters . Typical results in Cu and Au are shown in Fig. 1.

On the many-body theory of nuclear reactions

1968 ◽  
Vol 111 (1) ◽  
pp. 392-416 ◽  
Author(s):  
K DIETRICH ◽  
K HARA
Keyword(s):  
Nuclear Reactions ◽  
Many Body ◽  
Many Body Theory ◽  
The Many ◽  
Body Theory

The cross sections for different channels in heavy ion nuclear reactions

1971 ◽  
Vol 32 (1) ◽  
pp. 7-9 ◽  
Author(s):  
J. Galin ◽  
D. Guerreau ◽  
M. Lefort ◽  
X. Tarrago
Keyword(s):  
Cross Sections ◽  
Nuclear Reactions ◽  
Heavy Ion ◽  
The Cross

Euratom R&D Programmes on the Back-End of the Fuel Cycle

2005 ◽  
pp. 84-93
Author(s):  
M. Hugon ◽  
V. P. Bhatnagar ◽  
S. Casalta ◽  
M. Raynal ◽  
S. Webster
Keyword(s):  
Fuel Cycle
Sign in / Sign up

Export Citation Format

Share Document