Modified Mukherjee-Brill prediction model of pressure gradient for multiphase flow in wells

2017 ◽  
Vol 35 (1) ◽  
pp. 103-108
Author(s):  
Yu Lei ◽  
Ruiquan Liao ◽  
Mengxia Li ◽  
Yong Li ◽  
Wei Luo
Keyword(s):  
Multiphase Flow ◽  
Prediction Model ◽  
Pressure Gradient

scholarly journals Improved Aziz Prediction Model of Pressure Gradient for Multiphase Flow in Wells

2016 ◽  
Vol 34 (3) ◽  
pp. 423-428
Author(s):  
Mengxia Li ◽  
Ruiquan Liao ◽  
Wei Luo ◽  
Yong Dong
Keyword(s):  
Multiphase Flow ◽  
Prediction Model ◽  
Pressure Gradient

CFD Simulation of Two-Phase Vertical Annular Flow in Both Upward and Downward Direction in a Small Pipe

2019 ◽  
Author(s):  
Ekhwaiter Abobaker ◽  
Abadelhalim Elsanoose ◽  
John Shirokoff ◽  
Mohammad Azizur Rahman
Keyword(s):  
Film Thickness ◽  
Multiphase Flow ◽  
Pressure Gradient ◽  
Annular Flow ◽  
Cfd Simulation ◽  
Flow Direction ◽  
Flow Behavior ◽  
Two Phase ◽  
Downward Flow ◽  
Disturbance Wave

Abstract Computational fluid dynamics (CFD) simulation is presented to investigate the annular flow behavior in the vertical pipe by using ANSYS Fluent platform 17.2. The study was analyzed complex behavior of annular flow in two cases (upward and downward flow) for different air superficial velocities and range of Reynolds number for water, in order to obtain the effect of orientation flow and increasing superficial gas and liquid velocities on the base film, mean disturbance wave thickness, the average longitudinal size of disturbance wave as well as pressure gradient. For multiphase flow model, the volume of fluid method (VOF) for two-phase flow modelling was used and coupled with RNG k-ε turbulence model to predict fully annular flow structures in the upward and downward flow direction. From CFD simulation results, it is clear to see how increases in air velocity result in reductions in film thickness and increase in pressure gradient. Additionally, the results showed monotonic enhancement of film thickness occurring in tandem with increases in the liquid flow rate. However, due to the effect of gravitational force and interfacial friction, the film thickness and pressure gradient are slightly larger for the upward flow than for the downward flow. The results agree with the recent experimental data that studied the annular flow behavior and pressure drop in the upward and downward flow direction. This study will be very helpful in understanding multiphase flow behavior in natural gas wells.

Pressure Gradient Prediction of Multiphase Flow in Pipes

2014 ◽  
Vol 4 (35) ◽  
pp. 4945-4958 ◽  
Author(s):  
A. Sarah ◽  
U. Julius ◽  
Onuegbu Mary-Ann
Keyword(s):  
Multiphase Flow ◽  
Pressure Gradient

scholarly journals A Study of Pressure Gradient in Multiphase Flow in Vertical Pipes

2019 ◽  
Vol 4 (1) ◽  
pp. 54-59
Author(s):  
David Nwobisi Wordu ◽  
Felix J. K. Ideriah ◽  
Barinyima Nkoi
Keyword(s):  
Pressure Drop ◽  
Multiphase Flow ◽  
Pressure Gradient ◽  
Performance Optimization ◽  
Field Data ◽  
Oil And Gas ◽  
Liquid Velocity ◽  
Petroleum Industry ◽  
Well Performance ◽  
Flowing Fluid

The study of multiphase flow in vertical pipes is aimed at effective and accurate design of tubing, surface facilities and well performance optimization for the production of oil and gas in the petroleum industry by developing a better approach for predicting pressure gradient. In this study, field data was analyzed using mathematical model, multiphase flow correlations, statistical model, and computer programming to predict accurately the flow regime, liquid holdup and pressure drop gradient which are important in the optimization of well. A Computer programme was used to prediction pressure drop gradient. Four dimensionless parameters liquid velocity number (Nlv), gas velocity number (Ngv), pipe diameter number (Nd), liquid viscosity number (Nl), were chosen because they represent an integration of the two dominant components that influence pressure drop in pipes. These dominant component are flow channel/media and the flowing fluid. The model was found to give a fit of 100% to the selected data points. Hagedorn & Brown, Griffith &Wallis correlations and model were compared with field data and the overall pressure gradient for a total depth of 10000ft was predicted. The predicted pressure gradient measured was found to be 0.320778psi/ft, Graffith& Wallis gave 0.382649Psi/ft, Hagedorn & Brown gave 0.382649Psi/ft; whereas generated model gave 0.271514Psi/ft. These results indicate that the model equation generated is better and leads to a reasonably accurate prediction of pressure drop gradient according to measured pressure gradient.

scholarly journals A New Method for Predicting Pressure Gradient in Multiphase Flow Systems.

1994 ◽  
Vol 37 (2) ◽  
pp. 147-154
Author(s):  
A. BAYOUMI ◽  
N. EL-EMAM ◽  
A. EL-ASSAL
Keyword(s):  
Multiphase Flow ◽  
Pressure Gradient ◽  
New Method ◽  
Flow Systems

Effect of Drag-Reducing Agents in Multiphase Flow Pipelines

1998 ◽  
Vol 120 (1) ◽  
pp. 15-19 ◽  
Author(s):  
C. Kang ◽  
R. M. Vancko ◽  
A. S. Green ◽  
H. Kerr ◽  
W. P. Jepson
Keyword(s):  
Multiphase Flow ◽  
Pressure Gradient ◽  
Slug Flow ◽  
Annular Flow ◽  
Flow Regimes ◽  
Reducing Agents ◽  
Pressure Gradients ◽  
Horizontal Pipes ◽  
Flow Pressure ◽  
Inclined Pipes

The effect of drag-reducing agents (DRA) on pressure gradient and flow regime has been studied in horizontal and 2-deg upward inclined pipes. Experiments were conducted for different flow regimes in a 10-cm i.d., 18-m long plexiglass system. The effectiveness of DRA was examined for concentrations ranging from 0 to 75 ppm. Studies were done for superficial liquid velocities between 0.03 and 1.5 m/s and superficial gas velocities between 1 and 14 m/s. The results indicate that DRA was effective in reducing the pressure gradients in single and multiphase flow. The DRA was more effective for lower superficial liquid and gas velocities for both single and multiphase flow. Pressure gradient reductions of up to 42 percent for full pipe flow, 81 percent for stratified flow, and 35 percent for annular flow were achieved in horizontal pipes. In 2 deg upward inclination, the pressure gradient reduction for slug flow, with a concentration of 50 ppm DRA, was found to be 28 and 38 percent at superficial gas velocities of 2 and 6 m/s, respectively. Flow regimes maps with DRA were constructed in horizontal pipes. Transition to slug flow with addition of DRA was observed to occur at higher superficial liquid velocities.

A Note on Mixture Density Using the Shannak Definition

2015 ◽  
Vol 1 (1) ◽  
Author(s):  
M. M. Awad
Keyword(s):  
Multiphase Flow ◽  
Pressure Gradient ◽  
Froude Number ◽  
Liquid Density ◽  
Dimensionless Numbers ◽  
Two Phase ◽  
Phase Density ◽  
Mixture Density ◽  
Circular Pipes ◽  
Definition Of

In this study, a note on mixture density using the Shannak definition of the Froude number is presented (Shannak, B., 2009, “Dimensionless Numbers for Two-Phase and Multiphase Flow,” Proceedings of the International Conference on Applications and Design in Mechanical Engineering (ICADME), Penang, Malaysia, Oct. 11–13, 2009). From the definition of the two-phase Froude number, an expression of the two-phase density is obtained. The definition of the two-phase density can be used to compute the two-phase frictional pressure gradient using the homogeneous modeling approach in circular pipes, minichannels, and microchannels. We cannot have gas density≤two-phase density≤liquid density for 0≤mass quality≤1. Therefore, attention must be paid when using the obtained expression of the two-phase density in this note at any x value.

scholarly journals Air permeability of polyester nonwoven fabrics

2015 ◽  
Vol 15 (1) ◽  
pp. 8-12 ◽  
Author(s):  
Guocheng Zhu ◽  
Dana Kremenakova ◽  
Yan Wang ◽  
Jiri Militky
Keyword(s):  
Prediction Model ◽  
Pressure Gradient ◽  
Air Permeability ◽  
Woven Fabrics ◽  
Experimental Results ◽  
Hydraulic Radius ◽  
Nonwoven Fabrics ◽  
Model Based ◽  
Experimental Values

Abstract Air permeability is one of the most important properties of non-woven fabrics in many applications. This paper aims to investigate the effects of thickness, porosity and density on the air permeability of needle-punched non-woven fabrics and compare the experimental values with two models which are based on hydraulic radius theory and drag theory, respectively. The air permeability of the samples was measured by an air permeability tester FX3300. The results showed that the air permeability of non-woven fabrics decreased with the increase in thickness and density of samples, increased with the increase of porosity, and the air permeability was not directly proportional to the pressure gradient. Meanwhile, the prediction model based on hydraulic radius theory had a better agreement with experimental values than the model based on drag theory, but the values were much higher than the experimental results, especially for higher porosity and higher pressure gradient.

scholarly journals Engineering Simulation Tests on Multiphase Flow in Middle- and High-Yield Slanted Well Bores

Energies ◽  
2018 ◽  
Vol 11 (10) ◽  
pp. 2591 ◽  
Author(s):  
Dan Qi ◽  
Honglan Zou ◽  
Yunhong Ding ◽  
Wei Luo ◽  
Junzheng Yang
Keyword(s):  
Multiphase Flow ◽  
Prediction Model ◽  
Flow Pattern ◽  
Pipe Flow ◽  
Slug Flow ◽  
High Yield ◽  
Transition Flow ◽  
Liquid Holdup ◽  
Flow Pattern Map ◽  
Flow Pressure

Previous multiphase pipe flow tests have mainly been conducted in horizontal and vertical pipes, with few tests conducted on multiphase pipe flow under different inclined angles. In this study, in light of mid–high yield and highly deviated wells in the Middle East and on the basis of existent multiphase flow pressure research on well bores, multiphase pipe flow tests were conducted under different inclined angles, liquid rates, and gas rates. A pressure prediction model based on Mukherjee model, but with new coefficients and higher accuracy for well bores in the study block, was obtained. It was verified that the newly built pressure drawdown prediction model tallies better with experimental data, with an error of only 11.3%. The effect of inclination, output, and gas rate on the flow pattern, liquid holdup, and friction in the course of multiphase flow were analyzed comprehensively, and six kinds of classical flow regime maps were verified with this model. The results showed that for annular and slug flow, the Mukherjee flow pattern map had a higher accuracy of 100% and 80–100%, respectively. For transition flow, Duns and Ros flow pattern map had a higher accuracy of 46–66%.

Sign in / Sign up

Export Citation Format

Share Document