Determination of phase characteristics for PVDF membrane hydrophones in the frequency range 1-100 MHz using nonlinear acoustics approach

2021 ◽  
Author(s):  
Gaurav Gandhi
Keyword(s):  
Nonlinear Acoustics ◽  
Frequency Range ◽  
Pvdf Membrane

scholarly journals Nonlinear acoustics determination of phase characteristics of PVDF membrane hydrophones

2011 ◽  
Vol 279 ◽  
pp. 012001 ◽  
Author(s):  
Philip E Bloomfield ◽  
Gaurav Gandhi ◽  
Peter A Lewin
Keyword(s):  
Nonlinear Acoustics ◽  
Pvdf Membrane

Research of the Wood’s Alloy Crystallization Process Using the Acoustic Method

2021 ◽  
Vol 410 ◽  
pp. 855-861
Author(s):  
Aleksandr Yu. Yaroslavkin ◽  
Eugene A. Tyurin ◽  
Darya A. Melnikova
Keyword(s):  
Speed Of Sound ◽  
Crystallization Process ◽  
Ultrasonic Method ◽  
Single Pulse ◽  
Acoustic Method ◽  
The State ◽  
Sound Signal ◽  
Frequency Range ◽  
Wood’S Alloy

The article examines the process of crystallization of Wood alloy using the ultrasonic method. The dependence of the determination of the speed of sound in three aggregate states of the alloy (liquid, solid, transition (liquid-solid)) was derived. The relation-ship with the amplitude values of the sound signal, a single pulse in determining the speed of sound, as well as in determining the state of the alloy is carried out. The data obtained allow us to analyze the state of the alloy and the measurement time and the specified frequency range directly in the process of crystallization.

Method of Testing of Sound Absorption Properties of Materials Intended for Ultrasonic Noise Protection

2013 ◽  
Vol 38 (2) ◽  
pp. 191-195 ◽  
Author(s):  
Dariusz Pleban
Keyword(s):  
Sound Absorption ◽  
Free Field ◽  
Tone Burst ◽  
Mineral Wool ◽  
Frequency Range ◽  
Absorption Properties ◽  
Open Cell Foam ◽  
Properties Of Materials ◽  
Cell Foam

Abstract Efficient ultrasonic noise reduction by using enclosures requires the knowledge of absorbing properties of materials in the frequency range above 4 kHz. However, standardized methods enable determination of absorption coefficients of materials in the frequency range up to 4 kHz. For this reason, it is proposed to carry out measurements of the sound absorption properties of materials in the free field by means of a tone-burst technique in the frequency range from 4 kHz to 40 kHz at angles of incidence varying from 0° to 60°. The absorption coefficient of a material is calculated from the reflection coefficient obtained by reflecting a tone-burst from both a perfectly reflecting panel and a combination of this panel and the sample of the tested material. The tests results show that mineral wool and polyurethane open-cell foam possess very good absorbing properties in this frequency range.

Determination of Electric and Magnetic Properties of Commercial LTCC Soft Ferrite Material

2011 ◽  
Vol 8 (1) ◽  
pp. 1-9 ◽  
Author(s):  
Nelu Blaž ◽  
Andrea Marić ◽  
Goran Radosavljević ◽  
Nebojša Mitrović ◽  
Ibrahim Atassi ◽  
...  
Keyword(s):  
Electrical Properties ◽  
Low Frequency ◽  
Hysteresis Loops ◽  
Frequency Range ◽  
Dispersion Parameters ◽  
Simple Method ◽  
Component Design ◽  
Microwave Engineering ◽  
Characterization Procedure

This paper offers an effective, accurate, and simple method for permittivity and permeability determination of an LTCC (low temperature cofired ceramic) ferrite sample. The presented research can be of importance in the fields of ferrite component design and application, as well as for RF and microwave engineering. The characterization sample is a stack of LTCC tapes forming a toroid. Commercially available ferrite tape ESL 40012 was used and standard LTCC processing was applied for the sample fabrication. For the first time, the electrical properties of a ferrite toroid sample of ESL 40012 LTCC ferrite tape is presented at various frequencies. The electrical properties of LTCC ferrite materials, permittivity and specific resistivity, are shown in a frequency range from 10 kHz to 1 MHz using the capacitive method. The hysteresis properties of this material are also determined. B-H hysteresis loops were measured applying a maximum excitation of 2 kA/m and frequencies of 50 Hz, 500 Hz, and 1000 Hz. Permeability is determined in the frequency range from 10 kHz to 1 GHz and a characterization procedure is divided in two segments, for low and high frequencies. Low frequency measurements (from 10 kHz to 1 MHz) are performed using LCZ meter and discrete turns of wire, while a short coaxial sample holder and vector network analyzer were used for the higher frequency range (from 300 kHz to 1 GHz). In addition, another important factor required for the practical design of devices is presented, the temperature variation of the permeability dispersion parameters.

scholarly journals STUDY OF PROCESSES OF PRESSURE AND IMPULSE FREQUENCY INFLUENCE ON PENETRATION OF LIQUIDS IN THE SAND SAMPLES

2016 ◽  
pp. 120-125
Author(s):  
M. Ya. Habibullin ◽  
R. R. Shangareyev
Keyword(s):  
Experimental Data ◽  
Oil Recovery ◽  
Pressure Fluctuations ◽  
Experimental Studies ◽  
Regression Equations ◽  
Linear Variation ◽  
Frequency Range ◽  
Impulse Frequency ◽  
Overburden Pressure

The article deals with the issues related to the hydrocarbon reservoirs oil recovery enhancement. It describes the bench laboratory experimental studies. The results obtained during determination of fluid leakage through the rock samples and the amount of absorption of pressure fluctuations at various regime parameters are presented. Using the experimental data the regression analysis was performed on the basis of which the qualitative correlations between factorial and resultant features were identified. Using the regression equations the graphic relations were constructed. It was found that with increasing the oscillation frequency of the fluid the amount of fluid passing through the sample of porous medium increased, with the highest value of q reached at the frequency range of 600 ... 1000 Hz. With increase in the oscillations penetration depth the absorption of the amplitude of the pressure fluctuations corresponds to the linear decrease, and with the overburden pressure increase the linear variation of absorption is distorted.

scholarly journals Snow Stratigraphy and Water Equivalence Measured With an Active Microwave System

1980 ◽  
Vol 26 (94) ◽  
pp. 225-233
Author(s):  
D. A. Ellerbruch ◽  
H. S. Boyne
Keyword(s):  
Electromagnetic Scattering ◽  
Direct Determination ◽  
Snow Pack ◽  
Frequency Range ◽  
Microwave Radar ◽  
Snow Stratigraphy ◽  
Microwave System ◽  
The Relationship ◽  
System Operating

AbstractThis paper reports on research on the relationship between the electromagnetic scattering properties and physical properties of snow-pack. An FM-CW active microwave radar system operating in the frequency range 8-12 GHz is used to scatter electromagnetic radiation from surface and subsurface stratigraphic layers in the snow-pack. The amplitude of the scattered radiation as a function of depth in the snow-pack can be correlated with such physical characteristics as density, hardness, stratigraphy, and moisture content. A direct determination of snow-pack water equivalence can be made from these observations.

Sign in / Sign up

Export Citation Format

Share Document