The 29 September 1969, Ceres, South Africa, Earthquake: Full Waveform Moment Tensor Inversion for Point Source and Kinematic Source Parameters

2014 ◽  
Vol 104 (1) ◽  
pp. 576-581 ◽  
Author(s):  
F. Kruger ◽  
F. Scherbaum
Keyword(s):  
South Africa ◽  
Point Source ◽  
Moment Tensor ◽  
Source Parameters ◽  
Moment Tensor Inversion ◽  
Full Waveform

scholarly journals The waveform inversion of mainshock and aftershock data of the 2006 M6.3 Yogyakarta earthquake

2021 ◽  
Vol 8 (1) ◽  
Author(s):  
Hijrah Saputra ◽  
Wahyudi Wahyudi ◽  
Iman Suardi ◽  
Ade Anggraini ◽  
Wiwit Suryanto
Keyword(s):  
Joint Inversion ◽  
Body Wave ◽  
Moment Tensor ◽  
Near Field ◽  
Source Parameters ◽  
Waveform Inversion ◽  
Moment Tensor Inversion ◽  
Slip Distribution ◽  
Aftershock Distribution ◽  
Velocity Models

AbstractThis study comprehensively investigates the source mechanisms associated with the mainshock and aftershocks of the Mw = 6.3 Yogyakarta earthquake which occurred on May 27, 2006. The process involved using moment tensor inversion to determine the fault plane parameters and joint inversion which were further applied to understand the spatial and temporal slip distributions during the earthquake. Moreover, coseismal slip distribution was overlaid with the relocated aftershock distribution to determine the stress field variations around the tectonic area. Meanwhile, the moment tensor inversion made use of near-field data and its Green’s function was calculated using the extended reflectivity method while the joint inversion used near-field and teleseismic body wave data which were computed using the Kikuchi and Kanamori methods. These data were filtered through a trial-and-error method using a bandpass filter with frequency pairs and velocity models from several previous studies. Furthermore, the Akaike Bayesian Information Criterion (ABIC) method was applied to obtain more stable inversion results and different fault types were discovered. Strike–slip and dip-normal were recorded for the mainshock and similar types were recorded for the 8th aftershock while the 9th and 16th June were strike slips. However, the fault slip distribution from the joint inversion showed two asperities. The maximum slip was 0.78 m with the first asperity observed at 10 km south/north of the mainshock hypocenter. The source parameters discovered include total seismic moment M0 = 0.4311E + 19 (Nm) or Mw = 6.4 with a depth of 12 km and a duration of 28 s. The slip distribution overlaid with the aftershock distribution showed the tendency of the aftershock to occur around the asperities zone while a normal oblique focus mechanism was found using the joint inversion.

Source parameter determination of local earthquakes in Korea using moment tensor inversion of single station data

1999 ◽  
Vol 89 (4) ◽  
pp. 1077-1082 ◽  
Author(s):  
So Gu Kim ◽  
Nadeja Kraeva
Keyword(s):  
Moment Tensor ◽  
Source Parameters ◽  
Moment Tensor Inversion ◽  
P Wave ◽  
Parameter Determination ◽  
Reverse Fault ◽  
3D Tomography ◽  
Single Station ◽  
Slip Event

Abstract The purpose of this investigation is to determine source parameters such as focal mechanism, seismic moment, moment magnitude, and source depth from recent small earthquakes in the Korcan Peninsula using broadband records of three-component single station. It is very important and worthwhile to use a three-component single station in Korea because for most Korean earthquakes it is not possible to read enough first motions of P-wave arrivals because of the poor coverage of the seismic network and the small size (ML 5.0 or less) of the events. Furthermore the recent installation of the very broadband seismic stations in Korea and use of a 3D tomography technique can enhance moment tensor inversion to determine the source parameters of small earthquakes (ML 5.0 or less) that occur at near-regional distances (Δ ≤ 500 km). The focal solution for the Youngwol earthquake of 13 December 1996 is found to be a right-lateral strike slip event with a NE strike, and the Kyongju earthquake of 25 June 1997 is found to be an oblique reverse fault with a slight component of left-lateral slip in the SE direction.

Inversion of teleseismic body waves for the moment tensor of the 1978 Thessaloniki, Greece, earthquake

1981 ◽  
Vol 71 (5) ◽  
pp. 1423-1444
Author(s):  
Jeffrey S. Barker ◽  
Charles A. Langston
Keyword(s):  
Point Source ◽  
Moment Tensor ◽  
Source Parameters ◽  
Source Model ◽  
Body Waves ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Initial Rupture ◽  
Short Period ◽  
The Moment

abstract Seismograms from WWSSN and Canadian network stations were modeled to determine the source parameters of the 20 June 1978 Thessaloniki, Greece, earthquake (Ms = 6.4). The depth of the initial rupture was constrained to 11 ± 1 km by comparison of the arrival times of surface reflections with synthetic short-period seismograms. A focal sphere plot of first motion polarities provided little constraint on other focal parameters, except to indicate that predominantly normal faulting was involved. A generalized inverse technique utilizing the moment tensor formalism was applied to teleseismic P and SH waves for six increments of depth. The moment tensor obtained indicated a nearly horizontal, N-trending tension axis and a nearly vertical compression axis, and yielded the following double-couple source parameters: strike 280° ± 7°; dip 55° ± 3°; rake −65° ± 5°; seismic moment 5.7 × 1025 dyne-cm; and a skewed triangular source time function with a rise time of about 1 sec and duration of 6 to 8 sec. Due to indications of multiple or finite source effects for this event, and the assumption in the moment tensor formalism of a point source, a low-pass filter was applied to the data and the inversions were repeated. The results were nearly identical with those of the original inversion, suggesting that any individual sources had similar mechanisms, or that the point source model is sufficient for this earthquake.

scholarly journals The waveform inversion of mainshock and aftershock data of the 2006 M6.3 Yogyakarta earthquake

2021 ◽  
Author(s):  
Hijrah Saputra ◽  
Wahyudi Wahyudi ◽  
Iman Suardi ◽  
Ade Anggraini ◽  
Wiwit Suryanto
Keyword(s):  
Joint Inversion ◽  
Body Wave ◽  
Moment Tensor ◽  
Near Field ◽  
Source Parameters ◽  
Moment Tensor Inversion ◽  
Slip Distribution ◽  
Coseismic Slip ◽  
Aftershock Distribution ◽  
Velocity Models

Abstract This study comprehensively investigates the source mechanisms associated with the mainshock and aftershocks of the Yogyakarta earthquake of magnitude Mw = 6.3 on May 27, 2006. Therefore, this study is to provide a more precise answer to the controversial source mechanism. This study uses moment tensor inversion to obtain fault plane parameters and joint inversion to obtain spatial and temporal slip distributions during an earthquake. The coseismic slip distribution is overlaid with the relocated aftershock distribution to see the stress field variations around the tectonic area of the study. Moment tensor inversion uses near-field data, and joint inversion uses near-field and teleseismic body wave data. The data is filtered by trial and error using a bandpass filter with frequency pairs and velocity models from several previous studies. The green's function for moment tensor inversion calculated using the extended reflectivity method and joint inversion computed using the Kikuchi and Kanamori methods. In this study, we apply the Akaike Bayesian Information Criterion (ABIC) method to obtain more stable inversion results. The results of the mainshock and aftershock moment tensor inversion show different fault types. The mainshock fault types are strike-slip and dip-normal types, while the 8th aftershock is of the same type as the mainshock, while the 9th and 16th June are strike slips. The joint inversion results show two asperities. The maximum slip is 0.78 m, with the first asperity 10 km south of the mainshock and the second asperity 10 km north of the mainshock. The obtained source parameters are total seismic moment M0 = 0.4311E + 19 (Nm) or Mw = 6.4, with a source depth of 12 km and a source duration of 28 seconds. Slip distribution overlay with aftershock distribution shows compatibility. The type of focus mechanism that results from this joint inversion is the oblique.

Sign in / Sign up

Export Citation Format

Share Document