Earthquake Ground Motion and 3D Georgia Basin Amplification in Southwest British Columbia: Shallow Blind-Thrust Scenario Earthquakes

2014 ◽  
Vol 104 (1) ◽  
pp. 321-335 ◽  
Author(s):  
S. Molnar ◽  
J. F. Cassidy ◽  
K. B. Olsen ◽  
S. E. Dosso ◽  
J. He
2020 ◽  
Vol 110 (6) ◽  
pp. 2862-2881
Author(s):  
Arthur J. Rodgers ◽  
Arben Pitarka ◽  
Ramesh Pankajakshan ◽  
Bjorn Sjögreen ◽  
N. Anders Petersson

ABSTRACT Large earthquake ground-motion simulations in 3D Earth models provide constraints on site-specific shaking intensities but have suffered from limited frequency resolution and ignored site response in soft soils. We report new regional-scale 3D simulations for moment magnitude 7.0 scenario earthquakes on the Hayward Fault, northern California with SW4. Simulations resolved significantly broader band frequencies (0–10 Hz) than previous studies and represent the highest resolution simulations for any such earthquake to date. Seismic waves were excited by a kinematic rupture following Graves and Pitarka (2016) and obeyed wave propagation in a 3D Earth model with topography from the U.S. Geological Survey (USGS) assuming a minimum shear wavespeed, VSmin, of 500  m/s. We corrected motions for linear and nonlinear site response for the shear wavespeed, VS, from the USGS 3D model, using a recently developed ground-motion model (GMM) for Fourier amplitude spectra (Bayless and Abrahamson, 2018, 2019a). At soft soil locations subjected to strong shaking, the site-corrected intensities reflect the competing effects of linear amplification by low VS material, reduction of stiffness during nonlinear deformation, and damping of high frequencies. Sites with near-surface VS of 500  m/s or greater require no linear site correction but can experience amplitude reduction due to nonlinear response. Averaged over all sites, we obtained reasonable agreement with empirical ergodic median GMMs currently used for seismic hazard and design ground motions (epsilon less than 1), with marked improvement at soft sedimentary sites. At specific locations, the simulated shaking intensities show systematic differences from the GMMs that reveal path and site effects not captured in these ergodic models. Results suggest how next generation regional-scale earthquake simulations can provide higher spatial and frequency resolution while including effects of soft soils that are commonly ignored in scenario earthquake ground-motion simulations.


2021 ◽  
Vol 21 (2) ◽  
Author(s):  
Piotr Adam Bońkowski ◽  
Juliusz Kuś ◽  
Zbigniew Zembaty

AbstractRecent research in engineering seismology demonstrated that in addition to three translational seismic excitations along x, y and z axes, one should also consider rotational components about these axes when calculating design seismic loads for structures. The objective of this paper is to present the results of a seismic response numerical analysis of a mine tower (also called in the literature a headframe or a pit frame). These structures are used in deep mining on the ground surface to hoist output (e.g. copper ore or coal). The mine towers belong to the tall, slender structures, for which rocking excitations may be important. In the numerical example, a typical steel headframe 64 m high is analysed under two records of simultaneous rocking and horizontal seismic action of an induced mine shock and a natural earthquake. As a result, a complicated interaction of rocking seismic effects with horizontal excitations is observed. The contribution of the rocking component may sometimes reduce the overall seismic response, but in most cases, it substantially increases the seismic response of the analysed headframe. It is concluded that in the analysed case of the 64 m mining tower, the seismic response, including the rocking ground motion effects, may increase up to 31% (for natural earthquake ground motion) or even up to 135% (for mining-induced, rockburst seismic effects). This means that not only in the case of the design of very tall buildings or industrial chimneys but also for specific yet very common structures like mine towers, including the rotational seismic effects may play an important role.


2009 ◽  
Vol 1193 ◽  
Author(s):  
Taishi Oouchi ◽  
Hiroyuki Tsuchi ◽  
Tetsuya Ota ◽  
Koji Hane ◽  
Toru Sasaki

AbstractAccording to recent seismic observation records, there are some cases where unexpectedly large seismic motion was observed deep underground and that was larger than at the surface. The factors influencing such phenomena are assumed to be deep geological structures with topographic irregularity, velocity structure and non-linearity of subsurface layers. These factors should be taken into account in the earthquake-resistant design of a geological repository. The influence of a deep underground geological structure with topographic irregularity on ground motion has been studied and it has been confirmed that such a structure have a significant impact on ground motion and the constructive interference of waves may result in strong earthquake ground motion in the vicinity of a structural boundary deep underground.


Sign in / Sign up

Export Citation Format

Share Document