Grout curtain at the old Billingsgate Market

1994 ◽  
pp. 15-23
Author(s):  
Sergio Solera ◽  
Barry Lehane
Keyword(s):  
2012 ◽  
Vol 46 (2) ◽  
pp. 341-357 ◽  
Author(s):  
S. M. Sadeghiyeh ◽  
M. Hashemi ◽  
R. Ajalloeian
Keyword(s):  

Hydrology ◽  
2019 ◽  
Vol 6 (3) ◽  
pp. 71
Author(s):  
Kambiz Meshkabadi ◽  
Yousef Zandi

Design of earth dams and their issues during and after construction is very important for residents downstream of the dam because of the potential risks and possible breakdowns. In the design of dams, various forces influence the dam body, including uplift pressure and piping phenomenon which should be considered in order to ensure the safety of the dam. Among the measures taken to prevent the washing away phenomenon, the reduction of the output gradient, and the leakage discharge from beneath the hydraulic structures, construction of the grout curtain and installation of the drainage are applicable. Therefore, in order to investigate the effect of various parameters such as the gradient angle of the grout curtain, length, and distance and the number of grout curtains, as well as the length of the drainage on the pressure and output gradient of the numerical models, were considered in current study. For this purpose, the SEEP/W software was used for modeling on Sattarkhan Dam as a case study. The results of the analysis showed that the use of the Qa’im grout curtain at the upstream of the dam has the highest resistance against the pressure and piping phenomenon. The results also showed that increase in the length of the curtain of the water seal increases safety against uplift and piping phenomenon. The use of further spacing between the two grout curtains under the core of the dam led to increase in overall pressure or reduction in safety against uplift pressure. Increase in the length of the horizontal drainage reduced the effects of uplift pressure and output gradient. Results show that period of 70 to 110 degree is appropriate for curtain angle and setting curtain in upstream of dam core with angle of 70 to 80 degree is optimum and economic. A length of 30 m is optimum for curtain. The number of 2 curtains is also optimum. Studying various scenarios of distance of 2 curtains in dam core indicates that distance of 6 m is optimum and also length of 18 m for horizontal drainage is optimum.


2013 ◽  
Vol 13 (8) ◽  
pp. 2041-2052 ◽  
Author(s):  
T. Roje-Bonacci ◽  
O. Bonacci

Abstract. The Ombla Spring represents a typical abundant coastal karst spring located in the vicinity of the town of Dubrovnik (Croatia). Its outlet is at an altitude of 2.5 m above sea level (m a.s.l.) and the water from it immediately flows into the Adriatic Sea. The minimum and maximum measured discharges are 3.96 m3 s−1 and 117 m3 s−1, respectively. The Trebišnjica River traverses through its catchment. The mean annual discharge, after the canalization of over 60 km of its watercourse with spray concrete (in the time span 1981–2011), is 24.05 m3 s−1. Before massive civil engineering work which took place during 1968–1980, the mean annual discharge was 28.35 m3 s−1. There is a project for construction of the hydro-electric power plant (HEPP) Ombla, which will exclusively use groundwater from the Ombla Spring karst aquifer. The underground dam will be constructed about 200 m behind the existing karst spring outflow in the karst massif, by injecting a grout curtain. The top of the grout curtain is planned to be at an altitude of 130 m a.s.l. This karst system is complex, sensitive, vulnerable and ecologically extremely valuable. The grout curtain, as well as the HEPP Ombla development, could lead to extremely dangerous technical and environmental consequences. In this paper some probable, negative consequences of the HEPP Ombla construction and development are explained. The HEPP Ombla could result in many large and hard-to-predict negative consequences which are specific for this particular HEPP, for example (1) severe spring discharge change; (2) unpredictable regional groundwater redistribution; (3) threatening of endemic fauna; (4) induced seismicity; (5) induced sinkholes; (6) occurrence of landslides; (7) conflict regarding internationally shared karst aquifers; (8) intensification of karst flash floods; (9) sea water intrusion in coastal karst aquifer; etc.


1986 ◽  
Vol 20 (9) ◽  
pp. 539-542
Author(s):  
I. S. Ronzhin ◽  
L. E. Kanygin ◽  
V. N. Chernenko ◽  
P. P. Listrovoi ◽  
F. G. Kim
Keyword(s):  

2009 ◽  
Vol 2 (5) ◽  
pp. 421-429 ◽  
Author(s):  
Johannes Linortner ◽  
Gerald Jung ◽  
Gerald Zenz

2000 ◽  
Vol 22 ◽  
Author(s):  
Cristian Marunteanu ◽  
Ion Durdun

A model of engineering geological classification and zoning of the Scorillo Dam site in Romania is proposed to optimise the design of the dam and of the grout curtain. The rock mass was classified into four categories: from 1 (good) to 4 (very poor), according to the rock mass quality (RMQ) at the dam site. Parameters available and used to determine the RMQ were lithology, degree of weathering and fragmentation, rock quality designation (RQD), and modulus of elasticity (E). Based on the study, a new design of the dam, its slopes, and the grout curtain was carried out.


Sign in / Sign up

Export Citation Format

Share Document