DROP-SIZE DISTRIBUTIONS AND HEAT TRANSFER IN DROPWISE CONDENSATION - CONDENSATION COEFFICIENT OF WATER AT LOW PRESSURES

1986 ◽  
Author(s):  
Hiroaki Tanaka ◽  
Shigeo Hatamiya
Keyword(s):  
Heat Transfer ◽  
Drop Size ◽  
Size Distributions ◽  
Dropwise Condensation ◽  
Condensation Coefficient ◽  
Drop Size Distributions ◽  
Low Pressures

Measurements of Drop-Size Distributions During Transient Dropwise Condensation

1975 ◽  
Vol 97 (3) ◽  
pp. 341-346 ◽  
Author(s):  
H. Tanaka
Keyword(s):  
Drop Size ◽  
Vertical Surface ◽  
Size Distributions ◽  
Dropwise Condensation ◽  
Drop Size Distributions ◽  
Bare Surface

Instantaneous drop-size distributions were measured during transient dropwise condensation onto an initially bare surface which forms the constituent process of the so-called steady dropwise condensation on a vertical surface. The measured distributions agreed satisfactorily with the prediction from the previous author’s theory.

Influence of Surface Wettability on Dropwise Condensation Heat Transfer

2011 ◽  
Vol 228-229 ◽  
pp. 869-873
Author(s):  
Yun Fu Chen
Keyword(s):  
Heat Transfer ◽  
Contact Angle ◽  
Surface Wettability ◽  
Condensation Heat Transfer ◽  
Size Distributions ◽  
Dropwise Condensation ◽  
Number Density ◽  
Drop Radius ◽  
Proposed Model ◽  
Drop Size Distributions

For finding influence of the surface wettability on dropwise condensation heat transfer, a model for dropwise condensation heat transfer has been established based on the drop size distributions and the heat transfer rate through a single drop with considering influence of contact angle to heat transfer. It has been shown based on the proposed model that up to a drop radius of 5μm, the rate of decrease in the drop population density is not as steep as the rate for a drop radius greater than 10μm, because coalescence between drops starts taking place. Varying the contact angle changes the drop distribution; higher the contact angle, lower the departing droplet size and large number density of small droplets. Heat flux first increases and then decreases with increasing contact angle under the temperature difference condition.

Drop-size distributions from pneumatic atomizers

AIChE Journal ◽  
1971 ◽  
Vol 17 (3) ◽  
pp. 575-584 ◽  
Author(s):  
K. Y. Kim ◽  
W. R. Marshall
Keyword(s):  
Drop Size ◽  
Size Distributions ◽  
Drop Size Distributions

scholarly journals Raindrop Size Distribution and Rain Characteristics during the 2013 Great Colorado Flood

2015 ◽  
Vol 17 (1) ◽  
pp. 53-72 ◽  
Author(s):  
Katja Friedrich ◽  
Evan A. Kalina ◽  
Joshua Aikins ◽  
Matthias Steiner ◽  
David Gochis ◽  
...  
Keyword(s):  
Drop Size ◽  
Doppler Radar ◽  
Liquid Water Content ◽  
Size Distributions ◽  
Intense Rainfall ◽  
Wind Fields ◽  
Raindrop Size Distribution ◽  
Median Volume ◽  
Drop Size Distributions ◽  
Analysis System

Abstract Drop size distributions observed by four Particle Size Velocity (PARSIVEL) disdrometers during the 2013 Great Colorado Flood are used to diagnose rain characteristics during intensive rainfall episodes. The analysis focuses on 30 h of intense rainfall in the vicinity of Boulder, Colorado, from 2200 UTC 11 September to 0400 UTC 13 September 2013. Rainfall rates R, median volume diameters D0, reflectivity Z, drop size distributions (DSDs), and gamma DSD parameters were derived and compared between the foothills and adjacent plains locations. Rainfall throughout the entire event was characterized by a large number of small- to medium-sized raindrops (diameters smaller than 1.5 mm) resulting in small values of Z (<40 dBZ), differential reflectivity Zdr (<1.3 dB), specific differential phase Kdp (<1° km−1), and D0 (<1 mm). In addition, high liquid water content was present throughout the entire event. Raindrops observed in the plains were generally larger than those in the foothills. DSDs observed in the foothills were characterized by a large concentration of small-sized drops (d < 1 mm). Heavy rainfall rates with slightly larger drops were observed during the first intense rainfall episode (0000–0800 UTC 12 September) and were associated with areas of enhanced low-level convergence and vertical velocity according to the wind fields derived from the Variational Doppler Radar Analysis System. The disdrometer-derived Z–R relationships reflect how unusual the DSDs were during the 2013 Great Colorado Flood. As a result, Z–R relations commonly used by the operational NEXRAD strongly underestimated rainfall rates by up to 43%.

scholarly journals On the Shape–Slope Relation of Drop Size Distributions in Convective Rain

2005 ◽  
Vol 44 (7) ◽  
pp. 1146-1151 ◽  
Author(s):  
Axel Seifert
Keyword(s):  
Size Distribution ◽  
Gamma Distribution ◽  
Drop Size ◽  
Empirical Relation ◽  
Size Distributions ◽  
Shape Parameters ◽  
Raindrop Size Distribution ◽  
Raindrop Size ◽  
Drop Size Distributions ◽  
Good Agreement

Abstract The relation between the slope and shape parameters of the raindrop size distribution parameterized by a gamma distribution is examined. The comparison of results of a simple rain shaft model with an empirical relation based on disdrometer measurements at the surface shows very good agreement, but a more detailed discussion reveals some difficulties—for example, deviations from the gamma shape and the overestimation of collisional breakup.

Fuel Leaking Analysis of Fuel Tank by Projectiles Impact with Mechanical Properties of Projectiles

2013 ◽  
Vol 644 ◽  
pp. 203-206
Author(s):  
Hai Liang Cai ◽  
Bi Feng Song ◽  
Yang Pei ◽  
Shuai Shi
Keyword(s):  
High Speed ◽  
Drop Size ◽  
Fuel Tank ◽  
Size Distributions ◽  
Sauter Mean Diameter ◽  
Fuel Droplets ◽  
High Speed Impact ◽  
Fuel Tanks ◽  
Rigid Projectile ◽  
Drop Size Distributions

For making sure the dry bay ignition and fire, it’s necessary to calculate the number and the sizes of the droplets and determine the mass flow rate of the fuel induced by high-speed impact and penetration of a rigid projectile into fuel tank. An analytical model is founded and the method for calculating the initial leaking velocity of the fuel is determined. It gives the equation for calculating the drop size distributions of fuel and the Sauter mean diameter (SMD) of droplets, through the Maximum Entropy Theory and the conservation for mass. Using the Harmon’s equation for SMD,the fuel droplets SMD can be calculated. Results shows that the initial leaking velocity of the fuel is about linearly increasing with the velocity of the projectile, the SMD of fuel droplets increases with the hole size of the fuel tank which induced by the penetration of the projectile and linearly decreases with the velocity of the projectile. The results can be used for the ignition and fire analysis of the dry bay adjacent to fuel tanks.

Sign in / Sign up

Export Citation Format

Share Document