Theoretical Analysis on Bit Error Rate of Visible-Light Variable N-Parallel Code-Shift-Keying

2018 ◽  
Vol E101.A (12) ◽  
pp. 2352-2358 ◽  
Author(s):  
Keisuke OSAWA ◽  
Hiromasa HABUCHI ◽  
Yusuke KOZAWA
Keyword(s):  
Theoretical Analysis ◽  
Visible Light ◽  
Bit Error Rate ◽  
Error Rate ◽  
Shift Keying ◽  
Parallel Code

An approach to ensure joint illumination & communication performance of a forward error corrected indoor visible light communication (VLC) system in presence of ambient light interference

2020 ◽  
Vol 0 (0) ◽  
Author(s):  
Sourish Chatterjee ◽  
Biswanath Roy
Keyword(s):  
Visible Light ◽  
Bit Error Rate ◽  
Error Rate ◽  
Light Emitting Diode ◽  
Visible Light Communication ◽  
Ambient Light ◽  
Ambient Illumination ◽  
Communication Performance ◽  
Light Interference ◽  
Forward Error

AbstractIn recent time of looming radio frequency (RF) spectrum crisis, visible light communication using lighting infrastructure emerged as a potential alternative at an indoor environment. This paper addresses the setback associated with ambient light interference in an indoor Visible Light Communication (VLC) system to ensure joint communication and illumination performance inside an office room. A novel VLC architecture with suitable white light emitting diode (WLED) luminaire arrangement is presented to minimize the dispersion of signal to interference plus noise ratio (SINR) across the room. Luminaires are categorized in two groups viz. data transmitting illuminants and illuminants for lighting purpose. The first group is dedicated to transmit data as well as serves the purpose of illumination. The other set creates only ambient illumination to achieve quality lighting attributes. The proposed forward error corrected receiver configuration discards the ambient light noise originated by the illuminants that serve the ambient illumination. Tail biting convolutional encoder and viterbi decoder are used at the encoding section of the transmitter and decoding section of the receiver respectively to improve bit error rate. Results obtained through MATLAB simulation shows better average bit error rate (BER) in the order of 10−8 measured at uniformly distributed 25 grid points over the working plane. At the same time achieved average horizontal illuminance with good uniformity comply with ISO recommendation.

BlueFlood

2021 ◽  
Vol 2 (4) ◽  
pp. 1-30
Author(s):  
Beshr Al Nahas ◽  
Antonio Escobar-Molero ◽  
Jirka Klaue ◽  
Simon Duquennoy ◽  
Olaf Landsiedel
Keyword(s):  
Experimental Study ◽  
Bit Error Rate ◽  
Error Rate ◽  
Data Dissemination ◽  
Delivery Ratio ◽  
Controlled Experiments ◽  
Seamless Integration ◽  
Peer Communication ◽  
Shift Keying ◽  
University Buildings

Bluetooth is an omnipresent technology, available on billions of devices today. While it has been traditionally limited to peer-to-peer communication and star networks, the recent Bluetooth Mesh standard extends it to multi-hop networking. In addition, the Bluetooth 5 standard introduces new modes to allow for increased reliability. In this article, we evaluate the feasibility of concurrent transmissions (CT) in Bluetooth via modeling and controlled experiments and then devise an efficient network-wide data dissemination protocol, BlueFlood, based on CT for multi-hop Bluetooth networks. First, we model and analyze how CT distorts the received waveform and characterize the Bit Error Rate of a Frequency-Shift Keying receiver to show that CT is feasible over Bluetooth. Second, we verify our analytic results with a controlled experimental study of CT over Bluetooth PHY. Third, we present BlueFlood, a fast and efficient network-wide data dissemination in multi-hop Bluetooth networks. In our experimental evaluation, in two testbeds deployed in university buildings, we show that BlueFlood achieves 99.9% end-to-end delivery ratio with a duty-cycle of 0.4% for periodic dissemination of advertising packets of 38 bytes with 200 milliseconds intervals at 2 Mbps. Moreover, we show that BlueFlood can be received by off-the-shelf devices such as smartphones, paving a seamless integration with existing technologies.

scholarly journals PAPR Reduction of FBMC Signals Based on Uniform and Linear PDF Companding Schemes

2021 ◽  
Author(s):  
Srinivas Ramavath ◽  
Umesh Chandra Samal
Keyword(s):  
Theoretical Analysis ◽  
Bit Error Rate ◽  
Error Rate ◽  
Filter Bank ◽  
Phase Error ◽  
Average Power ◽  
Signal Amplitude ◽  
Papr Reduction ◽  
Basic Model ◽  
Filter Bank Multicarrier

Abstract In this paper, two new companders are designed to reduce the ratio of peak to average power (PAPR) experienced by filter bank multicarrier (FBMC) signals. Specifically, the compander basic model is generalized, which alter the distributed FBMC signal amplitude peak. The proposed companders design approach provides better performance in terms of reducing the PAPR, Bit Error Rate (BER) and phase error degradation over the previously existing compander schemes. Many PAPR reduction approaches, such as the µ-law companding technique, are also available. It results in the formation of spectrum side lobes, although the proposed techniques result in a spectrum with fewer side lobes. The theoretical analysis of linear compander and expander transform for a few specific parameters are derived and analyzed. The suggested linear companding technique is analytically analysed using simulations to show that it efficiently decreases the high peaks in the FBMC system.

scholarly journals Experimental Implementation and Theoretical Investigation of a Vanadium Dioxide Optical Filter for Bit Error Rate Enhancement of Enhanced Space Shift Keying Visible Light Communication Systems

Computation ◽  
2019 ◽  
Vol 7 (2) ◽  
pp. 30 ◽  
Author(s):  
Dimitra K. Manousou ◽  
Argyris N. Stassinakis ◽  
Emmanuel Syskakis ◽  
Hector E. Nistazakis ◽  
Spiros Gardelis ◽  
...  
Keyword(s):  
Visible Light ◽  
Bit Error Rate ◽  
Error Rate ◽  
Vanadium Dioxide ◽  
Background Noise ◽  
Communication Systems ◽  
Optical Filter ◽  
Optical Filters ◽  
Visible Light Communication ◽  
Performance Estimation

Visible Light Communication (VLC) systems use light-emitting diode (LED) technology to provide high-capacity optical links. The advantages they offer, such as the high data rate and the low installation and operational cost, have identified them as a significant solution for modern networks. However, such systems are vulnerable to various exogenous factors, with the background sunlight noise having the greatest impact. In order to reduce the negative influence of the background noise effect, optical filters can be used. In this work, for the first time, a low-cost optical vanadium dioxide (VO2) optical filter has been designed and experimentally implemented based on the requirements of typical and realistic VLC systems in order to significantly increase their performance by reducing the transmittance of background noise. The functionality of the specific filter is investigated by means of its bit error rate (BER) performance estimation, taking into account its experimentally measured characteristics. Numerous results are provided in order to prove the significant performance enhancement of the VLC systems which, as it is shown, reaches almost six orders of magnitude in some cases, using the specific experimental optical filter.

scholarly journals A Full-Duplex LED-to-LED Visible Light Communication System

Electronics ◽  
2020 ◽  
Vol 9 (10) ◽  
pp. 1713
Author(s):  
Hyunwoo Jung ◽  
Sung-Man Kim
Keyword(s):  
Visible Light ◽  
Bit Error Rate ◽  
Error Rate ◽  
Signal To Noise Ratio ◽  
Light Emitting Diode ◽  
Visible Light Communication ◽  
Full Duplex ◽  
Signal To Noise ◽  
Light Emitting ◽  
Half Duplex

We experimentally demonstrated full-duplex light-emitting diode (LED)-to-LED visible light communication (VLC) using LEDs as the transmitter and receiver. Firstly, we investigated the performance dependency on the wavelengths of the LED transmitter and receiver by measuring the rise time and signal-to-noise ratio (SNR). Through the investigation, we were able to choose the optimal LED color set for LED-to-LED VLC using Shannon’s channel capacity law. The bit error rate (BER) results of full-duplex and half-duplex LED-to-LED VLC systems with the optimal LED sets are shown to compare the performance. Furthermore, we discuss major distortions and signal losses in the full-duplex LED-to-LED VLC system.

Sign in / Sign up

Export Citation Format

Share Document