Robust Beamforming and Power Splitting for Secure CR Network with Practical Energy Harvesting

2019 ◽  
Vol E102.B (8) ◽  
pp. 1547-1553
Author(s):  
Lei NI ◽  
Xinyu DA ◽  
Hang HU ◽  
Miao ZHANG ◽  
Hehao NIU
Keyword(s):  
Energy Harvesting ◽  
Power Splitting ◽  
Robust Beamforming

Robust beamforming and power splitting design in MISO SWIPT downlink system

2016 ◽  
Vol 10 (6) ◽  
pp. 691-698 ◽  
Author(s):  
Zheng Chu ◽  
Weichen Xiang ◽  
Zhengyu Zhu ◽  
Jamal Hussein
Keyword(s):  
Power Splitting ◽  
Robust Beamforming ◽  
Downlink System

scholarly journals Robust Beamforming Design for Secure V2X Downlink System with Wireless Information and Power Transfer under a Nonlinear Energy Harvesting Model

Sensors ◽  
2018 ◽  
Vol 18 (10) ◽  
pp. 3294 ◽  
Author(s):  
Shidang Li ◽  
Chunguo Li ◽  
Weiqiang Tan ◽  
Baofeng Ji ◽  
Luxi Yang
Keyword(s):  
Energy Harvesting ◽  
Traffic Safety ◽  
Optimization Problem ◽  
Optimal Solution ◽  
Base Station ◽  
Power Splitting ◽  
Power Transfer ◽  
Vehicular Communication ◽  
Downlink System ◽  
Nonlinear Energy

Vehicle to everything (V2X) has been deemed a promising technology due to its potential to achieve traffic safety and efficiency. This paper considers a V2X downlink system with a simultaneous wireless information and power transfer (SWIPT) system where the base station not only conveys data and energy to two types of wireless vehicular receivers, such as one hybrid power-splitting vehicular receiver, and multiple energy vehicular receivers, but also prevents information from being intercepted by the potential eavesdroppers (idle energy vehicular receivers). Both the base station and the energy vehicular receivers are equipped with multiple antennas, whereas the information vehicular receiver is equipped with a single antenna. In particular, the imperfect channel state information (CSI) and the practical nonlinear energy harvesting (EH) model are taken into account. The non-convex optimization problem is formulated to maximize the minimum harvested energy power among the energy vehicular receivers satisfying the lowest harvested energy power threshold at the information vehicular receiver and secure vehicular communication requirements. In light of the intractability of the optimization problem, the semidefinite relaxation (SDR) technique and variable substitutions are applied, and the optimal solution is proven to be tight. A number of results demonstrate that the proposed robust secure beamforming scheme has better performance than other schemes.

scholarly journals Performance Analysis for Exact and Upper Bound Capacity in DF Energy Harvesting Full-Duplex with Hybrid TPSR Protocol

2021 ◽  
Vol 2021 ◽  
pp. 1-9
Author(s):  
Phu Tran Tin ◽  
Phan Van-Duc ◽  
Tan N. Nguyen ◽  
Le Anh Vu
Keyword(s):  
Energy Harvesting ◽  
Upper Bound ◽  
Relay Node ◽  
Ergodic Capacity ◽  
Cooperative Relaying ◽  
Spectrum Efficiency ◽  
Full Duplex ◽  
Power Splitting ◽  
Decode And Forward ◽  
Relaying System

In this paper, we investigate the full-duplex (FD) decode-and-forward (DF) cooperative relaying system, whereas the relay node can harvest energy from radiofrequency (RF) signals of the source and then utilize the harvested energy to transfer the information to the destination. Specifically, a hybrid time-power switching-based relaying method is adopted, which leverages the benefits of time-switching relaying (TSR) and power-splitting relaying (PSR) protocols. While energy harvesting (EH) helps to reduce the limited energy at the relay, full-duplex is one of the most important techniques to enhance the spectrum efficiency by its capacity of transmitting and receiving signals simultaneously. Based on the proposed system model, the performance of the proposed relaying system in terms of the ergodic capacity (EC) is analyzed. Specifically, we derive the exact closed form for upper bound EC by applying some special function mathematics. Then, the Monte Carlo simulations are performed to validate the mathematical analysis and numerical results.

scholarly journals RF Energy Harvesting with Multiple Sources in Wireless Mesh Network

2018 ◽  
Vol 10 (2) ◽  
pp. 606 ◽  
Author(s):  
K.N Puniran ◽  
Ahmad Robiah ◽  
Rudzidatul Akmam Dziyauddin
Keyword(s):  
Energy Harvesting ◽  
Base Station ◽  
Mesh Network ◽  
System Throughput ◽  
Power Splitting ◽  
Multiple Sources ◽  
Wireless Mesh ◽  
Optimal Value ◽  
Rf Energy ◽  
Single Relay

Energy harvesting (EH) module for wireless sensor network has become a promising feature to prolong the conventional battery inside the devices. This emerging technology is gaining interest from sensor manufacturers as well as academicians across the globe. The concept of employing EH module must be cost effective and practical. In such, the use of EH module type besides RF is more realistic due to the size of the scavenger module, the availability of the resources and conversion efficiency. Most of the oil and gas plants have some drawbacks in scavenging RF from surrounding (i.e. router, Wi-Fi, base station, cell phone) due to its placement in remote area and thus limited energy sources could be a threat in this application. Multiple sources, including co-channel interference (CCI) in any constraint nodes is a feasible way of scavenging several wastes from ambient RF energy via wireless mesh topology. In this paper, a 3-node decode-and-forward (DF) model is proposed where the relay node is subject to an energy constraint. Multiple primary sources and CCI are added in the system model known as Multiple-Source and Single-Relay (MSSR). A mathematical model is derived in Time Switching Relaying (TSR) and Power Splitting Relaying (PSR) schemes to obtain an average system throughput at a destination. Numerical simulation with respect to the average throughput and EH ratio was performed and compared with the Single-Source and Single-Relay (SSSR) and ideal receiver. By applying multiple sources and CCI as an energy enhancement at the constraint node, the optimal value of EH ratio for TSR can be reduced significantly by 10% as compared to the ideal receiver whereas the optimal value of EH ratio for PSR is outweigh TSR in terms of overall system throughput.

scholarly journals Outage-Based Resource Allocation for DF Two-Way Relay Networks with Energy Harvesting

Sensors ◽  
2018 ◽  
Vol 18 (11) ◽  
pp. 3946 ◽  
Author(s):  
Chunling Peng ◽  
Fangwei Li ◽  
Huaping Liu ◽  
Guozhong Wang
Keyword(s):  
Resource Allocation ◽  
Energy Harvesting ◽  
Outage Probability ◽  
Relay Network ◽  
Total Power ◽  
Power Splitting ◽  
Decode And Forward ◽  
Resource Allocation Algorithm ◽  
Joint Resource Allocation ◽  
System Outage Probability

A joint resource allocation algorithm to minimize the system outage probability is proposed for a decode-and-forward (DF) two-way relay network with simultaneous wireless information and power transfer (SWIPT) under a total power constraint. In this network, the two sources nodes exchange information with the help of a passive relay, which is assumed to help the two source nodes’ communication without consuming its own energy by exploiting an energy-harvesting protocol, the power splitting (PS) protocol. An optimization framework to jointly optimize power allocation (PA) at the source nodes and PS at the relay is developed. Since the formulated joint optimization problem is non-convex, the solution is developed in two steps. First, the conditionally optimal PS ratio at the relay node for a given PA ratio is explored; then, the closed-form of the optimal PA in the sense of minimizing the system outage probability with instantaneous channel state information (CSI) is derived. Analysis shows that the optimal design depends on the channel condition and the rate threshold. Simulation results are obtained to validate the analytical results. Comparison with three existing schemes shows that the proposed optimized scheme has the minimum system outage probability.

scholarly journals Joint Source and Relay Beamforming Design in Wireless Multi-Hop Sensor Networks with SWIPT

Sensors ◽  
2019 ◽  
Vol 19 (1) ◽  
pp. 182 ◽  
Author(s):  
Xiaoqing Liu ◽  
Zhigang Wen ◽  
Dan Liu ◽  
Junwei Zou ◽  
Shan Li
Keyword(s):  
Energy Harvesting ◽  
Multiple Input Multiple Output ◽  
The Other ◽  
Achievable Rate ◽  
Power Splitting ◽  
Amplify And Forward ◽  
Time Switching ◽  
Multiple Input ◽  
Convex Problem ◽  
Input Multiple Output

We consider a multiple-input multiple-output amplify-and-forward wireless multiple-hop sensor network (WMSN). The simultaneous wireless information and power transfer technology is deployed to potentially achieve an autonomous system. We investigate two practical receiver schemes, which are the power splitting (PS) and the time switching (TS). The power splitting receiver splits received signals into two streams, one for information decoding (ID) and the other for energy harvesting (EH). On the other hand, the time switching receiver only serves in ID mode or energy harvesting mode during a certain time slot. Subject to transmit power constraints and destination harvested energy constraint, we aim to obtain a joint beam-forming solution of source and relay precoders to maximize the maximum achievable rate of the WSN. In order to make the non-convex problem tractable, diagonalization-based alternating optimization algorithms are proposed. Numerical results show the convergence and good performance of the proposed algorithms under both PS and TS protocols.

Sign in / Sign up

Export Citation Format

Share Document