Near-Infrared Photodetection with Molecular Beam Epitaxy Grown Extended InGaAs

2005 ◽  
Vol 883 ◽  
Author(s):  
Jun-Xian Fu ◽  
Xiaojun Yu ◽  
Yu-Hsuan Kuo ◽  
James S Harris
Keyword(s):  
Electron Microscope ◽  
Molecular Beam Epitaxy ◽  
Optical Absorption ◽  
Molecular Beam ◽  
Near Infrared ◽  
Absorption Measurement ◽  
X Ray Diffraction ◽  
X Ray ◽  
Optical Absorption Measurement ◽  
Infrared Photodetection

AbstractStrain-balanced InxGa1-xAs/InyGa1-yAs superlattices and fractional monolayer In0.532Ga0.468As/InAs superlattices were grown by solid-source molecular beam epitaxy (SSMBE) in order to extend the photodetection wavelength range beyond 1.7μm. Material qualities were characterized by transmitted electron microscope (TEM), X-ray diffraction (XRD), roomtemperature photoluminesecence (RTPL) and optical absorption measurement.

Optical and structural prorerties of InAs epilayer on graded InGaAs

2001 ◽  
Vol 696 ◽  
Author(s):  
Gu Hyun Kim ◽  
Jung Bum Choi ◽  
Joo In Lee ◽  
Se-Kyung Kang ◽  
Seung Il Ban ◽  
...  
Keyword(s):  
Molecular Beam Epitaxy ◽  
Residual Strain ◽  
Molecular Beam ◽  
Lattice Mismatch ◽  
Peak Position ◽  
Excitation Intensity ◽  
Total Thickness ◽  
Ingaas Layer ◽  
X Ray Diffraction ◽  
X Ray

AbstractWe have studied infrared photoluminescence (PL) and x-ray diffraction (XRD) of 400 nm and 1500 nm thick InAs epilayers on GaAs, and 4 nm thick InAs on graded InGaAs layer with total thickness of 300 nm grown by molecular beam epitaxy. The PL peak positions of 400 nm, 1500 nm and 4 nm InAs epilayer measured at 10 K are blue-shifted from that of InAs bulk by 6.5, 4.5, and 6 meV, respectively, which can be largely explained by the residual strain in the epilayer. The residual strain caused by the lattice mismatch between InAs and GaAs or graded InGaAs/GaAs was observed from XRD measurements. While the PL peak position of 400 nm thick InAs layer is linearly shifted toward higher energy with increase in excitation intensity ranging from 10 to 140 mW, those of 4 nm InAs epilayer on InGaAs and 1500 nm InAs layer on GaAs is gradually blue-shifted and then, saturated above a power of 75 mW. These results suggest that adopting a graded InGaAs layer between InAs and GaAs can efficiently reduce the strain due to lattice mismatch in the structure of InAs/GaAs.

X-Ray Diffraction Study of Rare Earth Epitaxial Structures Grown by MBE onto (111) GaAs

1989 ◽  
Vol 151 ◽  
Author(s):  
W. R. Bennett ◽  
R. F. C. Farrow ◽  
S. S. P. Parkin ◽  
E. E. Marinero
Keyword(s):  
Rare Earth ◽  
Molecular Beam Epitaxy ◽  
Rare Earth Metal ◽  
Molecular Beam ◽  
Earth Metal ◽  
Magnetic Ordering ◽  
Metal Films ◽  
X Ray Diffraction ◽  
X Ray ◽  
Strain Components

ABSTRACTWe report on the new epitaxial system LaF3/Er/Dy/Er/LaF3/GaAs (111) grown by molecular beam epitaxy. X-ray diffraction studies have been used to determine the epitaxial relationships between the rare earths, the LaF3 and the substrate. Further studies of symmetric and asymmetric reflections yielded the in-plane and perpendicular strain components of the rare earth layers. Such systems may be used to probe the effects of magnetoelastic interactions and dimensionality on magnetic ordering in rare earth metal films and multilayers.

A Study on the Growth of Cubic GaN Films Using an AlGaAs Buffer Layer Grown on GaAs (100) by Plasma-Assisted Molecular Beam Epitaxy

2000 ◽  
Vol 639 ◽  
Author(s):  
Ryuhei Kimura ◽  
Kiyoshi Takahashi ◽  
H. T. Grahn
Keyword(s):  
Molecular Beam Epitaxy ◽  
Buffer Layer ◽  
Molecular Beam ◽  
High Energy ◽  
Rf Plasma ◽  
Cubic Phase ◽  
X Ray Diffraction ◽  
X Ray ◽  
Cubic Gan

ABSTRACTAn investigation of the growth mechanism for RF-plasma assisted molecular beam epitaxy of cubic GaN films using a nitrided AlGaAs buffer layer was carried out by in-situ reflection high energy electron diffraction (RHEED) and high resolution X-ray diffraction (HRXRD). It was found that hexagonal GaN nuclei grow on (1, 1, 1) facets during nitridation of the AlGaAs buffer layer, but a highly pure, cubic-phase GaN epilayer was grown on the nitrided AlGaAs buffer layer.

Optical and Structural Properties of AlGaN/GaN Quantum Wells Grown by Molecular Beam Epitaxy

1998 ◽  
Vol 537 ◽  
Author(s):  
Nicolas Grandjean ◽  
Jean Massies ◽  
Mathieu Leroux ◽  
Marguerite Latigt ◽  
Pierre Lefebvre ◽  
...  
Keyword(s):  
Molecular Beam Epitaxy ◽  
Quantum Wells ◽  
Molecular Beam ◽  
Stark Effect ◽  
X Ray Diffraction ◽  
X Ray ◽  
Quantum Confined Stark Effect ◽  
Sapphire Substrates ◽  
Gan Buffer Layer ◽  
Large Quantum

AbstractAIGaN/GaN quantum well (QWs) were grown on (0001) sapphire substrates by molecular beam epitaxy (MBE) using ammonia as nitrogen precursor. The Al composition in the barriers was varied between 8 and 27 % and the well thickness from 4 to 17 monolayers (MLs, 1ML = 2.59Å). X-ray diffraction (XRD) experiments are used to investigate the strain state of both the well and the barriers. The QW transition energy are measured by low temperature photoluminescence (PL). A large quantum confined Stark effect is observed leading to QW luminescence much lower than the emission line of the GaN buffer layer for well width above a certain critical thickness. The built-in electric field responsible for such a phenomenon is deduced from fit of the PL data. Its magnitude is of several hundred kV/cm and increases linearly with the Al composition.

Structural Perfection of in GaAs/InP Superlattices Grown by Gas Source Molecular Beam Epitaxy: A High-Resolution X-Ray Diffraction Study

1987 ◽  
Vol 103 ◽  
Author(s):  
J. M. Vandenberg ◽  
M. B. Panish ◽  
R. A. Hamm
Keyword(s):  
High Resolution ◽  
Molecular Beam Epitaxy ◽  
Molecular Beam ◽  
Structural Parameters ◽  
Molecular Layer ◽  
X Ray Diffraction ◽  
Structural Perfection ◽  
X Ray ◽  
Gas Source ◽  
Step Model

ABSTRACTHigh-resolution X-ray diffraction (HRXRD) studies have been cardied out to determine the structural perfection and periodicity for a number of high-quality InGaAsfInP superlattices grown by gas source molecular beam epitaxy. X-ray scans were carried out with a compact four-crystal monochromator resulting in a resolution of one molecular layer (∼3,Å), which enables one to observe very small variations in the periodic structure. Sharp and strong higher-order satellite reflections in the XRD profiles were observed indicating smooth interfaces with well-defined modulated structures. Excellent computer simulated fits of the X-ray satellite pattern could be generated based on a kinematical XRD step model which assumes ideally sharp interfaces, and periodic structural parameters such as the strain in the well could be extracted. Our results3 demonstrate that HRXRD in conjunction with the kinematical step model is a very sensitive method to assess periodic structural modifications in superlattices as a result of the precise growth conditions in the gas source MBE system.

Estimation of Epitaxial Temperature Using X-Ray Diffraction for Si Films Grown on (100) Si by Molecular Beam Epitaxy

2000 ◽  
Vol 39 (Part 1, No. 7B) ◽  
pp. 4554-4557 ◽  
Author(s):  
Kazuhiro Nakamura ◽  
Hirofumi Shimizu ◽  
Jun Kodera ◽  
Katsuhiro Yokota
Keyword(s):  
Molecular Beam Epitaxy ◽  
Molecular Beam ◽  
X Ray Diffraction ◽  
X Ray ◽  
Si Films

Bi-Based Superconducting Multilayers Obtained by Molecular Beam Epitaxy

1999 ◽  
Vol 13 (09n10) ◽  
pp. 991-996
Author(s):  
M. Salvato ◽  
C. Attanasio ◽  
G. Carbone ◽  
T. Di Luccio ◽  
S. L. Prischepa ◽  
...  
Keyword(s):  
Molecular Beam Epitaxy ◽  
Molecular Beam ◽  
Xrd Analysis ◽  
High Energy ◽  
X Ray Diffraction ◽  
One Dimensional ◽  
X Ray ◽  
Diffraction Model ◽  
Different Thickness

High temperature superconducting multilayers have been obtained depositing Bi2Sr2CuO6+δ(2201) and ACuO2 layers, where A is Ca or Sr, by Molecular Beam Epitaxy (MBE) on MgO and SrTiO3 substrates. The samples, formed by a sequence of 2201/ACuO2 bilayers, have different thickness of ACuO2 layers while the thickness of the 2201 layers is kept constant. The surface structure of each layer has been monitored by in situ Reflection High Energy Electron Diffraction (RHEED) analysis which has confirmed a 2D nucleation growth. X-ray diffraction (XRD) analysis has been used to confirm that the layered structure has been obtained. Moreover, one-dimensional X-ray kinematic diffraction model has been developed to interpret the experimental data and to estimate the period of the multilayers. Resistive measurements have shown that the electrical properties of the samples strongly depend on the thickness of the ACuO2 layers.

Sign in / Sign up

Export Citation Format

Share Document