The Electrochemistry of Germanium Nitride Versus Lithium

2002 ◽  
Vol 756 ◽  
Author(s):  
N. Pereira ◽  
M. Balasubramanian ◽  
L. Dupont ◽  
J. McBreen ◽  
L. C. Klein ◽  
...  
Keyword(s):  
Negative Electrode ◽  
Reversible Capacity ◽  
Ex Situ ◽  
X Ray Diffraction ◽  
Selective Area ◽  
Transmission Electron ◽  
Electrochemically Active ◽  
Li Ion ◽  
Negative Electrode Material

ABSTRACTGermanium nitride (Ge3N4) was examined as a potential negative electrode material for Li-ion batteries. The electrochemistry of Ge3N4 versus Li showed high reversible capacity (500mAh/g) and good capacity retention during cycling. A combination of ex-situ and in-situ x-ray diffraction (XRD), ex-situ transmission electron microscopy (TEM) and ex-situ selective area electron diffraction (SAED) analyses revealed evidence supporting the conversion of a layer of Ge3N4 crystal into an amorphous Li3N+LixGe nanocomposite during the first lithiation. The nanocomposite was electrochemically active via a reversible Li-Ge alloying reaction while a core of unreacted Ge3N4 crystal remained inactive. The lithium/metal nitride conversion reaction process was kinetically hindered resulting in limited capacity. Mechanical milling was found to improve the material capacity.

Size dependent behavior of Fe3O4crystals during electrochemical (de)lithiation: an in situ X-ray diffraction, ex situ X-ray absorption spectroscopy, transmission electron microscopy and theoretical investigation

2017 ◽  
Vol 19 (31) ◽  
pp. 20867-20880 ◽  
Author(s):  
David C. Bock ◽  
Christopher J. Pelliccione ◽  
Wei Zhang ◽  
Janis Timoshenko ◽  
K. W. Knehr ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Structural Changes ◽  
Ex Situ ◽  
X Ray Diffraction ◽  
X Ray ◽  
Size Dependent ◽  
Transmission Electron ◽  
Dependent Behavior ◽  
X Ray Absorption

Crystal and atomic structural changes of Fe3O4upon electrochemical (de)lithiation were determined.

scholarly journals Characterization and Electrochemical Behavior of Graphene-Based Anode for Li-Ion Batteries

2011 ◽  
Vol 5 (1) ◽  
pp. 236-241 ◽  
Author(s):  
Wei-Ren Liu ◽  
Shin-Liang Kuo ◽  
Chia-Yi Lin ◽  
Yi-Chen Chiu ◽  
Ching-Yi Su ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Graphene Nanosheets ◽  
Rate Capability ◽  
Reversible Capacity ◽  
X Ray Diffraction ◽  
Transmission Electron ◽  
Li Ion ◽  
Synthetic Graphite ◽  
Lower Impedance ◽  
Enhanced Electrochemical Performance

In this study, we investigate the characteristics and electrochemical properties of graphene nanosheets derived from chemical-thermal exfoliation processes of SFG44 synthetic graphite (SFG44-GNS). The characterizations and electrochemical measurements were carried out by means of X-ray diffraction, scanning electron microscopy, transmission electron microscopy, cyclic voltammetry, BET, Raman, rate capability as well as cycling tests and AC impedance. The as-synthesized SFG44-GNS with larger d-spacing of 0.3407 nm exhibits reversible capacity of 626 mAh/g and good rate capability of ~ 300 mAh/g at 2C rate, which are superior to those of graphite anode. The enhanced electrochemical performance of GNS anode was resulted from larger d-spacing, lower impedance in the interface and enhanced pore volume. The results indicate that graphene-based material is a good candidate for HEV/EV application.

(G03 Best Paper Award Winner) Analysis of Sn Behavior During Ni/GeSn Solid-State Reaction by Correlated X-ray Diffraction, Atomic Force Microscopy, and Ex-situ/In-situ Transmission Electron Microscopy

2020 ◽  
Vol MA2020-02 (24) ◽  
pp. 1750-1750
Author(s):  
Andrea Quintero Colmenares ◽  
Patrice Gergaud ◽  
Jean-Michel Hartmann ◽  
Vincent Delaye ◽  
Nicolas Bernier ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Ex Situ ◽  
Paper Award ◽  
X Ray Diffraction ◽  
Award Winner ◽  
X Ray ◽  
Force Microscopy ◽  
Atomic Force ◽  
Transmission Electron

In Situ Analysis of magnetic and Structural Properties of Epitaxial and Polycrystalline Ni80Fe20 Thin Films

1993 ◽  
Vol 313 ◽  
Author(s):  
I. Hashim ◽  
H.A. Atwater ◽  
Thomas J. Watson
Keyword(s):  
Magnetic Properties ◽  
Kerr Effect ◽  
High Energy ◽  
Epitaxial Films ◽  
Interface Roughness ◽  
Ex Situ ◽  
X Ray Diffraction ◽  
Cross Sectional ◽  
Transmission Electron

ABSTRACTWe have investigated structural and magnetic properties of epitaxial Ni80Fe20 films grown on relaxed epitaxial Cu/Si (001) films. The crystallographic texture of these films was analyzed in situ by reflection high energy electron diffraction (RHEED), and ex situ by x-ray diffraction and cross-sectional transmission electron Microscopy (XTEM). In particular, RHEED intensities were recorded during epitaxial growth, and intensity profiles across Bragg rods were used to calculate the surface lattice constant, and hence, find the critical epitaxial thickness for which Ni80Fe20 grows pseudomorphically on Cu (100). XTEM analysis indicated that the epitaxial films had atomically-abrupt interfaces which was not the case for polycrystalline Cu and Ni80Fe20 film interfaces. The Magnetic properties of these epitaxial films were Measured in situ using Magneto-optic Kerr effect magnetometry and were compared with those of polycrystalline films grown on SiO2/Si. Large Hc (∼ 35 Oe) was observed for epitaxial Ni80Fe20 films less than 3.0 nm thick whereas for increasing thickness, Hc decreased approximately monotonically to a few Oersteds. Correlations were made between magnetic properties of these epitaxial films, the strain in the film and the interface roughness obtained from XTEM analysis.

In situ X-ray diffraction studies of a graphite-based Li-ion battery negative electrode

1996 ◽  
Vol 63 (1) ◽  
pp. 41-45 ◽  
Author(s):  
A.H. Whitehead ◽  
K. Edström ◽  
N. Rao ◽  
J.R. Owen
Keyword(s):  
Negative Electrode ◽  
Li Ion Battery ◽  
X Ray Diffraction ◽  
X Ray ◽  
Li Ion

scholarly journals Microstructure and Electrical Property of Ex-Situ and In-Situ Copper Titanium Carbide Nanocomposites

Metals ◽  
2020 ◽  
Vol 10 (6) ◽  
pp. 735
Author(s):  
Nguyen Hoang Viet ◽  
Nguyen Thi Hoang Oanh
Keyword(s):  
Electrical Conductivity ◽  
Electron Microscope ◽  
Applied Pressure ◽  
Ex Situ ◽  
X Ray Diffraction ◽  
Composite Powders ◽  
Plasma Sintering ◽  
Transmission Electron ◽  
Spark Plasma

In this study, ex-situ Cu-TiC nanocomposites of 1, 3 and 5 vol. % TiC and in-situ Cu-TiH2-C nanocomposites (corresponding to 5 vol. % TiC) were prepared using ball milling and spark plasma sintering methods. Powder mixtures were milled for 4 h at 400 rpm. As-milled Cu-TiC composite powders were consolidated under an applied pressure of 70 MPa. The phase composition, and microstructure of the composite samples were characterized by X-ray diffraction, and scanning electron microscope and transmission electron microscope techniques, respectively. With the increasing TiC content from 1 to 5 vol. %, the hardness of the ex-situ composites when sintered at 600 °C changed between 161.4 and 178.5 HV and the electrical conductivity decreased from 52.1 to 47.6% IACS. In-situ Cu-TiH2-C nanocomposite sintered at 950 °C had higher hardness and electrical conductivity than ex-situ Cu-TiC composite due to having a homogenous distribution of nano reinforcement particles and dense structure.

Application of the “confusion principle” to Sn-based materials as negative electrode materials for Li-ion batteries

2010 ◽  
Vol 88 (2) ◽  
pp. 131-135 ◽  
Author(s):  
P. P. Ferguson ◽  
J. R. Dahn
Keyword(s):  
Electrode Materials ◽  
Specific Capacity ◽  
Negative Electrode ◽  
Alloy Sample ◽  
X Ray Diffraction ◽  
Cycle Number ◽  
Xrd Pattern ◽  
Li Ion ◽  
Xrd Patterns ◽  
Negative Electrode Material

The “confusion principle” (Greer. Nature, 366, 303 (1993)) is applied to tin-3d transition metals carbon alloys to obtain a nanostructured negative electrode material. Various Sn–TMs–C samples with TMs = Ti, V, Cr, Mn, Fe, Co, Ni, and Cu (all included with same atomic ratios) were prepared by mechanical milling and by mechanical alloying. Each 10-component alloy sample was examined structurally using X-ray diffraction (XRD) and electrochemically using Li/Sn–TM–C cells. The sample Sn10TMs80C10 showed a nanostructured or amorphous-type XRD pattern, which shows the validity of this principle. XRD patterns of samples prepared with higher Sn atomic content showed crystalline features of Sn-based intermetallics. As expected, a very low specific capacity ( [Formula: see text]100 mAh/g) was observed for the sample Sn10TMs80C10. The sample Sn30TMs30C40 had the highest specific capacity (near 400 mAh/g) of the samples prepared. However, features of Sn aggregation were noticed at cycle number 80 of the latter sample, which are normally detrimental to the capacity retention upon further cycling.

Sign in / Sign up

Export Citation Format

Share Document