Chemical Composition, Geochemical Alteration, and Radiation Damage Effects in Natural Perovskite

1997 ◽  
Vol 506 ◽  
Author(s):  
Gregory R. Lumpkin ◽  
Michael Colella ◽  
Katherine L. Smith ◽  
Roger H. Mitchell ◽  
Alf Olav Larsen

ABSTRACTPreliminary analytical and transmission electron microscopy (AEM and TEM) results for a small suite of natural perovskites are reported in this paper and discussed in relation to previous work. We show that perovskite compositions in Synroc and tailored ceramics plot within the known fields of natural perovskite compositions. AEM analyses and electron diffraction work on selected samples indicate that they are predominantly stoichiometric variants of the cubic perovskite structure. Geochemical alteration was observed in one sample of loparite from Bratthagen, Norway. The primary result of this alteration was leaching of Na from the A-site. Although sufficient alpha-decay dose levels for complete amorphization are not realized in this suite of samples, the available data bracket the beginning of the crystalline-amorphous transformation at doses that are ∼ 2-4 times greater than those of zirconolite of similar age. These results may be due to fundamental differences in the damage annealing rates of perovskite and zirconolite.

2018 ◽  
Vol 90 (5) ◽  
pp. 833-844
Author(s):  
Leonid Aslanov ◽  
Valery Zakharov ◽  
Ksenia Paseshnichenko ◽  
Aleksandr Yatsenko ◽  
Andrey Orekhov ◽  
...  

AbstractA new method for synthesis of 2D nanocrystals in water was proposed. The use of perfluorothiophenolate ions as surfactant allowed us to produce 2D single-crystal nanosheets of CaS at pH=9 and flat nanocrystals of PbS at pH=9 at room temperature. Mesocrystalline nanobelts of CdS and mesocrystals of PbS were obtained at pH=3–5 and pH=10–12, respectively. Morphology, structure and chemical composition of nanoparticles were characterized by high-resolution transmission electron microscopy, electron diffraction and energy dispersive X-ray spectroscopy. A mechanism of nanoparticles formation was discussed.


1993 ◽  
Vol 334 ◽  
Author(s):  
J. Eneva ◽  
S. Kitova ◽  
A Panov ◽  
H. Haefke

AbstractAg2S as a narrow band gap semiconductor is appropriate for photoimaging in the infrared (IR) region. Co-evaporation of Ag and S from two separate sources was used for preparing of thin Ag2S films with different Ag/S ratio. Gelatine subbed glass plates were used as substrates. The structure of the films obtained was examined by transmission electron microscopy and electron diffraction. The effects of chemical composition, film thickness and processing conditions on the photographic parameters were studied.It is shown that after appropriate processing thin Ag2S films with stoichiometric composition can. be successfully used as high resolution (1600 lines/mm) photographic materials in the IR region.


Author(s):  
George Guthrie ◽  
David Veblen

The nature of a geologic fluid can often be inferred from fluid-filled cavities (generally <100 μm in size) that are trapped during the growth of a mineral. A variety of techniques enables the fluids and daughter crystals (any solid precipitated from the trapped fluid) to be identified from cavities greater than a few micrometers. Many minerals, however, contain fluid inclusions smaller than a micrometer. Though inclusions this small are difficult or impossible to study by conventional techniques, they are ideally suited for study by analytical/ transmission electron microscopy (A/TEM) and electron diffraction. We have used this technique to study fluid inclusions and daughter crystals in diamond and feldspar.Inclusion-rich samples of diamond and feldspar were ion-thinned to electron transparency and examined with a Philips 420T electron microscope (120 keV) equipped with an EDAX beryllium-windowed energy dispersive spectrometer. Thin edges of the sample were perforated in areas that appeared in light microscopy to be populated densely with inclusions. In a few cases, the perforations were bound polygonal sides to which crystals (structurally and compositionally different from the host mineral) were attached (Figure 1).


Author(s):  
D. Loretto ◽  
J. M. Gibson ◽  
S. M. Yalisove

The silicides CoSi2 and NiSi2 are both metallic with the fee flourite structure and lattice constants which are close to silicon (1.2% and 0.6% smaller at room temperature respectively) Consequently epitaxial cobalt and nickel disilicide can be grown on silicon. If these layers are formed by ultra high vacuum (UHV) deposition (also known as molecular beam epitaxy or MBE) their thickness can be controlled to within a few monolayers. Such ultrathin metal/silicon systems have many potential applications: for example electronic devices based on ballistic transport. They also provide a model system to study the properties of heterointerfaces. In this work we will discuss results obtained using in situ and ex situ transmission electron microscopy (TEM).In situ TEM is suited to the study of MBE growth for several reasons. It offers high spatial resolution and the ability to penetrate many monolayers of material. This is in contrast to the techniques which are usually employed for in situ measurements in MBE, for example low energy electron diffraction (LEED) and reflection high energy electron diffraction (RHEED), which are both sensitive to only a few monolayers at the surface.


1983 ◽  
Vol 29 ◽  
Author(s):  
M. I. Birjega ◽  
C. A. Constantin ◽  
M. Dinescu ◽  
I. Th. Florescu ◽  
I. N. Mihailescu ◽  
...  

ABSTRACTThe crystallization and oxidation processes of thin, free-standing (FS), sputtered Cr films under the action of cw CO2 laser irradiation were studied by transmission electron microscopy (TEM) and transmission electron diffraction (TED). The crystallization is induced at power densities above 28.65 W cm−2, dwell time of 1 s, and the oxidation at power densities of 48.1 W cm−2 and longer dwell times.


BioResources ◽  
2006 ◽  
Vol 1 (2) ◽  
pp. 220-232 ◽  
Author(s):  
H. P. S. Abdul Khalil ◽  
M. Siti Alwani ◽  
A. K. Mohd Omar

The chemical composition, anatomical characteristics, lignin distribution, and cell wall structure of oil palm frond (OPF), coconut (COIR), pine-apple leaf (PALF), and banana stem (BS) fibers were analyzed. The chemical composition of fiber was analyzed according to TAPPI Methods. Light microscopy (LM) and transmission electron microscopy (TEM) were used to observe and determine the cell wall structure and lignin distribution of various agro-waste fibers. The results revealed differences in anatomical characteristics, lignin distributions, and cell wall structure of the different types of fibers investigated. Nevertheless, transmission electron microscopy (TEM) micrographs have confirmed that the well wall structure, in each case, could be described in terms of a classical cell wall structure, consisting of primary (P) and secondary (S 1 , S 2 , and S 3 ) layers.


2003 ◽  
Vol 18 (2) ◽  
pp. 475-481 ◽  
Author(s):  
Karfa Traoré ◽  
Philippe Blanchart

Kaolinite mixed with calcite was sintered at low temperature (1100 °C; 5 °C/min). The successive phase transformations are metakaolinite to gehlenite and then anorthite, although the available phase diagram indicates a direct anorthite recrystallization. Transmission electron microscopy and electron diffraction studies of nanocrystallites revealed that the transformation path is favored by the structural similarities of phases. In particular, the pseudolayers of gehlenite have a major orientation relationship with the initial metakaolinite layers. The gehlenite axis, [001]G, is parallel to the metakaolinite axis, [001]A. This direct transition is favored by the existence of Si tetrahedral units and 4–fold–coordinated Al in both structures. Ca atoms, initially in the interlayer spacing of metakaolinite, remain in the interlayers of gehlenite. During the second transformation step, anorthite recrystallizes from gehlenite with axis [020]A parallel to [210]G. It is proposed that this orientation relationship is favored by the orientation and shape of Ca-atom channels through both structures, along [001]G and [100]A axes.


2015 ◽  
Vol 229 ◽  
pp. 3-10 ◽  
Author(s):  
Bartłomiej Dybowski ◽  
Bogusława Adamczyk-Cieślak ◽  
Kinga Rodak ◽  
Iwona Bednarczyk ◽  
Andrzej Kiełbus ◽  
...  

The complex microstructure of as-cast AlSi7Mg alloy has been investigated. Microstructure observations were done using light microscopy, scanning electron microscopy and transmission electron microscopy. Chemical composition of the microstructure constituents was investigated by means of energy dispersive spectrometry, conducted both during SEM and STEM investigations. Selected area diffraction was used to identify the phases in the alloy. Microstructure of the alloy in the as-cast condition consists of Al-Si eutectic and intermetallic phases in the interdendritic regions. These are: Mg2Si, α-AlFeMnS, β-AlFeSi and π-AlFeSiMg phases. What is more, number of fine precipitates were found within the α-Al dendrites. Only the occurrence of U1 (MgAl2Si2) phase has been confirmed.


Nanoscale ◽  
2014 ◽  
Vol 6 (22) ◽  
pp. 13803-13808 ◽  
Author(s):  
Arnaud Mayence ◽  
Dong Wang ◽  
German Salazar-Alvarez ◽  
Peter Oleynikov ◽  
Lennart Bergström

Planar defects in Pd nanoparticle superlattices were revealed by a combination of real and reciprocal space transmission electron microscopy techniques. 3D electron diffraction tomography was extended to characterize mesoscale imperfections.


Sign in / Sign up

Export Citation Format

Share Document