Single Variant Orientational Growth of Yba2Cu3O7-x on Vicinal (011) SrTiO3 Substrates.

1995 ◽  
Vol 401 ◽  
Author(s):  
A. L. Vasiliev ◽  
D. S. Linehan ◽  
E. P. Kvam ◽  
L. Hou ◽  
M. W. McElfresh

AbstractThe results of a transmission electron microscopic (TEM) and X-ray microanalysis (EDS) study of Yba2Cu3O7-x (YBCO) films grown on vicinal (011) SrTiO3 substrates are presented. The YBCO films tend to be single crystalline grown in single variant orientation with c-axis =;45° from the surface. Cracks, second phase precipitates (CuO and Y2O3), and a few small YBCO grains in other orientations were revealed in the films.

2004 ◽  
Vol 19 (10) ◽  
pp. 2905-2912 ◽  
Author(s):  
Tokeer Ahmad ◽  
Ashok K. Ganguli

Nanoparticles of barium orthotitanate (Ba2TiO4) was obtained using microemulsions (avoiding Ba-alkoxide). Powder x-ray diffraction studies of the powder after calcining at 800 °C resulted in a mixture of orthorhombic (70%) and monoclinic (30%) phases. The high-temperature orthorhombic form present at 800 °C was due to the small size of particles obtained by the reverse micellar route. Pure orthorhombic Ba2TiO4 was obtained on further sintering at 1000 °C with lattice parameters a = 6.101(2) Å, b =22.94(1) Å, c = 10.533(2) Å (space group, P21nb). The particle size obtained from x-ray line broadening studies and transmission electron microscopic studies was found to be 40–50 nm for the powder obtained after heating at 800 °C. Sintering at 1000 °C showed increase in grain size up to 150 nm. Our studies corroborate well with the presence of a martensitic transition in Ba2TiO4. The dielectric constant was found to be 40 for Ba2TiO4 (at 100 kHz) for samples sintered at 1000 °C. The dielectric loss obtained was low (0.06) at 100 kHz.


1996 ◽  
Vol 431 ◽  
Author(s):  
Jianping Yang ◽  
Syed Qadri ◽  
Banahalli Ratna

AbstractBicontinuous cubic phase of lipid has been utilized for the first time as a matrix to synthesize II–VI (CdS) and IV–VI (PbS) semiconductor nanocrystallites. The nanoparticles were isolated from the lipid matrix and stabilized by capping with a thiol compound before purification. Two different sizes (2.3 nm and 3.0 nm) of CdS particles were prepared by varying the conditions of preparation. The size was determined by a combination of UV-vis absorption spectra and X-ray diffraction (XRD). The steep absorption edges of the two CdS samples indicate very narrow size distribution. XRD and transmission electron microscopic imaging of PbS nanocrystallites revealed that the size was 4.9 nm with nearly monodispersed size distribution.


2006 ◽  
Vol 955 ◽  
Author(s):  
Balakrishnan Krishnan ◽  
Masataka Imura ◽  
Kazuyoshi Iida ◽  
Kentaro Nagamatsu ◽  
Hiroki Sugimura ◽  
...  

ABSTRACTSingle crystalline AlN epitaxial layers have been grown on and (0001) sapphire and 6H-SiC substrates by MOVPE technique at high temperatures in the range of 1340-1500°C. The structural qualities of the high temperature grown AlN layers were found to be good as evidenced by X-ray diffraction analyses results. By transmission electron microscopic analysis, dislocation densities of the layers were found to be 6.2 × 107 cm−2 or lower and the formation of dislocation loops was confirmed. High temperature bridge layers of AlN and AlxGa1−xN layers were grown on linear-groove patterned sapphire based AlN templates and 6H-SiC substrates. AlxGa1−xN bridge layers exhibited different growth behaviours depending on the direction of groove patterns on the sub-strates.


1999 ◽  
Vol 583 ◽  
Author(s):  
V. V. Chaldyshev ◽  
N. A. Bert ◽  
N. N. Faleev ◽  
Yu. G. Musikhin ◽  
A. E. Kunitsyn ◽  
...  

AbstractInAs/GaAs superlattices with thin (0.5–1 monolayer) δ-InAs insertions were grown by molecular beam epitaxy at low (150–200°C) temperature. The as-grown samples contained up to 1020 cm−3 arsenic antisite defects. Transmission electron microscopic study revealed no extended defect and showed that the real thickness of δ-InAs insertions is 3–4 monolayers. This thickness seems to be due to short-range roughness of the growth surface. Low diffuse scattering and extended interference picture were observed for such superlattices by x-ray diffraction study. Superlattices of two-dimensional cluster sheets were produced by annealing of the δ-InAs/GaAs superlattices at 500–600°C. Precipitation of excess arsenic at InAs δ-layers was found to be accompanied by enhanced In-Ga intermixing, roughening the InAs δ-layers, and smoothing the x-ray interference picture. No evidence for any self-ordering in the system of nanoscale As clusters was revealed using x-ray mapping in reciprocal space.


Sign in / Sign up

Export Citation Format

Share Document