Tem Study of Stacking Faults Formed in Pairs in a ZnSe Epitaxial Layer on a GaAs(00l) Buffer Layer

1995 ◽  
Vol 399 ◽  
Author(s):  
J. Tanimura ◽  
O. Wada ◽  
Y. Endoh ◽  
M. Imaizumi ◽  
T. Ogama
Keyword(s):  
Electron Microscopy ◽  
Buffer Layer ◽  
Epitaxial Layer ◽  
Stacking Faults ◽  
Formation Mechanisms ◽  
Burgers Vector ◽  
Force Microscopy ◽  
Partial Dislocations ◽  
Atomic Force ◽  
Transmission Electron

ABSTRACTStructure of stacking faults in a ZnSe epitaxial layer grown on a GaAs(001) buffer layer was determined with transmission electron microscopy. Two stacking faults were formed in pairs on (111) and (111) planes with the same polarity and met at a point which is a few atomic layers away from the interface between ZnSe and GaAs. Partial dislocations were found to be the Shockley type ones with a Burgers vector of 1/6<211>. Atomic force microscopy showed that hillocks were formed in pairs at a surface where the pair of stacking faults existed in the layer. Moreover, it was observed that the pair of stacking faults elongated along the <110> direction by gliding on the {111} faulted planes under annealing at 200°C for 30min. Formation mechanisms of the pair of stacking faults have been discussed.

Links Between Etching Grooves Of Partial Dislocations And Their Characteristics Determined By TEM In 4H SiC

2008 ◽  
Vol 1069 ◽  
Author(s):  
Jean-Pierre Ayoub ◽  
Michael Texier ◽  
Gabrielle Regula ◽  
Bernard Pichaud ◽  
Maryse Lancin
Keyword(s):  
Electron Microscopy ◽  
Chemical Etching ◽  
Stacking Faults ◽  
Sample Surface ◽  
Force Microscopy ◽  
Etch Patterns ◽  
Partial Dislocations ◽  
Atomic Force ◽  
Core Composition ◽  
Transmission Electron

ABSTRACTWe introduce defects into (1120) oriented highly N-doped 4H-SiC by surface scratching, bending and annealing in the brittle regime. Emerging defects at the sample surface are revealed by chemical etching of the deformed samples. The etch patterns are constituted of straight bulges and grooves exhibiting various topographical features. These etch figures correspond to the emergence of double stacking faults dragged by a pair of partial dislocations. In this paper, we discuss the links between the etch figure characteristics and the defect nature. Results obtained by optical and atomic force microscopy are completed by structural analysis of defects performed by transmission electron microscopy. Mobility of partial dislocations in 4H-SiC is discussed and correlated to their core composition and to the effect of the applied mechanical stress.

Overlapping Shockley/Frank Faults in 4H-SiC PiN Diodes

2006 ◽  
Vol 527-529 ◽  
pp. 383-386 ◽  
Author(s):  
Mark E. Twigg ◽  
Robert E. Stahlbush ◽  
Peter A. Losee ◽  
Can Hua Li ◽  
I. Bhat ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Light Emission ◽  
Stacking Faults ◽  
Dark Field ◽  
Pin Diodes ◽  
Plan View ◽  
Planar Defects ◽  
Burgers Vector ◽  
Partial Dislocations ◽  
Transmission Electron

Using light emission imaging (LEI), we have determined that not all planar defects in 4H-SiC PiN diodes expand in response to bias. Accordingly, plan-view transmission electron microscopy (TEM) observations of these diodes indicate that these static planar defects are different in structure from the mobile stacking faults (SFs) that have been previously observed in 4H-SiC PiN diodes. Bright and dark field TEM observations reveal that such planar defects are bounded by partial dislocations, and that the SFs associated with these partials display both Frank and Shockley character. That is, the Burgers vector of such partial dislocations is 1/12<4-403>. For sessile Frank partial dislocations, glide is severely constrained by the need to inject either atoms or vacancies into the expanding faulted layer. Furthermore, these overlapping SFs are seen to be fundamentally different from other planar defects found in 4H-SiC.

Structural Characterization of Prismatic Stacking Faults of Two Types of Carrot Defects in 4H-SiC Epi Wafers

2020 ◽  
Vol 1004 ◽  
pp. 421-426
Author(s):  
Hideki Sako ◽  
Kentaro Ohira ◽  
Kenji Kobayashi ◽  
Toshiyuki Isshiki
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Stacking Faults ◽  
Wafer Surface ◽  
Cross Sectional ◽  
Force Microscopy ◽  
Atomic Force ◽  
Transmission Electron ◽  
Scanning Transmission ◽  
The Difference

Two types of carrot defects with and without a shallow pit were found by mirror projection electron microscopy (MPJ) inspection in 4H-SiC epi wafer. Surface morphology and cross-sectional structure of prismatic stacking faults (PSFs) were investigated using MPJ and atomic force microscopy (AFM), transmission electron microscopy (TEM) and high-resolution scanning transmission electron microscopy (STEM). The depths of the surface grooves due to the PSFs, the stacking sequences around the PSFs and the structure of the Frank-type stacking faults which were connected to the PSFs were different. We discuss the difference between the two types of carrot defects.

Defect-Engineered Graded GexSi1-x Buffers on Si (001) with Extreme Low Threading Dislocation Density

1995 ◽  
Vol 378 ◽  
Author(s):  
G. Kissinger ◽  
T. Morgenstern ◽  
G. Morgenstern ◽  
H. B. Erzgräber ◽  
H. Richter
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Atomic Force Microscopy ◽  
Dislocation Density ◽  
Threading Dislocation ◽  
Force Microscopy ◽  
Atomic Force ◽  
Transmission Electron ◽  
Dislocation Densities ◽  
Threading Dislocation Density

AbstractStepwise equilibrated graded GexSii-x (x≤0.2) buffers with threading dislocation densities between 102 and 103 cm−2 on the whole area of 4 inch silicon wafers were grown and studied by transmission electron microscopy, defect etching, atomic force microscopy and photoluminescence spectroscopy.

Effectiveness and Reliability of Metal Diffusion Barriers for Copper Interconnects

1995 ◽  
Vol 403 ◽  
Author(s):  
G. Bai ◽  
S. Wittenbrock ◽  
V. Ochoa ◽  
R. Villasol ◽  
C. Chiang ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Vapor Deposition ◽  
Physical Vapor Deposition ◽  
Chemical Vapor ◽  
Diffusion Barriers ◽  
Copper Interconnects ◽  
Time To Failure ◽  
Force Microscopy ◽  
Atomic Force ◽  
Transmission Electron

AbstractCu has two advantages over Al for sub-quarter micron interconnect application: (1) higher conductivity and (2) improved electromigration reliability. However, Cu diffuses quickly in SiO2and Si, and must be encapsulated. Polycrystalline films of Physical Vapor Deposition (PVD) Ta, W, Mo, TiN, and Metal-Organo Chemical Vapor Deposition (MOCVD) TiN and Ti-Si-N have been evaluated as Cu diffusion barriers using electrically biased-thermal-stressing tests. Barrier effectiveness of these thin films were correlated with their physical properties from Atomic Force Microscopy (AFM), Transmission Electron Microscopy (TEM), Secondary Electron Microscopy (SEM), and Auger Electron Spectroscopy (AES) analysis. The barrier failure is dominated by “micro-defects” in the barrier film that serve as easy pathways for Cu diffusion. An ideal barrier system should be free of such micro-defects (e.g., amorphous Ti-Si-N and annealed Ta). The median-time-to-failure (MTTF) of a Ta barrier (30 nm) has been measured at different bias electrical fields and stressing temperatures, and the extrapolated MTTF of such a barrier is > 100 year at an operating condition of 200C and 0.1 MV/cm.

Development of Ge Nanoparticles Embedded in GeO2 Matrix

2008 ◽  
Vol 8 (8) ◽  
pp. 4081-4085 ◽  
Author(s):  
Y. Batra ◽  
D. Kabiraj ◽  
D. Kanjilal
Keyword(s):  
Electron Microscopy ◽  
Annealing Temperature ◽  
Spectroscopic Studies ◽  
Electron Beam Evaporation ◽  
Granular Structure ◽  
Raman Analysis ◽  
Force Microscopy ◽  
Atomic Force ◽  
Transmission Electron ◽  
Ge Nanocrystals

Germanium (Ge) nanoparticles have attracted a lot of attention due to their excellent optical properties. In this paper, we report on the formation of Ge nanoparticles embedded in GeO2 matrix prepared by electron beam evaporation and subsequent annealing. Transmission electron microscopy (TEM) studies clearly indicate the formation of Ge nanocrystals in the films annealed at 500 °C. Fourier transform infrared (FTIR) spectroscopic studies are carried out to verify the evolution of the structure after annealingat each stage. Micro-Raman analysis also confirms the formation of Ge nanoparticles in the annealed films. Development of Ge nanoparticles is also established by photoluminescence (PL) analysis. Surface morphology study is carried out by atomic force microscopy (AFM). It shows the evolution of granular structure of the films with increasing annealing temperature.

scholarly journals Measuring the Autocorrelation Function of Nanoscale Three-Dimensional Density Distribution in Individual Cells Using Scanning Transmission Electron Microscopy, Atomic Force Microscopy, and a New Deconvolution Algorithm

2017 ◽  
Vol 23 (3) ◽  
pp. 661-667 ◽  
Author(s):  
Yue Li ◽  
Di Zhang ◽  
Ilker Capoglu ◽  
Karl A. Hujsak ◽  
Dhwanil Damania ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Density Distribution ◽  
Scanning Transmission Electron Microscopy ◽  
Mass Density ◽  
Three Dimensional ◽  
Force Microscopy ◽  
Statistical Measures ◽  
Atomic Force ◽  
Transmission Electron ◽  
Scanning Transmission

AbstractEssentially all biological processes are highly dependent on the nanoscale architecture of the cellular components where these processes take place. Statistical measures, such as the autocorrelation function (ACF) of the three-dimensional (3D) mass–density distribution, are widely used to characterize cellular nanostructure. However, conventional methods of reconstruction of the deterministic 3D mass–density distribution, from which these statistical measures can be calculated, have been inadequate for thick biological structures, such as whole cells, due to the conflict between the need for nanoscale resolution and its inverse relationship with thickness after conventional tomographic reconstruction. To tackle the problem, we have developed a robust method to calculate the ACF of the 3D mass–density distribution without tomography. Assuming the biological mass distribution is isotropic, our method allows for accurate statistical characterization of the 3D mass–density distribution by ACF with two data sets: a single projection image by scanning transmission electron microscopy and a thickness map by atomic force microscopy. Here we present validation of the ACF reconstruction algorithm, as well as its application to calculate the statistics of the 3D distribution of mass–density in a region containing the nucleus of an entire mammalian cell. This method may provide important insights into architectural changes that accompany cellular processes.

scholarly journals Spore Coat Architecture of Clostridium novyi NT Spores

2007 ◽  
Vol 189 (17) ◽  
pp. 6457-6468 ◽  
Author(s):  
Marco Plomp ◽  
J. Michael McCaffery ◽  
Ian Cheong ◽  
Xin Huang ◽  
Chetan Bettegowda ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Anaerobic Bacterium ◽  
Amorphous Layer ◽  
Spore Coat ◽  
Experimental Animals ◽  
Force Microscopy ◽  
Atomic Force ◽  
Clostridium Novyi ◽  
Transmission Electron

ABSTRACT Spores of the anaerobic bacterium Clostridium novyi NT are able to germinate in and destroy hypoxic regions of tumors in experimental animals. Future progress in this area will benefit from a better understanding of the germination and outgrowth processes that are essential for the tumorilytic properties of these spores. Toward this end, we have used both transmission electron microscopy and atomic force microscopy to determine the structure of both dormant and germinating spores. We found that the spores are surrounded by an amorphous layer intertwined with honeycomb parasporal layers. Moreover, the spore coat layers had apparently self-assembled, and this assembly was likely to be governed by crystal growth principles. During germination and outgrowth, the honeycomb layers, as well as the underlying spore coat and undercoat layers, sequentially dissolved until the vegetative cell was released. In addition to their implications for understanding the biology of C. novyi NT, these studies document the presence of proteinaceous growth spirals in a biological organism.

Sign in / Sign up

Export Citation Format

Share Document