Laboratory Testing of the Corrosion of Waste Glasses in Aqueous Environments - Effects of Experimental Parameters

1993 ◽  
Vol 333 ◽  
Author(s):  
AA. Barkatt ◽  
Jing C. Sang ◽  
S.-B. Xing ◽  
Yan Guo ◽  
I. L. Pegg ◽  
...  
Keyword(s):  
Test Methods ◽  
Waste Form ◽  
Test Duration ◽  
Leach Rate ◽  
Aqueous Environments ◽  
Experimental Parameters ◽  
Sensitive Function ◽  
Nuclear Waste Forms ◽  
Critical Aspects

ABSTRACTMany types of procedures have been developed for testing of the chemical durability of nuclear waste forms. These procedures differ from each other in critical aspects, such as duration, replenishment or non-replenishment of the leachates, and S/V ratio. As a result, different answers to basic questions, such as how waste-form leachability depends on its chemical composition, are obtained when different test methods are used. Furthermore, the possibility that some glasses may exhibit a leach rate excursion within the test period causes the composition dependence to be an even more sensitive function of test duration and of leachant replenishment. These factors also complicate the use of test data for the prediction of long-term waste form behavior.

Natural Analogues: Their Application to the Prediction of the Long-Term Behavior of Nuclear Waste Forms

1986 ◽  
Vol 84 ◽  
Author(s):  
Rodney C. Ewing ◽  
Michael J. Jercinovic
Keyword(s):  
Nuclear Waste ◽  
Borosilicate Glass ◽  
Large Scale ◽  
Laboratory Data ◽  
Waste Form ◽  
Long Time ◽  
Natural Analogues ◽  
Long Term Behavior ◽  
Nuclear Waste Forms

AbstractOne of the unique and scientifically most difficult aspects of nuclear waste isolation is the extrapolation ofshot-term laboratory data (hours to years) to the long time periods (103-105 years) required by regulatory agencies for performance assessment. The direct verification of these extrapolations is not possible, but methods must be developed to demonstrate compliance with government regulations and to satisfy the lay public that there is a demonstrable and reasonable basis for accepting the long-term extrapolations. Natural analogues of both the repository environment (e.g. radionuclide migration at Oklo) and nuclear waste form behavior (e.g. alteration of basaltic glasses and radiation damage in minerals) have been used to demonstrate the long-term behavior of large scale geologic systems and, on a smaller scale, waste form durability. This paper reviews the use of natural analogues to predict the long-term behavior of nuclear waste form glasses. Particular emphasis is placed on the inherent limitations of any conclusions that are based on “proof” by analogy. An example -- corrosion of borosilicate glass -- is discussed in detail with specific attention to the proper and successful use of natural analogues (basaltic glass) in understanding the long-term corrosion behavior of borosilicate glass.

scholarly journals Applying laboratory methods for durability assessment of vitrified material to archaeological samples

2021 ◽  
Vol 5 (1) ◽  
Author(s):  
Lorena Nava-Farias ◽  
James J. Neeway ◽  
Michael J. Schweiger ◽  
José Marcial ◽  
Nathan L. Canfield ◽  
...  
Keyword(s):  
Nuclear Waste ◽  
Iron Age ◽  
Test Methods ◽  
Durability Test ◽  
Laboratory Methods ◽  
Near Surface ◽  
Glass Corrosion ◽  
Durability Assessment ◽  
Nuclear Waste Forms

AbstractLaboratory testing used to assess the long-term chemical durability of nuclear waste forms may not be applicable to disposal because the accelerated conditions may not represent disposal conditions. To address this, we examine the corrosion of vitrified archeological materials excavated from the near surface of a ~1500-year old Iron Age Swedish hillfort, Broborg, as an analog for the disposal of vitrified nuclear waste. We compare characterized site samples with corrosion characteristics generated by standard laboratory durability test methods including the product consistency test (PCT), the vapor hydration test (VHT), and the EPA Method 1313 test. Results show that the surficial layer of the Broborg samples resulting from VHT displays some similarities to the morphology of the surficial layer formed over longer timescales in the environment. This work provides improved understanding of long-term glass corrosion behavior in terms of the thickness, morphology, and chemistry of the surficial features that are formed.

The Long-Term Performance of Nuclear Waste Forms: Natural Materials - Three Case Studies

1992 ◽  
Vol 294 ◽  
Author(s):  
Rodney C. Ewing
Keyword(s):  
Case Studies ◽  
Nuclear Waste ◽  
Experimental Results ◽  
Waste Form ◽  
Short Term ◽  
Waste Forms ◽  
Long Term Performance ◽  
Term Performance ◽  
Nuclear Waste Forms

ABSTRACTNatural materials may be used to advantage in the evaluation of the long-term performance of nuclear waste forms. Three case studies are presented: (I) radiation effects in ceramic waste forms; (II) corrosion products of U02 under oxic conditions; (III) corrosion rate of nuclear waste glasses. For each case, a natural phase which is structurally and chemically analogous to the waste form is identified and used to evaluate the long-term behavior of a nuclear waste form. Short-term experimental results are compared to the observations made of analogous natural phases. The three case studies illustrate that results may range between providing fundamental data needed for the long-term evaluation of a waste form to only providing qualitative data of limited use. Although in the most rigorous view the long-term behaviour of a phase cannot be predicted, the correspondence between short-term experimental results and observations made of natural phases provides confidence in the “predicted” behavior of the waste form. The strength of this approach rests with the degree to which a mechanistic understanding of the phenomenon is attained.

Long-Term Radioactivity Release From Solidified High-Level Waste -Part I: An Approach To Evaluating Experimental Data

1981 ◽  
Vol 11 ◽  
Author(s):  
Friedrich K. Altenhein ◽  
Werner Lutze ◽  
Rodney C. Ewing
Keyword(s):  
Source Term ◽  
Elevated Temperatures ◽  
Relative Sensitivity ◽  
Reaction Rates ◽  
Waste Form ◽  
High Level Waste ◽  
Leach Rate ◽  
Leaching Experiments ◽  
High Level

Safety and risk analyses for the isolation of radioactive waste in a repository must begin with a source term to quantify the amount of radioactivity released from the waste form under a specific set of conditions. The interaction of the waste form with aqueous solutions is the most important mechanism to consider, as any material released may be dissolved and reach the biosphere. In this regard the behaviour of heat generating high-level waste is of particular importance, because reaction rates are higher at elevated temperatures. A long-term leach rate was derived from previous and continuing experimental work. The purpose of this paper is not to describe the “real case” release but rather to provide guidelines for the design of leaching experiments and determine the required precision for the data. This can be derived from the relative sensitivity of extrapolated leach rates for various parameters measured in laboratory experiments.

Ion Implantation Damage in Silicate Glasses

1982 ◽  
Vol 15 ◽  
Author(s):  
George W. Arnold
Keyword(s):  
Ion Implantation ◽  
Nuclear Waste ◽  
Silicate Glasses ◽  
Glass Waste ◽  
Leach Rate ◽  
Implantation Damage ◽  
Waste Forms ◽  
Long Term Behavior ◽  
Nuclear Waste Forms

ABSTRACTIon implantation is a rapid technique for simulating damage induced by α-recoil nuclei in nuclear waste forms. The simulation has been found to be quite good in TEM comparisons with natural α-decay damage in minerals, but leach rate differences have been observed in glass studies and were attributed to dose-rate differences. The similarities between ion implantation and recoil nuclei as a means of producing damage suggest that insights into the long-term behavior of glass waste forms can be obtained by examination of what is known about ion-implantation damage in silicate glasses. This paper briefly reviews these effects and shows that leaching results in certain nuclear waste glasses can be understood as resulting from plastic flow and track overlap. Phase separation is also seen to be a possible consequence of damage-induced compositional changes.

Study of Natural Minerals of U-Ryrochlore-Type Structure as Analogues of Plutonium Ceramic Waste-form

2002 ◽  
Vol 713 ◽  
Author(s):  
Roman V. Bogdanov ◽  
Yuri F. Batrakov ◽  
Elena V. Puchkova ◽  
Andrey S. Sergeev ◽  
Boris E. Burakov
Keyword(s):  
Chemical Shifts ◽  
Pyrochlore Structure ◽  
Type Structure ◽  
Waste Form ◽  
X Ray ◽  
Ceramic Waste ◽  
Natural Minerals ◽  
The Us ◽  
Pyrochlore Type

ABSTRACTAt present, crystalline ceramic based on titanate pyrochlore, (Ca,Gd,Hf,Pu,U)2Ti2O7, is considered as the US candidate waste form for the immobilization of weapons grade plutonium. Naturally occuring U-bearing minerals with pyrochlore-type structure: hatchettolite, betafite, and ellsworthite, were studied in orders to understand long-term radiation damage effects in Pu ceramic waste forms. Chemical shifts (δ) of U(Lδ1)– and U(Lβ1) – X-ray emission lines were measured by X-ray spectrometry. Calculations were performed on the basis of a two-dimensional δLá1- and δLδ1- correlation diagram. It was shown that 100% of uranium in hatchettolite and, probably, 95-100% of uranium in betafite are in the form of (UO2)2+. formal calculation shows that in ellsworthite only 20% of uranium is in the form of U4+ and 80% of the rest is in the forms of U5+ and U6+. The conversion of the initial U4+ ion originally occurring in the pyrochlore structure of natural minerals to (UO2)2+ due to metamict decay causes a significant increase in uranium mobility.

Physical Properties of Saltstone: Physical Properties of Saltstone: A Savannah River Plant Waste Form

1984 ◽  
Vol 44 ◽  
Author(s):  
Christine A. Langton
Keyword(s):  
Compressive Strength ◽  
Physical Properties ◽  
Field Tests ◽  
Waste Form ◽  
Savannah River ◽  
X Ray Diffraction ◽  
Near Surface ◽  
Leach Rate ◽  
Savannah River Plant ◽  
Water To Cement Ratio

AbstractA cement-based waste form, “saltstone,” has been designed for disposal of Savannah River Plant low-level radioactive salt waste. Laboratory and field tests indicate that this stabilization process greatly reduces the mobility of all of the waste constituents in the surface and near-surface environment. Bulk properties of this material have been tailored with respect to salt leach rate, permeability, and compressive strength. Microstructure and mineralogy were characterized by SEM and x-ray diffraction analyses.Compressive strength was found to increase as the water to cement ratio decreased. Porosity and mean pore size increased with increasing water to cement ratios. Bulk diffusivities of the various ions dissolved in the pore solutions were also found to increase as water to cement ratios increased.

Aging Studies of Pu-238 and -239 Containing Calcium Phosphate Ceramic Waste-forms

2013 ◽  
Vol 1518 ◽  
pp. 73-78 ◽  
Author(s):  
Shirley K. Fong ◽  
Brian L. Metcalfe ◽  
Randall D. Scheele ◽  
Denis M. Strachan
Keyword(s):  
Calcium Phosphate ◽  
Accelerated Aging ◽  
Waste Form ◽  
Calcium Phosphate Ceramic ◽  
Ceramic Waste ◽  
Waste Forms ◽  
Aging Studies ◽  
Flow Through ◽  
Pyrochemical Reprocessing

ABSTRACTA calcium phosphate ceramic waste-form has been developed at AWE for the immobilisation of chloride containing wastes arising from the pyrochemical reprocessing of plutonium. In order to determine the long term durability of the waste-form, aging trials have been carried out at PNNL. Ceramics were prepared using Pu-239 and -238, these were characterised by PXRD at regular intervals and Single Pass Flow Through (SPFT) tests after approximately 5 yrs.While XRD indicated some loss of crystallinity in the Pu-238 samples after exposure to 2.8 x 1018 α decays, SPFT tests indicated that accelerated aging had not had a detrimental effect on the durability of Pu-238 samples compared to Pu-239 waste-forms.

scholarly journals Career Satisfaction Based on Trust and Proactive Personality

2020 ◽  
Vol 9 (1) ◽  
pp. 35-45
Author(s):  
Iwan Sunardi ◽  
Vini Wiratno Putri
Keyword(s):  
Career Satisfaction ◽  
Analytical Data ◽  
Sampling Technique ◽  
Test Methods ◽  
Validity And Reliability ◽  
Career Needs ◽  
Relationship Of ◽  
The Relationship ◽  
The City

The purpose of this study was to examine the effect of the trust of co-workers and proactive personalities on career satisfaction by exchanging leader-members as mediation on employees of bus assembly companies in the city of Semarang. Career satisfaction is the phase in which employees’ long-term career needs are aligned with what they get while working. Employees will always look for opportunities and trust in the organization and people who will help them in achieving career satisfaction. The sampling method uses a purposive sampling technique in the category of staff and foreman employees who have worked for more than five years with a sample of 160 employees. The analytical data in this study uses descriptive statistical test methods, instinctual tests include validity and reliability, and hypothesis testing. The tool used to test in this study uses SmartPLS 3.0. The results of this study, colleague trust cannot directly influence career satisfaction. However, it can be mediated by the exchange of leader members and produce significant influence. For further researchers, they can re-examine the relationship of coworkers’ trust with career satisfaction. And can expand the object of research or respondents under study.

Sign in / Sign up

Export Citation Format

Share Document